Water and/or Wastewater Sample Clauses

Water and/or Wastewater i. As-built drawings shall show location of mains, blowoffs, manholes, reducers, tees, any field changes, change orders, etc. ii. All valves and blowoffs shall be located by measurements taken from two separate, easily identifiable, stationary points. These points shall not include P.I., P.C. (as these acronyms are given their usual meaning in surveying parlance), or other similar, minute, not easily found points of reference. Property pins may be used if no other reference point is available. All measurements should be taken from manholes, power poles, electric vaults, telephone pedestals, buildings, etc. Reference points should not include trees, shrubs, or other living organisms or other objects, which are subject to change in size or shape. Any deviation from this concept will result in rejection of as-built drawings unless a variance has been obtained, in writing, from the District. GPS coordinates to submeter accuracy may be submitted for each item instead of measurements. iii. If a main is dead ended, there should be a blow-off with its location shown by measurement from easily identifiable points. iv. The District will not accept as-built maps showing complete and incomplete portions of the Development on the same sheet unless the incomplete portions are labeled as such and a separate as-built is submitted at the time that portion is completed. v. Lot numbers and block letters must be shown. * Note: Road names are not to be recorded as Road A, Road B, etc. As built drawings are to be submitted no later than 15 days from the date of acceptance of the construction letter.