Xxxxxx’s Rules. Unless otherwise provided by applicable law or these Bylaws, all rules of order not herein provided for will be determined in accordance with Xxxxxx’s Rules of Order Newly Revised.
Xxxxxx’s Rules Sample Clauses
Related to Xxxxxx’s Rules
Safety Rules 5.01 The safety rules of the State having jurisdiction shall be observed by the parties hereto. It is recognized that the Employer has the exclusive responsibility for providing a safe and healthful workplace. To assist the Employer in maintaining an effective and continuing safety program, a permanent Joint Safety Committee shall be established, consisting of two (2) members from the Union and two (2) members from the Employers, who shall meet at regular times to administer educational instructions, investigate serious accidents, and to draft appropriate safety rules. Such rules as adopted by this committee, shall become a part of this Agreement.
Business Rules The response interval starts when the CLEC’s Mechanized Loop Makeup Service Inquiry (LMUSI) is submitted electronically through the Operational Support Systems interface, LENS, TAG or RoboTAG. It ends when BellSouth’s Loop Facility Assignment and Control System (LFACS) responds electronically to the CLEC with the requested Loop Makeup data via LENS, TAG or RoboTAG Interfaces. Note: The Loop Make Up Service Inquiry Form does not require the CLEC to furnish the type of Loop. The CLEC determines whether the loop makeup will support the type of service they wish to order or not and qualifies the loop. If the loop makeup will sup- port the service, a firm order LSR is submitted by the CLEC. EDI is not a pre-ordering system, and, therefore, is not applicable in this measure. Calculation Response Interval = (a - b) • a = Date and Time the LMUSI returned to CLEC • b = Date and Time the LMUSI is received Average Interval = (c ÷ d) • c = Sum of all response intervals • d = Total Number of LMUSIs received within the reporting period Percent within interval = (e ÷ f) X 100 • e = Total LMUSIs received within the interval • f = Total Number of LMUSIs processed within the reporting period Report Structure • CLEC Aggregate • CLEC Specific • Geographic Scope - State - Region • Interval for electronic LMUs: 0 – < 1 minute >1 – < 5 minutes 0 - ≤ 5 minutes > 5 – < 8 minutes > 8 – < 15 minutes > 15 minutes • Average Interval in minutes PO-2: Loop Make Up - Response Time - Electronic Data Retained Relating to CLEC Experience Relating to BellSouth Performance • Report Month • Legacy Contract • Response Interval • Regional Scope • Not Applicable SQM Disaggregation - Analog/Benchmark SQM Level of Disaggregation SQM Analog/Benchmark • Loop Benchmark • 95% ≤ 1 Minute SEEM Measure SEEM Measure Yes Tier I Tier II X SEEM Disaggregation - Analog/Benchmark SEEM Disaggregation SEEM Analog/Benchmark • Loop • 95% ≤ 1 Minute O-1: Acknowledgement Message Timeliness
Export Rules You agree that the Software will not be shipped, transferred or exported into any country or used in any manner prohibited by the United States Export Administration Act or any other export laws, restrictions or regulations (collectively the "Export Laws"). In addition, if the Software is identified as an export controlled item under the Export Laws, you represent and warrant that you are not a citizen of, or located within, an embargoed or otherwise restricted nation (including without limitation Iran, Syria, Sudan, Libya, Cuba and North Korea) and that you are not otherwise prohibited under the Export Laws from receiving the Software. All rights to use the Software are granted on condition that such rights are forfeited if you fail to comply with the terms of this agreement.
Xxxxx-Xxxxx Act Xxxxx-Xxxxx Act, as amended (40 U.S.C. 3141-3148). When required by Federal program legislation, all prime construction contracts in excess of $2,000 awarded by non-Federal entities must include a provision for compliance with the Xxxxx-Xxxxx Act (40 U.S.C. 3141-3144, and 3146-3148) as supplemented by Department of Labor regulations (29 CFR Part 5, “Labor Standards Provisions Applicable to Contracts Covering Federally Financed and Assisted Construction”). In accordance with the statute, contractors must be required to pay wages to laborers and mechanics at a rate not less than the prevailing wages specified in a wage determination made by the Secretary of Labor. In addition, contractors must be required to pay wages not less than once a week. The non-Federal entity must place a copy of the current prevailing wage determination issued by the Department of Labor in each solicitation. The decision to award a contract or subcontract must be conditioned upon the acceptance of the wage determination. The non-Federal entity must report all suspected or reported violations to the Federal awarding agency. The contracts must also include a provision for compliance with the Xxxxxxxx “Anti-Kickback” Act (40 U.S.C. 3145), as supplemented by Department of Labor regulations (29 CFR Part 3, “Contractors and Subcontractors on Public Building or Public Work Financed in Whole or in Part by Loans or Grants from the United States”). The Act provides that each contractor or Subrecipient must be prohibited from inducing, by any means, any person employed in the construction, completion, or repair of public work, to give up any part of the compensation to which he or she is otherwise entitled. The non-Federal entity must report all suspected or reported violations to the Federal awarding agency.
Xxxxx-Xxxxx Act compliance IF proposing on PART 2, Texas Statute requires compliance with Xxxxx-Xxxxx Act, as amended (40 U.S.C. 3141- 3148). When required by Federal program legislation, all prime construction contracts in excess of $2,000 awarded by non-Federal entities must include a provision for compliance with the Xxxxx-Xxxxx Act (40 U.S.C. 3141-3144, and 3146-3148) as supplemented by Department of Labor regulations (29 CFR Part S, "Labor Standards Provisions Applicable to Contracts Covering Federally Financed and Assisted Construction"). In accordance with the statute, contractors must be required to pay wages to laborers and mechanics at a rate not less than the prevailing wages specified in a wage determination made by the Secretary of Labor. In addition, contractors must be required to pay wages not less than once a week. The non-Federal entity must place a copy of the current prevailing wage determination issued by the Department of Labor in each solicitation. The decision to award a contract or subcontract must be conditioned upon the acceptance of the wage determination. The non-Federal entity must report all suspected or reported violations to the Federal awarding agency. The contracts must also include a provision for compliance with the Xxxxxxxx "Anti-Kickback" Act {40 U.S.C. 314S), as supplemented by Department of Labor regulations (29 CFR Part 3, "Contractors and Subcontractors on Public Building or Public Work Financed in Whole or in Part by Loans or Grants from the United States"). The Act provides that each contractor or subrecipient must be prohibited from inducing, by any means, any person employed in the construction, completion, or repair of public work, to give up any part of the compensation to which he or she is otherwise entitled. The non-Federal entity must report all suspected or reported violations to the Federal awarding agency. BY SUBMITTING A PROPOSAL FOR PART 2 OF THIS SOLICITATION, the Vendor agrees, AS REQUIRED BY LAW, to comply with the Xxxxx Xxxxx Act, IF APPLICABLE and if proposing on PART 2 of this solicitation.
Health and Safety Standards Contractor shall abide by all health and safety standards set forth by the State of California and/or the County of Xxxxxx pursuant to the Injury and Illness Prevention Program. If applicable, Contractor must receive all health and safety information and training from County.
CONTRACT WORK HOURS AND SAFETY STANDARDS As per the Contract Work Hours and Safety Standards Act (40 U.S.C. 3701-3708), where applicable, all Customer Purchase Orders in excess of ,000 that involve the employment of mechanics or laborers must include a provision for compliance with 40 U.S.C. 3702 and 3704, as supplemented by Department of Labor regulations (29 CFR Part 5). Under 40 U.S.C. 3702 of the Act, each contractor must be required to compute the wages of every mechanic and laborer on the basis of a standard work week of 40 hours. Work in excess of the standard work week is permissible provided that the worker is compensated at a rate of not less than one and a half times the basic rate of pay for all hours worked in excess of 40 hours in the work week. The requirements of 40 U.S.C. 3704 are applicable to construction work and provide that no laborer or mechanic must be required to work in surroundings or under working conditions which are unsanitary, hazardous or dangerous. These requirements do not apply to the purchases of supplies or materials or articles ordinarily available on the open market, or contracts for transportation or transmission of intelligence.
Contract Work Hours and Safety Standards Act The following clauses apply to any Federal-aid construction contract in an amount in excess of $100,000 and subject to the overtime provisions of the Contract Work Hours and Safety Standards Act. These clauses shall be inserted in addition to the clauses required by 29 CFR 5.5(a) or 29 CFR 4.6. As used in this paragraph, the terms laborers and mechanics include watchmen and guards.
Laws, Rules and Regulations You agree to comply with all existing and future operating procedures used by the Bank for processing of transactions. You further agree to comply with, and be bound by, all applicable state or federal laws, rules, regulations, orders, guidelines, operating circulars and pronouncements, affecting checks and drafts, including, but not limited to, all rules and procedural guidelines established by the Board of Governors of the Federal Reserve and the Electronic Check Clearing House Organization ("ECCHO") and any other clearinghouse or other organization in which Bank is a member or to which rules Bank has agreed to be bound. These procedures, rules, and regulations (collectively the "Rules") and laws are incorporated herein by reference. In the event of conflict between the terms of this Agreement and the Rules, the Rules will control.
Safety Standards Performance of the Contract for all commodities or contractual services must comply with requirements of the Occupational Safety and Health Act and other applicable State of Florida and federal requirements.
