Cold Test definition

Cold Test means the no load test as per Technical Specification.
Sample 1Sample 2Sample 3

Examples of Cold Test in a sentence

  • Subcontractor may be required to make periodic visits to Hanford Site locations (i.e., 2440 Stevens Center, HAMMER, Cold Test Facility [CTF], 200 East/West Area, 600 Area, 222-S Laboratory, Effluent Treatment Facility [ETF], etc.).

  • Accordingly, ACIN covenants and agrees not to assert a lost coal claim for: (1) any area in which mining has been restricted under the Existing Agreement, (2) any area that could not be accessed because of the restrictions imposed under the Existing Agreement, (3) any area in which mining has been restricted under Paragraph 4 above or (4) any area that cannot be accessed because of the restrictions imposed under Paragraph 4.

  • The CEA Saclay Cold Test Facility kept a sustained pace, the result of constant improvements which reduced the testing times well below 20 days per coil.

  • CE/EMI/EMC ComplianceIn addition to compliance to STQC guidelines applicable at the time of Contract Agreement, following mandatory compliance requirements are as under:For PoS Terminals:Dry heat test- Operating (50 ±2˚C for 2 hrs) Cold test – Operating (0 ±3˚C for 2 hrs)Dry heat test (55 ±2˚C for 2 hrs)Damp heat Cyclic (40˚C for (12+12 hrs)),No. of cycles : 2 Cold Test (-10 ±3˚C for 2 hrs)Drop/Free Fall Test, in unpacked, switched off and normal handling conditions (Height : 100mm, Total no.

  • Cold Test stands have sensors, gauges and transducers that are calibrated and maintained via the calibration process.

  • Meanwhile the Pre-Assembly team was able to match the Cold Test Facility feats by producing in the same time interval a fully preassembled, carefully measured and nicely packed coil.

  • Cold Test : in accordance with IS:9000 (Part 2/Sec.4)1977 (Reaffirmed 2007) at -10 degreeC for 4 hrs.

  • A, dated 06/17/ 2014- Danfoss - Vibration Test Report for P7020 LHD120 No. 00720571, dated 07/08/2015- UL India Lab - Cold Test Report for LHD-120 No. 4786962025-S1-1, dated 07/09/2015- Danfoss - Cold Test Report for P7020 LHD120 No. 00726256, dated 07/10/2015- Elite - EMC Tests on LHD120 Drive System No. 1401200-01 Rev.

  • Abdel Maksoud, Completion of the JT-60 SA Toroidal Field coils tests in the Cold Test Facility.

  • It is expected that Subcontractor personnel will be primarily be located in an office in the 200 Areas or other locations in support of WRPS work (i.e., 2425 Stevens Center, HAMMER, Cold Test Facility, 600 Area, 222-S Laboratory, etc.) Work schedules and facility operations are not consistent on the Hanford Site.

Related to Cold Test

  • DNS test Means one non-­‐recursive DNS query sent to a particular “IP address” (via UDP or TCP). If DNSSEC is offered in the queried DNS zone, for a query to be considered answered, the signatures must be positively verified against a corresponding DS record published in the parent zone or, if the parent is not signed, against a statically configured Trust Anchor. The answer to the query must contain the corresponding information from the Registry System, otherwise the query will be considered unanswered. A query with a “DNS resolution RTT” 5 times higher than the corresponding SLR, will be considered unanswered. The possible results to a DNS test are: a number in milliseconds corresponding to the “DNS resolution RTT” or, undefined/unanswered.

  • RDDS test Means one query sent to a particular “IP address” of one of the servers of one of the RDDS services. Queries shall be about existing objects in the Registry System and the responses must contain the corresponding information otherwise the query will be considered unanswered. Queries with an RTT 5 times higher than the corresponding SLR will be considered as unanswered. The possible results to an RDDS test are: a number in milliseconds corresponding to the RTT or undefined/unanswered.

  • COVID-19 test means a viral test for SARS-CoV-2 that is:

  • Start-Up Testing means the completion of applicable required factory and start-up tests as set forth in Exhibit C.

  • Penetration Testing means security testing in which assessors mimic real-world attacks to identify methods for circumventing the security features of an application, system, or network. (NIST SP 800-115)

  • EPP test Means one EPP command sent to a particular “IP address” for one of the EPP servers. Query and transform commands, with the exception of “create”, shall be about existing objects in the Registry System. The response shall include appropriate data from the Registry System. The possible results to an EPP test are: a number in milliseconds corresponding to the “EPP command RTT” or undefined/unanswered.

  • Commissioning test means tests applied to a distributed generation facility by the applicant after construction is completed to verify that the facility does not create adverse system impacts and performs to the submitted specifications. At a minimum, the scope of the commissioning tests performed shall include the commissioning test specified in Institute of Electrical and Electronics Engineers, Inc. (IEEE) Standard 1547 Section 5.4 "Commissioning tests".

  • Drug use test means a scientifically substantiated method to test for the presence of illegal or performance-enhancing drugs or the metabolites thereof in a person’s urine.

  • Drug test means a test designed to detect the illegal use of a controlled substance.

  • Fit test means the use of a protocol to qualitatively or quantitatively evaluate the fit of a respirator on an individual.

  • Percolation test means a subsurface soil test at the depth of a proposed absorption system or similar component of an OWTS to determine the water absorption capability of the soil, the results of which are normally expressed as the rate at which one inch of water is absorbed. The rate is expressed in minutes per inch.

  • Maintenance Test means the maintenance test set out in Clause 12.1 (Maintenance Test).

  • Screening Test means a drug or alcohol test which uses a method of analysis allowed by the Minnesota Drug and Alcohol Testing in the Workplace Act to be used for such purposes.

  • Cold Weather Alert means the notice that PJM provides to PJM Members, Transmission Owners, resource owners and operators, customers, and regulators to prepare personnel and facilities for expected extreme cold weather conditions.

  • Performance Test means all operational checks and tests required to determine the performance parameters including inter-alia capacity, efficiency and operating characteristics of the Stores as specified in the Contract.

  • Test means such test as is prescribed by the particulars or considered necessary by the Inspecting Officer whether performed or made by the Inspecting Officer or any agency acting under the direction of the Inspecting Officer;

  • Commissioning Tests means all of the procedures and tests which, in accordance with the Reasonable and Prudent Standard, and in compliance with industry guidelines, practices and standards, are:

  • Cannabis testing facility means an entity registered by

  • Operational Acceptance Tests means the tests specified in the Technical Requirements and Agreed Project Plan to be carried out to ascertain whether the System, or a specified Sub system, is able to attain the functional and performance requirements specified in the Technical Requirements and Agreed Project Plan, in accordance with the provisions of GCC Clause 27.2 (Operational Acceptance Test).

  • Stand-Alone Test Environment or "SATE" shall have the meaning set forth in Section 12.2.9.3.2.

  • Internal test assessment means, but is not limited to, conducting those tests of quality assurance necessary to ensure the integrity of the test.

  • Covenant Testing Period means a period (a) commencing on the last day of the fiscal month of Parent most recently ended prior to a Covenant Trigger Event for which Borrowers are required to deliver to Agent monthly financial statements pursuant to Schedule 5.1 to this Agreement, and (b) continuing through and including the first day after such Covenant Trigger Event that Availability has equaled or exceeded the greater of (a) 15% of the Maximum Revolver Amount, and (b) $4,500,000 for 60 consecutive days.

  • S&P CDO Monitor Test A test that will be satisfied on any date of determination (following receipt, at any time on or after the S&P CDO Monitor Election Date, by the Issuer and the Collateral Administrator of the Class Break-even Default Rates for each S&P CDO Monitor input file (in accordance with the definition of “Class Break-even Default Rate”)) if, after giving effect to a proposed sale or purchase of an additional Collateral Obligation, the Class Default Differential of the Highest Ranking Class of the Proposed Portfolio is positive. The S&P CDO Monitor Test will be considered to be improved if the Class Default Differential of the Proposed Portfolio that is not positive is greater than the corresponding Class Default Differential of the Current Portfolio.

  • Acceptance Testing mean the tests, reviews and other activities that are performed by or on behalf of Agency to determine whether the Deliverables meet the Acceptance Criteria or otherwise satisfy the Agency, as determined by the Agency in its sole discretion.

  • Performance Tests means the tests to be conducted on the equipment at site for checking the performance parameters of the equipment as defined in Technical Specification.

  • Plant Test Date or "PTD" means the date acceptance testing is performed with CLEC. "Point of Interface", "Point of Interconnection," or "POI" is a demarcation between the networks of two (2) LECs (including a LEC and CLEC). The POI is that point where the exchange of traffic takes place.