Generally applicable environmental radiation standards means standards issued by the U.S. Environmental Protection Agency (EPA) under the authority of the Atomic Energy Act of 1954, as amended, that impose limits on radiation exposures or levels, or concentrations or quantities of radioactive material, in the general environment outside the boundaries of locations under the control of persons possessing or using radioactive material.
Applicable Standards means the requirements and guidelines of NERC, the Applicable Regional Entity, and the Control Area in which the Customer Facility is electrically located; the PJM Manuals; and Applicable Technical Requirements and Standards.
Applicable water quality standards means all water quality standards to which a discharge is subject under the federal Clean Water Act and which has been (a) approved or permitted to remain in effect by the Administrator following submission to the Administrator pursuant to Section 303(a) of the Act, or (b) promulgated by the Director pursuant to Section 303(b) or 303(c) of the Act, and standards promulgated under (APCEC) Regulation No. 2, as amended.
Applicable Technical Requirements and Standards means those certain technical requirements and standards applicable to interconnections of generation and/or transmission facilities with the facilities of an Interconnected Transmission Owner or, as the case may be and to the extent applicable, of an Electric Distributor, as published by Transmission Provider in a PJM Manual provided, however, that, with respect to any generation facilities with maximum generating capacity of 2 MW or less (synchronous) or 5 MW or less (inverter-based) for which the Interconnection Customer executes a Construction Service Agreement or Interconnection Service Agreement on or after March 19, 2005, “Applicable Technical Requirements and Standards” shall refer to the “PJM Small Generator Interconnection Applicable Technical Requirements and Standards.” All Applicable Technical Requirements and Standards shall be publicly available through postings on Transmission Provider’s internet website.
Applicable effluent standards and limitations means all State and Federal effluent standards and limitations to which a discharge is subject under the Act, including, but not limited to, effluent limitations, standards of performance, toxic effluent standards and prohibitions, and pretreatment standards.
Pretreatment standards means all applicable Federal rules and regulations implementing Section 307 of the Act, as well as any nonconflicting State or local standards. In cases of conflicting standards or regulations, the more stringent thereof shall be applied.
National Ambient Air Quality Standards or “NAAQS” means national ambient air quality standards that are promulgated pursuant to Section 109 of the Act, 42 U.S.C. § 7409.
Availability Standards has the meaning set forth in the CAISO Tariff.
Reliability Standards means the criteria, standards, rules and requirements relating to reliability established by a Standards Authority.
Accessibility Standards means accessibility standards and specifications for Texas agency and institution of higher education websites and EIR set forth in 1 TAC Chapter 206 and/or Chapter 213.
Good Industry Practices means the practices that would be adopted by, and the exercise of that degree of care, skill, diligence, prudence and foresight that reasonably would be expected from, a competent contractor in the international oil and gas industry experienced in performing work similar in nature, size, scope and complexity to the Work and under conditions comparable to those applicable to the Work, where such work is subject to, and such contractor is seeking to comply with, the standards and codes specified in the Contract or (to the extent that they are not so specified) such national or international standards and codes as are most applicable in the circumstances, and the applicable Law.
National Standards means the document entitled “National Standards for the Volatile Organic Compound Content of Canadian Commercial/Industrial Surface Coating Products Automotive Refinishing, October 1998, PN 1288" and published by the Canadian Council of Ministers of the Environment;
Water quality standards means provisions of state or federal law which consist of a designated use or uses for the waters of the Commonwealth and water quality criteria for such waters based upon such uses. Water quality standards are to protect the public health or welfare, enhance the quality of water and serve the purposes of the State Water Control Law (§ 62.1-44.2 et seq. of the Code of Virginia) and the federal Clean Water Act (33 USC § 1251 et seq.).
State minimum standards means minimum requirements
Good Laboratory Practices or “GLP” means the then-current good laboratory practice standards promulgated or endorsed by the FDA, as defined in U.S. 21 C.F.R. Part 58 (or such other comparable regulatory standards in jurisdictions outside the United States, as they may be updated from time to time).
Clean air standards, as used in this clause means:
Good Industry Practice means standards, practices, methods and procedures conforming to the Law and the degree of skill and care, diligence, prudence and foresight which would reasonably and ordinarily be expected from a skilled and experienced person or body engaged in a similar type of undertaking under the same or similar circumstances.
Locational Deliverability Area Reliability Requirement means the projected internal capacity in the Locational Deliverability Area plus the Capacity Emergency Transfer Objective for the Delivery Year, as determined by the Office of the Interconnection in connection with preparation of the Regional Transmission Expansion Plan, less the minimum internal resources required for all FRR Entities in such Locational Deliverability Area.
Technical Standards means the technical standards set out in paragraph 2.5 of the Order Form;
Web Site Accessibility Standards/Specifications means standards contained in Title 1 Texas Administrative Code Chapter 206.