Invert Elevation definition

Invert Elevation means the elevation of the inside bottom of the pipe.
Sample 1Sample 2Sample 3

Examples of Invert Elevation in a sentence

  • Invert Elevation means the elevation of the inside bottom of pipe.

  • Invert Elevation - The invert elevation of the inlet of a grease trap shall be at least 2 inches above the invert elevation of the outlet.

  • Manhole Invert Elevation: Plus or minus 0.04 feet from required elevation.

  • SD 5.11 Invert Elevation - The invert elevation of the inlet of a grease trap shall be at least 2 inches above the invert elevation of the outlet.

  • The attribute data for manhole, drop inlets, catch basins, and outfalls are to include, at a minimum: Shape, Base Diameter, Type, Depth, Manhole Ring/Cover Elevation, and Invert Elevation of Inlet/Outlet Pipes.

  • Salamsi and J.P. Abraham, Determination of Stilling Basin Invert Elevation and its Effect on Controlling Hydraulic Jumps, Chapter 5, Techniques and Innovation in Engineering Research, Vol.

  • Location, Size, and Invert Elevation of any existing sanitary or storm sewers, culverts, and drain pipes, the location of manholes, catch basins, hydrants, power and telephone poles, and the location and size of any existing water and gas mains within the exterior boundaries of the plat or immediately adjacent thereto.

  • Pump Section: Diameter of Delivery Pipe Length of Delivery Pipe Friction Loss in Delivery Pipe, H, ft Elevation of Dosing Tank Low Water Level Elevation of Lateral Invert Elevation Head, H, ft Total Operating Head, H ( H + H + H), ft Pump Model Rate Horsepower Pump Discharge Rate at Total Operating Head, gym 5b.

  • Salamsi and J.P. Abraham, Determination of Stilling Basin Invert Elevation and its Effect on Controlling Hydraulic Jumps, Technological Innovation In Engineering Research, (in press).

  • Table 7-5Orifice Attributes for Modeling Software Orifice AttributeDescriptionOrifice typeSelect type of orifice: 1) Side , 2) BottomOrifice ShapeSelect shape of orifice: 1) Circular, 2) Rectangular (RECT_CLOSED) Invert Elevation Invert of the bottom of the orifice HeightHeight of orifice (diameter for circular orifice)WidthWidth of orifice (zero for circular orifice) Orifice AttributeDescriptionDischarge coefficientThe coefficient for the orifice flow equation.

Related to Invert Elevation

  • Water surface elevation means the height, in relation to the National Geodetic Vertical Datum (NGVD) of 1929, the North American Vertical Datum (NAVD) of 1988, or other datum, where specified, of floods of various magnitudes and frequencies in the floodplains of riverine areas.

  • Base flood elevation (BFE) means the elevation shown on the Flood Insurance Rate Map for Zones AE, AH, A1-30, VE and V1-V30 that indicates the water surface elevation resulting from a flood that has a 1-percent or greater chance of being equaled or exceeded in any given year.

  • Base Flood Elevation (BFE means a determination of the water surface elevations of the base flood as published in the Flood Insurance Study. When the BFE has not been provided in a “Special Flood Hazard Area”, it may be obtained from engineering studies available from a Federal, State, or other source using FEMA approved engineering methodologies. This elevation, when combined with the “Freeboard”, establishes the “Regulatory Flood Protection Elevation”.

  • Uppermost aquifer means the geologic formation nearest the natural ground surface that is an aquifer, as well as lower aquifers that are hydraulically interconnected with this aquifer within the facility's property boundary.

  • Flood Elevation Study means an examination, evaluation and determination of flood hazards and, if appropriate, corresponding water surface elevations, or an examination, evaluation and determination of mudslide (i.e., mudflow) or flood-related erosion hazards.

  • Impact surface means an interior or exterior surface that is subject to damage by repeated sudden force such as certain parts of door frames.

  • Acre-foot – means the amount of water necessary to cover one acre of land one foot deep, or 325,851 gallons of water.

  • Rate Center Area means the following in each applicable area:

  • Built-Up Area and/or “Covered Area” in relation to a Flat shall mean the floor area of that Flat including the area of balconies and terraces, if any attached thereto, and also the thickness of the walls (external or internal) and the columns and pillars therein Provided That if any wall, column or pillar be common between two Flats, then one-half of the area under such wall column or pillar shall be included in the built-up area of each such Flat.

  • Residential Floor Area means all of the square footage of living area within the perimeter of a residential structure, not including any carport, walkway, garage, overhang, patio, enclosed patio, or similar area. The determination of Residential Floor Area shall be made by reference to the building permit(s) issued for such Assessor’s Parcel.

  • Building Energy Benchmarking means the process of measuring a building’s Energy use, tracking that use over time, and comparing performance to similar buildings.

  • Conversion building means a building that at any time before creation of the common interest community was occupied wholly or partially by persons other than purchasers and persons who occupy with the consent of purchasers.

  • Building Drain means that part of the lowest horizontal piping of a drainage system which receives the discharge from soil, waste, and other drainage pipes inside the walls of the building and conveys it to the building sewer, beginning five (5) feet (1.5 meters) outside the inner face of the building wall.

  • Basement means any area of the building having its floor subgrade (below ground level) on all sides.