Opacity Limit definition

Opacity Limit means the maximum opacity level set forth in Paragraphs 14, 16, 17, 19 and 20 that is applicable within the Not to Exceed Control Area specified in Section 2 of Appendix C.
Sample 1Sample 2Sample 3
Opacity Limit means the maximum opacity level set forth in Paragraphs 14, 16, 17, 19 and 20
Sample 1

Examples of Opacity Limit in a sentence

  • Opacity Limit is less than 96.5% at such combustion stack in any Quarter during the term of the Consent Decree, in the next Quarter AMM shall (beginning no later than ten days after the end of the previous Quarter) conduct an investigation, in accordance with the requirements of this Paragraph, whenever the opacity of emissions from the combustion stack (as measured by the COMS) equals or exceeds (i) 20% for a period or periods aggregating more than two minutes in any one hour or (ii) 50% at any time.

  • The tide of the pass- ing star will deliver a velocity impulse to one component of the binary, relative to the other, given by the product of the tidal ac- celeration and the duration of the interaction,sumed to determine the minimum mass for star formation – namely (i) Primary Fragmentation and the Opacity Limit; (ii) Secondary Fragmentation during H2 dissociation – and the con- sequences these thermodynamic processes have for the statistics of binary systems containing brown dwarfs.

  • Paragraph, whenever the opacity of emissions from the combustion stack (as measured by visual observation in accordance with Method 9) exceeds the Combustion Stack Opacity Limit.

  • Paragraph, whenever the opacity of emissions from the combustion stack (as measured by the COMS) exceeds the Combustion Stack Opacity Limit.

  • Basis for Opacity Limit - Enter, from the list below, the code which corresponds to the basis for the visible emissions limitations addressed in this set of Fields 1-5.

  • This section makes the map modernization program ongoing; requires the mapping of the 500-year floodplain (but such 500-year mapping may not delay the mapping of acommunity’s 100-year floodplain map); gives priority in updating maps to areas affected by hurricanes Katrina and Rita, creates a responsibility for FEMA to educate communities about map updates; establishes the trigger for pre-FIRM subsidy phase out of second and vacation homes as January 1, 2011.

  • Applicable Regulation, Emission Limit, and Monitoring Requirements: Regulation: 567 IAC 23.3 (2) "a"DNR Construction Permits 96-A-093-S4, 96-A-093-S5 Pollutant: PMRRl0 RR& PM Emission Limit: 0.66 lb/hr PMRR10RR; 0.1 gr/dscf, 0.66 lb/hr PM Opacity Limit: 40%UUC.

  • Opacity Limit - Complete as follows: Normal Conditions ‑ Enter the maximum opacity, to the nearest whole percent, that the emissions unit would be allowed during normal operating conditions as a specific condition of its permit.

  • Opacity Limit: Normal Conditions: % Exceptional Conditions: % Maximum Period of Excess Opacity Allowed: min/hour 4.

  • Usage logs are kept as paint is checked out for each individual job and monthly recordkeeping was deemed sufficient.GP 002PM Limit ≤ 0.40 lbs/MMBtu SO2 Limit ≤ 2.0 lbs/MMBtu Opacity Limit ≤ 20%(Minn.

Related to Opacity Limit

  • Facility Limit means, $175,000,000, as reduced or increased from time to time pursuant to the terms hereof. References to the unused portion of the Facility Limit shall mean, at any time of determination, an amount equal to (x) the Facility Limit at such time, minus (y) the Aggregate Capital at such time.

  • Maximum Daily Limit means the maximum allowable "Daily Concentration" (defined above) when expressed as a concentration (e.g. mg/l), otherwise, it means the maximum allowable "Daily Quantity" as defined above, unless it is expressed as a flow quantity. If expressed as a flow quantity it means "Maximum Daily Flow" as defined in Section 22a-430-3(a) of the RCSA.

  • Capacity Utilization Factor or “CUF” shall have the same meaning as provided in CERC (Terms and Conditions for Tariff determination from Renewable Energy Sources) Regulations, 2009 as amended from time to time; However, for avoidance of any doubt, it is clarified that the CUF shall be calculated on the Contracted Capacity; In any Contract Year, if ‘X’ MWh of energy has been metered out at the Delivery Point for ‘Y’ MW Project capacity, CUF= (X MWh/(Y MW*8766)) X100%; Declared CUF for this Project shall be % (to be revised as applicable).

  • Exceedance means a condition that is detected by monitoring that provides data in terms of an emission limitation or standard and that indicates that emissions (or opacity) are greater than the applicable emission limitation or standard (or less than the applicable standard in the case of a percent reduction requirement) consistent with any averaging period specified for averaging the results of the monitoring.

  • Total maximum daily load or "TMDL" means the sum of the individual wasteload allocations for point sources, load allocations (LAs) for nonpoint sources, natural background loading and a margin of safety. TMDLs can be expressed in terms of either mass per time, toxicity, or other appropriate measure. The TMDL process provides for point versus nonpoint source trade-offs.

  • Maximum Limit means that number of issued Shares representing 10% of the total number of issued Shares as at the date of the passing of this Resolution (excluding any Shares which are held as treasury shares as at that date); and

  • Maximum Facility Output means the maximum (not nominal) net electrical power output in megawatts, specified in the Interconnection Service Agreement, after supply of any parasitic or host facility loads, that a Generation Interconnection Customer’s Customer Facility is expected to produce, provided that the specified Maximum Facility Output shall not exceed the output of the proposed Customer Facility that Transmission Provider utilized in the System Impact Study.

  • Normal Maximum Generation means the highest output level of a generating resource under normal operating conditions.

  • Normal Minimum Generation means the lowest output level of a generating resource under normal operating conditions.

  • low voltage means the set of nominal voltage levels that are used for the distribution of electricity and whose upper limit is generally accepted to be an a.c. voltage of 1000V ( or a d.c. voltage of 1500 V). [SANS 1019]

  • Maximum allowable cost list means a list of drugs for

  • Life-cycle cost means the expected total cost of ownership during the life of a product, including disposal costs.