Further displays shall have navigation built-in covering Page forward, Page backward, Page up, Page down facilities indicating the corresponding names of the displays for navigation.
Multiple tomogram system means a computed tomography X-ray system which obtains X-ray transmission data simultaneously during a single scan to produce more than one tomogram.
IVR means Interactive Voice Response.
SPID is the number that identifies a service provider to the relevant NPAC. The SPID may be a state-specific number. "Serving Wire Center" denotes the CenturyLink building from which dial tone for local Exchange Service would normally be provided to a particular End User Customer premises. "Signaling System 7" or "SS7" is an out-of-band signaling protocol consisting of four basic sub- protocols:
Basic Comprehensive User Guide means the Ministry document titled Basic Comprehensive Certificates of Approval (Air) User Guide” dated April 2004 as amended.
Continuous emissions monitoring system (CEMS means all of the equipment that may be required to meet the data acquisition and availability requirements of this section, to sample, condition (if applicable), analyze, and provide a record of emissions on a continuous basis.
Network Upgrades means modifications or additions to transmission-related facilities that are integrated with and support the Transmission Provider’s overall Transmission System for the general benefit of all users of such Transmission System. Network Upgrades shall include:
Continuous emission monitoring system or "CEMS" means the equipment required under section 11 of this rule to sample, analyze, measure, and provide, by means of readings recorded at least once every fifteen (15) minutes, using an automated data acquisition and handling system (DAHS), a permanent record of nitrogen oxides emissions, stack gas volumetric flow rate, stack gas moisture content, and oxygen or carbon dioxide concentration, as applicable, in a manner consistent with 40 CFR 75*. The following systems are the principal types of continuous emission monitoring systems required under section 11 of this rule:
Packet Switch is a router designed to read the destination address in an incoming cell or packet, consult a routing table and route the packet toward its destination. Packetizing is done in originating CPE and reassembly is done in terminating CPE. Multiple packet formats or protocols exist (e.g., x.25, x.75, frame relay, ATM, and IP).
CLEC means a competitive local exchange carrier.
Switched Access Detail Usage Data means a category 1101xx record as defined in the EMI iconectiv Practice BR 010-200-010.
Continuous emissions monitoring system or “CEMS” means all of the equipment that may be required to meet the data acquisition and availability requirements of this chapter, to sample, to condition (if applicable), to analyze, and to provide a record of emissions on a continuous basis.
Back siphonage means the backflow resulting from pressures lower than atmospheric pressure in the water installation;
Access Tandem Switch is a Switch used to connect End Office Switches to interexchange Carrier Switches. Qwest's Access Tandem Switches are also used to connect and switch traffic between and among Central Office Switches within the same LATA and may be used for the exchange of local traffic.
Reference evapotranspiration or “ETo” means a standard measurement of environmental parameters which affect the water use of plants. ETo is given expressed in inches per day, month, or year as represented in Appendix C of these Guidelines, and is an estimate of the evapotranspiration of a large field of four to seven-inch tall, cool-season grass that is well watered. Reference evapotranspiration is used as the basis of determining the Maximum Applied Water Allowances.
Nominal tomographic section thickness means the full width at half-maximum of the sensitivity profile taken at the center of the cross-sectional volume over which x-ray transmission data are collected.
Vehicle measuring attitude means the position of the vehicle as defined by the co-ordinates of fiducial marks in the three-dimensional reference system.
Predictive emissions monitoring system or "PEMS" means all of the equipment necessary to monitor process and control device operational parameters (for example, control device secondary voltages and electric currents) and other information (for example, gas flow rate, O2 or CO2 concentrations), and calculate and record the mass emissions rate (for example, pounds per hour) on a continuous basis.
Year 2000 Compliant means, with respect to the Company's Information Technology, that the Information Technology is designed to be used prior to, during and after the calendar Year 2000, and the Information Technology used during each such time period will accurately receive, provide and process date and time data (including, but not limited to, calculating, comparing and sequencing) from, into and between the 20th and 21st centuries, including the years 1999 and 2000, and leap-year calculations, and will not malfunction, cease to function, or provide invalid or incorrect results as a result of the date or time data, to the extent that other information technology, used in combination with the Information Technology, properly exchanges date and time data with it. The Company has delivered to the Buyers true and correct copies of all analyses, reports, studies and similar written information, whether prepared by the Company or another party, relating to whether the Information Technology is Year 2000 Compliant, if any.
Network Service User means an entity using Network Transmission Service.
Single tomogram system means a CT x-ray system which obtains x-ray transmission data during a scan to produce a single tomogram.
Carrier Access Billing System (“CABS”) is the system which is defined in a document prepared under the direction of the Billing Committee of the OBF. The CABS document is published by Telcordia in Volumes 1, 1A, 2, 3, 3A, 4 and 5 as Special Reports SR-OPT-001868, SR-OPT-0011869, SR-OPT-001871, SR-OPT- 001872, SR-OPT-001873, SR-OPT-001874, and SR-OPT-001875, respectively, and contains the recommended guidelines for the billing of access and other connectivity services. Sprint’s carrier access billing system is its Carrier Access Support System (CASS). CASS mirrors the requirements of CABS.
PID means photo ionization detector.
Synchronous Optical Network (SONET means the optical interface standard that allows inter-networking of transmission products from multiple vendors. The base rate is 51.84 Mbps (“OC 1/STS 1”) and higher rates are direct multiples of the base rate, up to 13.22 Gbps.
Downtime means the Total Minutes in the Month during which the Cloud Service (or Servers for Server Provisioning) does not respond to a request from SAP’s Point of Demarcation for the data center providing the Cloud Service (or Server for Server Provisioning), excluding Excluded Downtime.
Synchronous Optical Network (SONET) is an optical interface standard that allows inter-networking of transmission products from multiple vendors. The base rate is 51.84 Mbps (“OC-1/STS-1”) and higher rates are direct multiples of the base rate, up to 13.22 Gbps.