Examples of Power Quality Meter in a sentence
In this paper, we conducted security evaluation of two different smart meters, (i) General Electric (GE) Multilin EPM 6100 Power Quality Meter [25] (Figure 2) and (ii) Lyndis Gyr E650 s4x [29] (Figure 4) -both deployed Eth- ernet port for data communication, operating at a frequency of 60 HZ.For the experiment, both meters were connected to the remote monitoring computer and the attacker network over ethernet.
A G.E. or equivalent PQM (Power Quality Meter) and transducer unit shall be provided which allows continuous, real time monitoring of: Line to line Voltages (A-B, B-C, C-A) Line Currents (A, B, C)Line Frequency Kilowatts KilovarsKVAKilowatt-Hrs.
Additionally, inverter #2 also had a permanently installed Elspec Power Quality Meter (PQM) gathering data continuously.The inertial constant of one inverter will be set to H=5, which is on the lower end of the proposed range.
The Power Quality Meter shall be supplied along with the valid calibration certificate as per relevant standards.• Power quality compliance certificate as per IEC 61000-4-30 Ed. 3, IEC 62586-2 (Class-A)• Type test report (IS 14697) amended up to date (if applicable.)• Test Report of DLMS 15959, CAT B amended up to date• IEC 62443-4-1 & 2 Cyber Security Compliance (for Software System)• BIS compliance of manufacturing facilityCommunication device should be type tested.
Tests at 5kV AC rms showed a leakage current of around 20nA (insulation resistance of about 250GΩ).The readings of the total log current sensor and electrode potential sensor in the DAS were measured against the readings from a Fluke 435 Power Quality Meter with independent sensors (Fluke CT and Tektronix 1000:1 ‘scope probe).
Such trademark licenses shall be non-transferable, except that FMI shall have the right to sublicense such rights to its licensees in the FMI Territory, and Roche shall have the right to sublicense such rights to its permitted Sublicensees in the Territory.
The Power Quality Meter shall be supplied along with the valid calibration certificate as per relevant standards.
Centrifuge 4 Power Quality Meter (requires Serial to Ethernet Converter) CONTRACTOR is to provide all cabling, serial-to-Ethernet converters and other devices to connect the above devices to new SCADA Ethernet network.
The only additional hardware required is a sufficiently fast Power Quality Meter (PQM), in this case a SEL-735.
Centrifuge 3 Power Quality Meter (requires Serial to Ethernet Converter) Secondary Thickening Centrifuge 4 Sec.