Pressure test definition
Pressure test means a test that pressurizes the evaporative system to check for leakage as described in "IM240 & Evap Technical Guidance", EPA420-R-00-007, April 2000** and 40 CFR 51*.
Pressure test means a test to determine the integrity of the primary integral piping performed in accordance with Rules 62-762.601 and 62-762.602, F.A.C.
Pressure test means a test that pressurizes the evaporative system to check for leakage as described in High-Tech I/M Test Procedures, Emission Standards, Quality Control Requirements, and Equipment Specifications (dated April 1994)** and 40 CFR 51*.
Examples of Pressure test in a sentence
Pressure test in accordance with AWWA C600 for ductile iron pipe and AWWA C605 and M23 for PVC pipe and the following.
Examples: Pressure test, repeatability of a positioning system, bearing pre-load measurement etc.
Pressure test@ WP: ⮚ Stage#1 • 3 minutes without any drop ( chart as evidence) ⮚ Stage#2: • 15 minutes without and drop (chart as evidence).
The pump panel shall be equipped with Vacuum & Pressure test plugs to allow for test equipment to monitor pump pressure and vacuum levels.
Refilling should be done when pressure is drop 10% or more than 10% in stored pressure type and caking of powder in DCP cartridge type or after Hydraulic Pressure test (HPT).
More Definitions of Pressure test
Pressure test means a test to determine the integrity of integral piping performed in accordance with subparagraph 62-761.640(5)(a)1., F.A.C.
Pressure test means a test that pressurizes the evaporative system to check for leakage as described in High-Tech I/M Test Procedures, Emission Standards, Quality Control Requirements, and Equipment Specifications (dated April 1994)** "IM240 & Evap Technical Guidance", EPA420-R-00-007, April 2000** and 40 CFR 51*.
Pressure test means a check for the rate of water flow; also a test for leaks in the system.
Pressure test means a proof test in which the pipe is pressurized to evaluate its integrity, conducted in accordance with applicable API, ASME, or ASTM guidelines and the Pipeline manufacturer recommendations. In the event of a conflict between any guideline and the applicable Pipeline manufacturer’s recommendations for pressure testing, testing shall conform to the more stringent requirement.
Pressure test is a test to ensure the safety, reliability, and leak tightness of pressure systems that is required for a pressure system before initial use or an existing pressure system after repair or alteration.
Pressure test means a test to determine the integrity of integral piping performed in accordance with subparagraph 62-762.641(3)(e)1., F.A.C.
Pressure test means a functional test (such test to be developed and agreed to by the Parties in good faith prior to the time of testing) of the Gas Compressor to verify, using Prudent Industry Practices, that the Gas Compressor can maintain an actual discharge pressure of no less than 650 psig while both gas turbines at VCP and the adjacently located CCGT facility owned by Buyer or its Affiliates are all operating at a full load (such test, the has the meaning set forth in Section 7.08(b).