Examples of Reactive Power Output in a sentence
Reactive Power Output and Power FactorIn order to maintain transmission voltages on Big Rivers’ transmission facilities within acceptable limits, generating facilities and non-generation resources capable of providing reactive power that are under the control of the balancing area operator must be operated to produce (or absorb) reactive power as required by Big Rivers’ transmission facilities.
The Reactive Power Output under steady state conditions should be fully available as per capability curves within a voltage range of ± 5% of nominal value.
In the absence of a Dispatch Instruction for Reactive Power with a Dispatch Instruction to Synchronise, the Reactive Power Output shall be 0 MVAr; and• where a Dispatch Instruction to Desynchronise is given, a Dispatch Instruction for Reactive Power, compatible with shutdown, may be given prior to Desynchronisation being achieved.
In the absence of a separate Dispatch Instruction for Reactive Power, it is implicit in the instruction to Desynchronise that Reactive Power Output shall be reduced to 0 MVAr by the time of Desynchronisation.
Any constant Reactive Power Output control mode or constant Power Factor Output control mode must always be disabled, unless agreed otherwise with OETC.
The Reactive Power Output from the individual Centrally Dispatched Generating Unit (including a Wind Turbine Generating Unit or Solar Generating Unit) onto the Transmission System is the Output at the Generating Unit's Connection Point namely the HV side of the Generator Transformer (or at the Distribution System Connection Point in the case of Embedded Centrally Dispatched Generating Units).
Figure 2.2 shows the schematic of soil specimen in a triaxial chamber provided by AASHTO T 307.
Therefore, the output reactive power contribution for each individual generator is equal to each other.VQ Curve Qmargin-WEAK0.550.650.750.850.951.05Qmargin-STIFFQ (p.u) WTG Stiff-GridQ (p.u) WTG Weak-Grid0.4 Reactive Power Output (p.u.)0.2 0 -0.2 -0.4Regulated Voltage at bus 3 (p.u.) Figure 33.
The Reactive Power Output under steady state conditions should be ful y available as per capability curves within a voltage range of ± 5% of nominal value.(vi ) Governors: Al new Generating units must have automatic Governors with a droop of 3 to 6% and automatic voltage regulators.
Figure 1.0The rating of the Power Park Module or HVDC System is calculated on the basis of the rated MW output at maximum Reactive Power Output.