Reagent Injection definition

Reagent Injection or "RI" means an H2SO4 control system consisting of the injection of a reagent in the flue gas stream to react with the acid gases and reduce the outlet H2SO4 Emissions Rate.
Sample 1Sample 2Sample 3
Reagent Injection or "RI" means an H2 SO4 control system consisting of the injection of a reagent in the flue gas stream to react with the acid gases and reduce the outlet
Sample 1

Examples of Reagent Injection in a sentence

  • Where Dynegy Zimmer has selected Option 2 (Sulfuric Acid Stack Test and reagent injection) as set forth in Paragraph17.b above, during malfunction of the Sulfuric Acid Mitigation System that prevents reagent injection at rates and, if liquid reagent is used, concentration, consistent with the applicable Reagent Injection Compliance Curve, Dynegy Zimmer shall use either Option 1 or Option 3 as set forth in Paragraphs 17.a and c above as its compliance demonstration option.

  • Dynegy Zimmer may exceed the Final Sulfuric Acid Emissions Rate set forth in Paragraph 14 above during the following events: (1) limited and infrequent testing of an alternative sulfuric acid mitigation system reagent approved by EPA; and (2) limited and infrequent periods of a Sulfuric Acid Stack Test when determining Reagent Injection Compliance Curves in accordance with Paragraph 30 below.

  • Engineering evaluations have been completed to describe the performance and impact of NOx reduction technologies such as staging and overfire air, low NOx burners, visciated air and air preheating, co-firing of opportunity fuels, fuel blending, Rich Reagent Injection (RRI), Selective Non-catalytic Reduction (SNCR), gas reburning, and Fuel Lean Gas Reburning (FLGR).

  • These projects include: Sibley Unit 3: Selective Catalytic Reducer (SCR) Sibley Unit 1 and 2: Selective Non-Catalytic Reducer (SNCR) with Rich Reagent Injection (RRI) Jeffrey Energy Center: Replacing/rebuilding three scrubbers During the two six-month accumulation periods from June 1, 2007 through May 31, 2008, these projects were in various phases of construction and were not operational.

  • After completing the requirements of Paragraph 33, at all times that each unit at the Petersburg Station is in operation, IPL shall maintain a level at or above the reagent concentration (e.g., molar ratio) and reagent injection rate (based on a 24-hour rolling average injection rate) that corresponds to the operating load on the Reagent Injection Compliance Curve developed in Paragraph 33.35.

  • The Rich Reagent Injection (RRI) process reduces formation of NOx by injecting amine-based com- pounds into the fuel-rich regions of furnaces.

  • Rich Reagent Injection (RRI) – uses ammonia or urea as a reducing agent that converts NOx to nitrogen and water without using a catalyst.

  • Through a license agreement with Reaction Engineering International (REI), we added Rich Reagent Injection, a technology jointly developed by REI and the Electric Power Research Institute, yet another process that provides for NOx reductions in a cost-effective manner.

  • Within sixty (60) Days after the completion of each sulfuric acid stack test under this Decree IPL shall develop a Sulfuric Acid Mitigation System Reagent Injection Compliance Curve that corresponds to the reagent and reagent injection rates utilized during the last successfully demonstrated compliant stack test, and include such curve as part of the stack test report submitted in accordance with Paragraph 32 above.34.

  • WPL has considered a range of commercially available technologies for NOx removal at Edgewater Unit 5, including Rich Reagent Injection (RRI), Selective Non-Catalytic Reduction (SNCR), Hybrid SCR, and Full-size SCR.

Related to Reagent Injection

  • Injection means the injection of carbon dioxide streams into the storage site;

  • Injection tool means a device used for controlled subsurface injection of radioactive tracer material.

  • Semisolid means a product that, at room temperature, will not pour, but will spread or deform easily, including but not limited to gels, pastes, and greases.

  • Underground injection means the subsurface emplacement of fluids through a bored, drilled or driven well; or through a dug well, where the depth of the dug well is greater than the largest surface dimension. (See also “injection well”.)

  • Injection well means a well into which fluids are injected. (See also “underground injection”.)

  • Reagent means any product other than fuel that is stored on-board the vehicle and is provided to the exhaust after-treatment system upon request of the emission control system.

  • Fluoroscopic imaging assembly means a subsystem in which X-ray photons produce a visual image. It includes the image receptor(s) such as the image intensifier and spot-film device, electrical interlocks, if any, and structural material providing linkage between the image receptor and diagnostic source assembly.

  • Feed ingredient means each of the constituent materials making up a commercial feed.

  • Polystyrene foam means blown polystyrene and expanded and

  • Polystyrene foam adhesive means an aerosol adhesive designed to bond polystyrene foam to substrates.

  • Nitrogen oxides means nitric oxide and nitrogen dioxide, expressed as nitrogen dioxide (NO2);

  • Ethanol blended gasoline means the same as defined in section 214A.1.

  • Drug Substance means an active ingredient that is intended to furnish pharmacological activity or other direct effect in the diagnosis, cure, mitigation, treatment, or prevention of disease or to affect the structure or any function of the human body, but does not include intermediates used in the synthesis of such ingredient.

  • Hydrofluorocarbons means compounds that only contain hydrogen, fluorine, and carbon.

  • Cyanoacrylate adhesive means any adhesive with a cyanoacrylate content of at least 95% by weight.

  • Epinephrine auto-injector means a device for immediate self-administration or administration by another trained person of a measured dose of epinephrine to a person at risk of anaphylaxis.

  • Diesel means a distillate oil which can be used as fuel for the operation of a compression ignition engine and which has an approximate boiling temperature of between 150 °C to 400 °C;

  • Bulk gasoline plant means a gasoline storage and distribution facility with an average daily throughput of 20,000 gallons (76,000 liters) of gasoline or less on a 30-day rolling average.

  • Feedstock means any controlled substance or new substance that undergoes chemical transformation in a process in which it is entirely converted from its original composition and whose emissions are insignificant,

  • Chemical substance means a substance intended to be used as a precursor in the manufacture of a controlled substance or any other chemical intended to be used in the manufacture of a controlled substance. Intent under this subsection may be demonstrated by the substance's use, quantity, manner of storage, or proximity to other precursors or to manufacturing equipment.

  • Bulk drug substance means any substance that is represented for use, and that, when used in the

  • Transportation district and "district" shall mean the

  • Geothermal fluid means water in any form at temperatures greater than 120

  • Gasoline dispensing facility means any site where gasoline is dispensed to motor vehicle gasoline tanks from stationary storage tanks.

  • Transportation project or "project" means any or the

  • Chemical Storage Facility means a building, portion of a building, or exterior area adjacent to a building used for the storage of any chemical or chemically reactive products.