Examples of Single command in a sentence
The two agencies formed a hybrid model that has features such as: - Single-source dispatching- Consistent training for all responders- Common and shared language and response culture- Elimination of redundancy- Single command structure- Shared facilities While I am open to the idea of looking at some sort of model, I believe that our relatively small size and call volume would not make operational sense to a private ambulance provider.
Command is generally established in the following two ways: Single command is utilized when an incident occurs within a single jurisdiction and there is no jurisdictional or functional agency overlap, a single IC should be designated with overall incident management responsibility by the appropriate jurisdictional authority.
Secondary system supervision Current circuit supervisionFuse failure supervisionMonitoring Measurements Event counterDisturbance report Fault locatorCommunication IEC61850-8-1 CommunicationIEC60870-5-103 communication protocol Single command, 16 signalsMultiple command and transmit.
RTS/CTS are not uSed for Single command and meSSage packetS, or Small groupS of packetS (e.g. 4) for longer meSSageS that require leSS than a couple SecondS to tranSmit.
The command structure may be established as single command, unified command, or area command and may be changed as the incident progresses to meet evolving needs.Single CommandA Single command is generally established when an incident is contained within and affects a single jurisdiction and / or single agency has the legal responsibility to manage the principle incident hazard.
Single command <45>, Double command <46>, Set point command <49> (last one can be relayed to h06 function for Modbus devices); • Modbus RTU/TCP: Force single coil (h05), Write single holding register (h06); • IEC 61850: direct-with-normal-security, sbo-with-normal-security, direct-with- enhanced-security, sbo-with-enhanced-security.
Where data concentrators will capture and process data for transmission to the control centres it is expected that the following functions shall be provided:• Single command outputs, double command outputs for supervisory (on/off) control of circuit breakers, isolators etc.
Single command exampleAn example of a command with a parameter:Enter APN internet.beeline.ru,beeline,beeline as shown in the figure above and press Run single commandbutton.
Single command is applicable when there is no overlap of jurisdictional boundaries or when a single IC is designated by the agency with overall management responsibility for the incident.
The following code shows an example of issuing data point setting commands: linkNo = 1 // ASDU CA ioa = 123;u8val = 1; // ONqu = 0; // qualifier of commands (default) isSelect = 1; // Select before operate typeId = 45; // Single command if (!Iec101MAppSendDOCmd(appCfg.link.casdu, typeId, ioa, u8val, qu, (uint8_t)isSelect)){dprintf(fd, "CA=%hu, Sending Digital Output command failed\n", appCfg.link.casdu); break;} The above example can be used to send Single or Double point commands.