Static load definition

Static load means the live load that the orchestra pit lift is designed and installed to support while the lift platform is not in motion as provided by the manufacturer upon installation or as approved by the department.
Static load. 400 Te equally spread between nodes 1 to 4. VCG 55' ABL ------------------------------------------------------------------------------- Revision March 30, 2000 Page 84 of 87 110 Midnight Warrior Technical Specifications -------------------------------------------------------------------------------- Dynamic loads (worst case of survival): per mode 135 Te or 150 ST to sterx xx bow 145 Te or 161 ST to port or starboard 790 Te or 877 ST vertical down or 170 Te or 189 ST vertical up MOON POOL LOAD HANDLING FOUNDATION [DIAGRAM] Maximum load: 135 Te or 150 ST at each mode 1 to 4 (moon pool corners).

Examples of Static load in a sentence

  • To maintain control in these countries, there is the need to create a local crop of comprador elite of leaders who will facilitate the exploitation process.

  • Main Features of Codine • Support for batch, interactive and parallel (Express, p4 and PVM) jobs.• Support for multiple queues.• Support for checkpointing.• Static load balancing.• Dynamic load balancing by checkpointing and job migration.• NQS interface - used for integration with existing NQS-based systems.• Accounting and utilisation statistics.• X11 Motif GUI, command-line and script interfaces for administrators and users.• POSIX compliance.• Support for DCE technology.

  • Static load verification is to be provided for platforms with a height of 0.50 m and more.

  • Static load tests shall be performed in accordance with the procedures specified in ASTM D1143.

  • Static load test – stiffnessSpecified No. of Samples :10% or 20 springs whichever is less Actual No. of samples :Load of 30% - Load of 70% - Specified Spring rate –Sample No. QC INCHARGE OF M/s RDSO INSPECTING OFFICIAL12.

  • Static load testing shall be used after a test pile has been driven to sufficient bearing as determined by the dynamic formula.

  • Static load testing of TP 1 and TP 2 will be accomplished prior to driving the piling for the abutments.

  • Static load tests are conducted to determine the shaft (or pile) performance and the soil response in resisting applied axial and lateral loads.

  • Percentage analysis of vertical displacement differences; Static load test (Period2a-2b) The value of displacement difference LEV/TRYG [mm]The use of precise leveling in the study of bridge stability (not just railway bridge) is one of the most common research solution.

  • Static load models are usually simpler to implement compared to the dynamic ones.

Related to Static load

  • Low-level radioactive waste or “waste” means radioactive material that consists of or contains class A, B, or C radioactive waste as defined by 10 C.F.R. 61.55, as in effect on January 26, 1983, but does not include waste or material that is any of the following:

  • Manual Load Dump Warning means a notification from PJM to warn Members of an increasingly critical condition of present operations that may require manually shedding load.

  • credit meter means a meter where an account is issued subsequent to the consumption of electricity;

  • Maximum Concentration Level Assessment means the Maximum Concentration Level Assessment for the purposes of a Basic Comprehensive Certificate of Approval, described in the Basic Comprehensive User Guide, prepared by a Toxicologist using currently available toxicological information, that demonstrates that the concentration at any Point of Impingement for a Compound of Concern that does not have a Ministry Point of Impingement Limit is not likely to cause an adverse effect as defined by the EPA. The concentration at Point of Impingement for a Compound of Concern must be calculated in accordance with O. Reg. 419/05.

  • Concentration Percentage means (i) for any Group A Obligor, 10.00%, (ii) for any Group B Obligor, 8.00%, (iii) for any Group C Obligor, 6.00% and (iv) for any Group D Obligor, 4.00%.

  • Electronic Funds Transfer (EFT) indicator means a four-character suffix to the unique entity identifier. The suffix is assigned at the discretion of the commercial, nonprofit, or Government entity to establish additional System for Award Management records for identifying alternative EFT accounts (see subpart 32.11) for the same entity.

  • Instantaneous flow measurement means the flow measured during the minimum time required for the flow-measuring device or method to produce a result in that instance. To the extent practical, instantaneous flow measurements coincide with the collection of any grab samples required for the same sampling period so that together the samples and flow are representative of the discharge during that sampling period.

  • High global warming potential hydrofluorocarbons means any hydrofluorocarbons in a particular end use for which EPA’s Significant New Alternatives Policy (SNAP) program has identified other acceptable alternatives that have lower global warming potential. The SNAP list of alternatives is found at 40 CFR Part 82 subpart G with supplemental tables of alternatives available at (http://www.epa.gov/snap/).

  • Manual Load Dump Action means an Operating Instruction, as defined by NERC, from PJM to shed firm load when the PJM Region cannot provide adequate capacity to meet the PJM Region’s load and tie schedules, or to alleviate critically overloaded transmission lines or other equipment.

  • Maximum contaminant level goal or “MCLG” means the maximum level of a contaminant in drinking water at which no known or anticipated adverse effect on the health of persons would occur, and which allows an adequate margin of safety. MCLGs are nonenforceable health goals.

  • Maximum contaminant level means the maximum permissible level of a contaminant in water which is delivered to any user of a public water system.

  • Interconnection Point means the point(s) of connection(s) at which the project is connected to the grid i.e. it shall be at 11 / 22 kV bus bar level of substation of MSEDCL.

  • low voltage means the set of nominal voltage levels that are used for the distribution of electricity and whose upper limit is generally accepted to be an a.c. voltage of 1000V ( or a d.c. voltage of 1500 V). [SANS 1019]

  • Switched Access Detail Usage Data means a category 1101xx record as defined in the EMI Telecordia Practice BR 000-000-000.

  • INTER-CONNECTION POINT/ DELIVERY/ METERING POINT means a single point at 220kV or above, where the power from the Project(s) is injected into the identified ISTS Substation (including the dedicated transmission line connecting the Projects with the substation system) as specified in the RfS document. Metering shall be done at this interconnection point where the power is injected into. For interconnection with grid and metering, the WPDs shall abide by the relevant CERC/ SERC Regulations, Grid Code and Central Electricity Authority (Installation and Operation of Meters) Regulations, 2006 as amended and revised from time to time.

  • Concentration Reserve Percentage means, at any time of determination, the largest of: (a) the sum of the five (5) largest Obligor Percentages of the Group D Obligors, (b) the sum of the three (3) largest Obligor Percentages of the Group C Obligors, (c) the sum of the two (2) largest Obligor Percentages of the Group B Obligors and (d) the largest Obligor Percentage of the Group A Obligors.

  • Meet-Point Billing (MPB means the billing associated with interconnection of facilities between two (2) or more LECs for the routing of traffic to and from an IXC with which one of the LECs does not have a direct connection. In a multi-bill environment, each Party bills the appropriate tariffed rate for its portion of a jointly provided Switched Exchange Access Service.

  • Slug loading means any pollutant, including oxygen demanding pollutants, released in a discharge at a flow rate and/or pollutant concentration as to cause interference in the POTW.

  • Palletized unit load means a MIL-STD-129 defined quantity of items, packed or unpacked, arranged on a pallet in a specified manner and secured, strapped, or fastened on the pallet so that the whole palletized load is handled as a single unit. A palletized or skidded load is not considered to be a shipping container. A loaded 463L System pallet is not considered to be a palletized unit load. Refer to the Defense Transportation Regulation, DoD 4500.9-R, Part II, Chapter 203, for marking of 463L System pallets.

  • Runoff volume means the volume of water that runs off the land development project from a prescribed storm event.

  • high voltage means the classification of an electric component or circuit, if its working voltage is > 60 V and ≤ 1500 V DC or > 30 V and ≤ 1000 V AC root mean square (rms).

  • Transit Traffic means traffic originating on CLEC’s network that is switched and transported by AT&T-TSP and delivered to a Third Party Terminating Carrier’s network or traffic from a Third Party Originating Carrier’s network. A call that is originated or terminated by a CLEC purchasing local switching pursuant to a commercial agreement with AT&T-TSP is not considered Transit Traffic for the purposes of this Attachment. Additionally Transit Traffic does not include traffic to/from IXCs.

  • Digital Signal Level 3 (DS-3 means the 44.736 Mbps third level signal in the time division multiplex hierarchy.

  • Lead-contaminated dust means surface dust that contains an area or mass concentration of lead at

  • Market Participant Energy Injection means transactions in the Day-ahead Energy Market and Real-time Energy Market, including but not limited to Day-ahead generation schedules, real- time generation output, Increment Offers, internal bilateral transactions and import transactions, as further described in the PJM Manuals.

  • Eligible customer-generator means a customer-generator whose net energy metering system for renewable resources, cogeneration, fuel cells, and microturbines meets all applicable safety and performance standards.