Switch ON definition

Switch ON means to manually or automatically operate an illuminating or signalling function to effectively emit light, irrespective of whether the function is operating correctly or not.
Sample 1Sample 2Sample 3
Switch ON means manually turn on a FAD buoy to enable the FAD Buoy to send or receive satellite transmissions of position and any other available information.
Sample 1
Switch ON means to manually, or automatically or through the action of an ADS, operate an illuminating or signalling function to effectively emit light, irrespective of whether the function is operating correctly or not.”
Sample 1

Examples of Switch ON in a sentence

  • Switch ON Bluetooth from the mobile phone and ensure it is discoverable.

  • Switch ON Bluetooth on the mobile phone side and ensure it is discoverable.

  • Switch ON shall denote bit state "1" to the 170 CPU and switch OFF shall denote bit state "0" to the 170 CPU.

  • Controller Light Switch ON OFF Main Power SwitchRocker Switch Rear Grille Mainnot turn on, check that all of the light plugs are in.

  • NOTETurning the base Main Power Switch ON will change the table operation to AC power.

  • The LED to the left of the display is LED 1 while the one to the right is LED 2.The following options can be selected when setting the LEDs:• Signal Selection: The following signals can be selected: turbidity 1 and 2.• Output function, direction of action, switch point entry method, switch point, hysteresis• Switch ON Delay, Switch OFF Delay: The digital output is switched on or off with the delay set here.

  • Normal outputSet point 1Switch ON Hysteresis Switch OFFOFF ON Stroke Reversed output Switch ON Switch OFF Set point 1 Hysteresis ON OFF Stroke 2Auto Switch Mode Set point 1 is at the centre of the operating range (the range is approx.

  • Switch ON the main power supply button Switch ON the UPS button Switch ON the CPU buttonSwitch ON the monitor button.

  • There is no Hot Water CauseRemedyThe heating system is off.- Switch the ON/OFF switch ON (refer to diagrams on page 20).- Switch ON the mains isolator, if installed (outside the boiler room).- Reset the fuse/MCB in the power distribution board (main domestic fuse/ MCB).■ Control unit incorrectly adjusted.■ Remote control (if installed) set incorrectly.

  • Close doors properly while coming out of the car.2. Do not turn the Key Switch ON when the doors are open - this makes remote button disabled even after the Key Switch is switched OFF.This situation is indicated by the continuous glow of the CDL-LED.CAUTIONDuring the neutral time however , the car stays immobilized - the CDL-LEDglows continuously to indicate this.

Related to Switch ON

  • Interconnection arrangements means arrangements governing the physical connection of two or more networks to allow the use of another's network to hand off traffic where it is ultimately delivered (e.g., connection of a customer of telephone provider A to a customer of telephone company B) or sharing data and other information resources.

  • Interconnection is as defined in the Act.

  • Trunk means a communication line between two switching systems.