File Naming Conventions Files will be named according to the following convention: {gTLD}_{YYYY-MM-DD}_{type}_S{#}_R{rev}.{ext} where: {gTLD} is replaced with the gTLD name; in case of an IDN-TLD, the ASCII-compatible form (A-Label) must be used; {YYYY-MM-DD} is replaced by the date corresponding to the time used as a timeline watermark for the transactions; i.e. for the Full Deposit corresponding to 2009-08-02T00:00Z, the string to be used would be “2009-08-02”; {type} is replaced by: “full”, if the data represents a Full Deposit; “diff”, if the data represents a Differential Deposit; “thin”, if the data represents a Bulk Registration Data Access file, as specified in Section 3 of Specification 4; {#} is replaced by the position of the file in a series of files, beginning with “1”; in case of a lone file, this must be replaced by “1”. {rev} is replaced by the number of revision (or resend) of the file beginning with “0”: {ext} is replaced by “sig” if it is a digital signature file of the quasi-homonymous file. Otherwise it is replaced by “ryde”.
LEAVE FOR PROVINCIAL CONTRACT NEGOTIATIONS 1. The employer shall grant a leave of absence without pay to an employee designated by the BCTF for the purpose of preparing for, participating in or conducting negotiations as a member of the provincial bargaining team of the BCTF. 2. To facilitate the administration of this clause, when leave without pay is granted, the employer shall maintain salary and benefits for the employee and the BCTF shall reimburse the employer for the salary costs. 3. Any other leaves of absence granted for provincial bargaining activities shall be granted on the basis that the salary and benefits of the employees continue and the BCTF shall reimburse the employer for the salary costs of any teacher employed to replace a teacher granted leave. 4. Any leaves of absence granted for local bargaining activities shall be granted in accordance with the Previous Local Agreement.
Union Conventions Subject to the approval of the supervisor(s) concerned, and upon written request submitted at least twenty (20) working days in advance, leave of absence without pay shall be granted to not more than two (2) employees at any one time, who may be elected or selected by the Union to attend any authorized labour convention. Such leave of absence is to be confined to the actual duration of the convention and the necessary travelling time. Such leave shall not exceed ten (10) working days per year for each employee to whom such leave is granted.
LEAVE FOR REGULATORY BUSINESS AS PER THE TEACHERS’ ACT 1. Upon written request to the Superintendent or designate from the Ministry of Education, an employee who is appointed or elected to the BC Teachers’ Council or appointed to the Disciplinary or Professional Conduct Board shall be entitled to a leave of absence with pay and shall be deemed to be in the full employ of the board as defined in Article G.6.1. 2. Upon written request to the superintendent or designate from the Ministry of Education, a teacher teaching on call (TTOC) who is appointed or elected to the BC Teachers’ Council or appointed to the Disciplinary and Professional Conduct Board shall be considered on leave and shall be deemed to be in the full employ of the Board as defined in Article A.10.1 above. TTOCs shall be paid in accordance with the collective agreement. 3. Leave pursuant to Article A.10.1 and A.10.2 above shall not count toward any limits on the number of days and/or teachers on leave in the provisions in Article G.6.
Recognition of the U.S. Special Resolution Regimes (i) In the event that any Underwriter that is a Covered Entity becomes subject to a proceeding under a U.S. Special Resolution Regime, the transfer from such Underwriter of this Agreement, and any interest and obligation in or under this Agreement, will be effective to the same extent as the transfer would be effective under the U.S. Special Resolution Regime if this Agreement, and any such interest and obligation, were governed by the laws of the United States or a state of the United States. (ii) In the event that any Underwriter that is a Covered Entity or a BHC Act Affiliate of such Underwriter becomes subject to a proceeding under a U.S. Special Resolution Regime, Default Rights under this Agreement that may be exercised against such Underwriter are permitted to be exercised to no greater extent than such Default Rights could be exercised under the U.S. Special Resolution Regime if this Agreement were governed by the laws of the United States or a state of the United States. As used in this Section 16(e):
Please see the current Washtenaw Community College catalog for up-to-date program requirements Conditions & Requirements
Measurements and arithmetic conventions All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.
Pricing Instrument; Execution and Incorporation of Terms The parties hereto will enter into this Indenture by executing the Pricing Instrument. By executing the Pricing Instrument, the Indenture Trustee, the Registrar, the Transfer Agent, the Paying Agent, the Calculation Agent and the Trust hereby agree that the Indenture will constitute a legal, valid and binding agreement between the Indenture Trustee, the Registrar, the Transfer Agent, the Paying Agent, the Calculation Agent and the Trust. All terms relating to the Trust or the Notes not otherwise included herein will be as specified in the Pricing Instrument or Pricing Supplement, as indicated herein.
CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes
Basis for Layoff A. The reasons for layoffs include, but are not limited to, the following: 1. Lack of funds; 2. Lack of work; or 3. Organizational change. B. Examples of layoff actions due to lack of work include, but are not limited to: 1. Termination of a project or special employment; 2. Availability of fewer positions than there are employees entitled to such positions; 3. Employee’s ineligibility to continue in a position following its reallocation to a class with a higher salary maximum; or 4. Employee’s ineligibility to continue, or choice not to continue, in a position following its reallocation to a class with a lower salary range maximum.
