Diagnostic Assessment 6.3.1 Boards shall provide a list of pre-approved assessment tools consistent with their Board improvement plan for student achievement and which is compliant with Ministry of Education PPM (PPM 155: Diagnostic Assessment in Support of Student Learning, date of issue January 7, 2013). 6.3.2 Teachers shall use their professional judgment to determine which assessment and/or evaluation tool(s) from the Board list of preapproved assessment tools is applicable, for which student(s), as well as the frequency and timing of the tool. In order to inform their instruction, teachers must utilize diagnostic assessment during the school year.
Ergonomic Assessments At the request of the employee, the Employer will ensure that an ergonomic assessment of the employee’s workstation is completed. Solutions to identified issues will be implemented within available resources.
Conformity Assessment Procedures 1. Each Party shall give positive consideration to accepting the results of conformity assessment procedures of other Parties, even where those procedures differ from its own, provided it is satisfied that those procedures offer an assurance of conformity with applicable technical regulations or standards equivalent to its own procedures. 2. Each Party shall seek to enhance the acceptance of the results of conformity assessment procedures conducted in the territories of other Parties with a view to increasing efficiency, avoiding duplication and ensuring cost effectiveness of the conformity assessments. In this regard, each Party may choose, depending on the situation of the Party and the specific sectors involved, a broad range of approaches. These may include but are not limited to: (a) recognition by a Party of the results of conformity assessments performed in the territory of another Party; (b) recognition of co-operative arrangements between accreditation bodies in the territories of the Parties; (c) mutual recognition of conformity assessment procedures conducted by bodies located in the territory of each Party; (d) accreditation of conformity assessment bodies in the territory of another Party; (e) use of existing regional and international multilateral recognition agreements and arrangements; (f) designating conformity assessment bodies located in the territory of another Party to perform conformity assessment; and (g) suppliers’ declaration of conformity. 3. Each Party shall exchange information with other Parties on its experience in the development and application of the approaches in Paragraph 2(a) to (g) and other appropriate approaches with a view to facilitating the acceptance of the results of conformity assessment procedures. 4. A Party shall, upon request of another Party, explain its reasons for not accepting the results of any conformity assessment procedure performed in the territory of that other Party.
Risk Assessment An assessment of any risks inherent in the work requirements and actions to mitigate these risks.
Joint Assessment If the Premises are not separately assessed, Lessee's liability shall be an equitable proportion of the Real Property Taxes for all of the land and improvements included within the tax parcel assessed, such proportion to be conclusively determined by Lessor from the respective valuations assigned in the assessor's work sheets or such other information as may be reasonably available.
Assessment The Secretary of State will notify the appropriate body for assessment purposes about the Academy.
Loss Assessment We will pay up to $1000 for your share of loss assessment charged during the policy period against you by a corporation or as- sociation of property owners, when the assess- ment is made as a result of:
Phase II A small portion of the work for the Phase II modifications to the Plattsburgh Substation will be performed by Transmission Owner, and the remainder will be performed by Clinton and Xxxxxxxxx. A detailed definition of the specific scope for Transmission Owner and Clinton and Xxxxxxxxx including interface points shall be defined during the design phase and, as such documents become available, copies will be delivered to the NYISO, Transmission Owner, Noble Altona Windpark, LLC and Marble River, LLC. The full scope includes the installation of wave traps, CCVT’s and modifications and/or additions to relaying on the MWP-1 and MWP- 2 lines. These lines will be reconfigured at the completion of Phase II to connect to Xxxxx and Xxxxxxx Substations on MWP-1 and the Xxxx Substation on MWP-2. Clinton and Xxxxxxxxx will design the upgrades and purchase the materials based on the outline specification that was prepared and issued by Transmission Owner. The work to be performed by Clinton and Xxxxxxxxx will include both the materials for the exterior and interior installations and items for Transmission Owner installation inside the control building in existing relay panels and communication racks. In addition, Clinton and Xxxxxxxxx will be responsible for the exterior and interior construction work and will provide construction management services in coordination with Transmission Owner. The civil design for the foundations and the electrical design for the cable runs to the control room will be designed by, as approved by Transmission Owner, and installed under the supervision and control of Clinton and Xxxxxxxxx. The equipment will be selected and procured in accordance with the specifications developed during the detailed engineering phase, copies of which shall be furnished to the NYISO, Transmission Owner, Noble Altona Windpark, LLC and Marble River, LLC. The construction of the foundations, structures, wave traps, CCTV and cable runs into the control building to the termination cabinets will be completed by Clinton and Xxxxxxxxx. The work at the Plattsburgh Substation will be installed under Transmission Owner’s CPP-1. Transmission Owner will provide Protection and Controls Engineering, install and terminate wiring from the termination cabinets to the control panels and relays, install relays and equipment in the existing panels, and will commission such work inside the 230kV control building. Transmission Owner will develop the communications protocols and data flow over the circuits.
Report on Assessment of Compliance and Attestation (a) On or before March 1 of each calendar year, commencing in 2007, the Servicer shall: (i) deliver to the Owner and any Depositor a report (in form and substance reasonably satisfactory to the Owner and such Depositor) regarding the Servicer’s assessment of compliance with the Servicing Criteria during the immediately preceding calendar year, as required under Rules 13a-18 and 15d-18 of the Exchange Act and Item 1122 of Regulation AB. Such report shall be addressed to the Owner and such Depositor and signed by an authorized officer of the Servicer, and shall address each of the Servicing Criteria specified on a certification substantially in the form of Exhibit 7 hereto delivered to the Owner concurrently with the execution of this Agreement; (ii) deliver to the Owner and any Depositor a report of a registered public accounting firm reasonably acceptable to the Owner and such Depositor that attests to, and reports on, the assessment of compliance made by the Servicer and delivered pursuant to the preceding paragraph. Such attestation shall be in accordance with Rules 1-02(a)(3) and 2-02(g) of Regulation S-X under the Securities Act and the Exchange Act; (iii) cause each Subservicer, and each Subcontractor determined by the Company pursuant to Section 12.06(b) to be “participating in the servicing function” within the meaning of Item 1122 of Regulation AB, to deliver to the Owner and any Depositor an assessment of compliance and accountants’ attestation as and when provided in paragraphs (a) and (b) of this Section; and (iv) if requested by the Owner or any Depositor not later than February 1 of the calendar year in which such certification is to be delivered, deliver to the Owner, any Depositor and any other Person that will be responsible for signing the certification (a “Sarbanes Certification”) required by Rules 13a-14(d) and 15d-14(d) under the Exchange Act (pursuant to Section 302 of the Xxxxxxxx-Xxxxx Act of 2002) on behalf of an asset-backed issuer with respect to a Securitization Transaction a certification in the form attached hereto as Exhibit 6. The Servicer acknowledges that the parties identified in clause (a)(iv) above may rely on the certification provided by the Servicer pursuant to such clause in signing a Sarbanes Certification and filing such with the Commission. Neither the Owner nor any Depositor will request delivery of a certification under clause (a)(iv) above, unless a Depositor is required under the Exchange Act to file an annual report on Form 10-K with respect to an issuing entity whose asset pool includes Mortgage Loans. (b) Each assessment of compliance provided by a Subservicer pursuant to Section 12.05(a)(i) shall address each of the Servicing Criteria specified on a certification substantially in the form of Exhibit 7 hereto delivered to the Owner concurrently with the execution of this Agreement or, in the case of a Subservicer subsequently appointed as such, on or prior to the date of such appointment. An assessment of compliance provided by a Subcontractor pursuant to Section 12.05(a)(iii) need not address any elements of the Servicing Criteria other than those specified by the Servicer pursuant to Section 12.06.
Environmental Assessment Buyer shall have the right for a period commencing upon execution of this Agreement by both parties and ending on November 28, 2012, to conduct an environmental assessment of the Assets, at Buyer’s sole risk, liability and expense. Seller shall make available to Buyer, during the environmental assessment period described above, Seller’s historical files regarding prior operations on the Assets, and provide Buyer and its representatives with reasonable access to the Assets to conduct the environmental assessment. Buyer shall provide Seller three (3) days prior written notice of a desired date(s) for such assessment and Seller shall have the right to be present during any assessment and, if any testing is conducted pursuant to Seller’s express prior written consent, Seller may require splitting of all samples. Notwithstanding any other provision of this Agreement to the contrary, Buyer shall not have the right to drill any test, monitor or other xxxxx or to extract samples of any air, soil, water or other substance from the Assets without Seller’s express prior written consent. If Buyer proposes a reasonable request to drill a test well or extract a sample pursuant to a systematic and customary procedure for the assessment of the environmental condition of the Assets and Seller refuses to grant its consent to such a well or sampling, then Buyer shall have the right, for a period of seventy-two (72) hours following notification of Seller’s refusal to consent, to deliver written notice to Seller of Buyer’s election to exclude from this transaction the portion of the Assets affected by such proposed test well or sample, and the Purchase Price shall be adjusted accordingly by the Allocated Value of such portion of the Assets so excluded. Under no circumstances whatsoever shall Seller ever be obligated to grant its consent to any such test xxxxx or sampling proposed by Buyer, and Buyer’s sole and exclusive remedy for any refusal by Seller to grant its consent shall be the limited right contained in the preceding sentence to exclude the affected Assets from the transactions contemplated by this Agreement. If Buyer fails to exercise the right to exclude such Assets by written notice to Seller delivered prior to the expiration of the seventy-two hour period described above, then Buyer shall be conclusively deemed to have waived such right and shall be obligated to purchase the affected Assets without conducting such testing or sampling or any adjustment of the Purchase Price unless otherwise provided in this Agreement.