Common use of , amend to read Clause in Contracts

, amend to read. 6.1.1.1. The section width shall be calculated by the following formula: S = S1 + K (A-A1), where: S is the "section width" rounded to the nearest millimetre and measured on the measuring rim; S1 is the "nominal section width" (in mm) as shown on the side wall of the tyre in the designation of the tyre as prescribed; A is the width (expressed in mm) of the measuring rim, as shown by the manufacturer in the descriptive note, 5 A1 is the width (expressed in mm) of the theoretical rim. A1 shall be taken to equal S1 multiplied by the factor x, as specified by the manufacturer, and K shall be taken to equal 0.4.

, amend to read. 6.1.1.1. The section width shall be calculated by the following formula: S 𝑆 = S1 𝑆1 + K 𝐾 ∙ (A-A1𝐴 − 𝐴1), where: S is the "section width" width rounded to the nearest millimetre and measured on the measuring rimmillimetre; S1 is the "nominal section width" width (in mm) as shown on the side wall of the tyre in the designation of the tyre as prescribed; A is the width (expressed in mm) of the measuring rim, as shown by the manufacturer in the descriptive note, 5 ; 5/ A1 is the width (expressed in mm) of the theoretical rim. A1 shall be taken to equal S1 multiplied by the factor x, as specified by the manufacturer, and K shall be taken to equal 0.4." Footnote 5/, amend to read: "5/ When the rim width is given by code, the value in mm is obtained by multiplying such number by 25.4."

, amend to read. 6.1.1.1. The section width shall be calculated obtained by means of the following formula: S = S1 + K (A-A - A1), whereWhere: S is the "section width" rounded to the nearest millimetre and measured on the measuring rim; S1 is "the "nominal section width" (in mm) millimetres, as shown on the side wall sidewall of the tyre in the tyre designation of the tyre as prescribed; A is the width (expressed in mm) of the measuring rimrim in millimetres, as shown by the manufacturer in the descriptive note, 5 ; and A1 is the width (expressed in mm) of the theoretical rimrim in millimetres. A1 shall be taken to equal S1 multiplied by the factor x, x as specified by the manufacturer, and K shall be taken to equal 0.4."

, amend to read. 6.1.1.1. The section width shall be calculated by the following formula: S = S1 + K (A-A1), whereWhere: S is the "section width" rounded to the nearest millimetre and measured on the measuring rim; S1 is the "nominal section width" (in mm) as shown on the side wall of the tyre in the designation of the tyre as prescribed; A is the width (expressed in mm) of the measuring rim, as shown by the manufacturer in the descriptive note, 5 ; A1 is the width (expressed in mm) of the theoretical rim. ; A1 shall be taken to equal S1 multiplied by the factor x, as X specified by the manufacturer, and ; K shall be taken to equal 0.4."