Test. The outer surface of the lamp lenses shall be subjected once or more than once to the action of the sand jet produced as described above. The jet shall be sprayed almost perpendicular to the surface to be tested. The deterioration shall be checked by means of one or more samples of glass placed as a reference near the lenses to be tested. The mixture shall be sprayed until the variation in the diffusion of light on the sample or samples measured by the method described in Appendix 2, is such that: Δ d = (T5 - T4) / T2 ≤ 0.0250 ± 0.0025 Several reference samples may be used to check that the whole surface to be tested has deteriorated homogeneously.
Test. The test shall be carried out in a dry and still atmosphere at an ambient temperature of 23 °C ± 5 °C.
Test. Medical records and information relating directly thereto will be maintained in strict confidentiality. Any laboratory contract shall provide that the contractor's records are to be kept confidential under provisions of Florida laws. M-DCPS shall establish a system of maintaining records to include both the District's and the contractor's record of applicant and employee urinalysis and blood alcohol results. The contract and the record maintenance system must have specific provisions that require that employee records are maintained and used with the highest regard for employee privacy consistent with Florida's Public Records Act and the purpose of achieving and maintaining a drug-free work place.
Test. The components of the fitness test will include body fat composition, aerobic endurance, muscular strength, and endurance and flexibility assessments. These components will be measured through the following means:
1. Push-ups
2. Sit-ups (modified)
Test procedures—
Test. Is current distribution month [ ], 20[ ], or [ ], 20[ ], or [ ], 20[ ]?
Test. 5.1. Mount the specimen so that both sides and one end are held by the U-shaped frame, and specimen is not more than 51 mm, so that the sides of the specimen cannot be held in the U-shaped frame, place the specimen in position on wire supports as described in 2.3, with one end held by the closed end of the U-shaped frame.
5.2. Place the mounted specimen in a horizontal position, in the center of the cabinet.
5.3. With the flame adjusted according to 2.4, position the bunsen burner and specimen so that the center of the burner tip is 19 mm below the center of the bottom edge of the open end of the specimen.
5.4. Expose the specimen to the flame for 15 seconds.
5.5. Begin timing (without reference to the period of application of the burner flame) when the flame from the burning specimen reaches a point 38 mm from the open end of the specimen.
5.6. Measure the time that it takes the flame to progress to a point 38 mm from the clamped end of the specimen. If the flame does not reach the specified end point, time its progress to the point where flaming stops.
5.7. Calculate the burn rate from the formula: B = 60 x (D/T) Where:
Test. It is the AGENCY’s responsibility to: 1) Determine whether such TB testing is required; (2) to notify CSUMB in writing of this requirement in advance of the student’s placement at the worksite and; (3) obtain results from STUDENT.
Test. As plans for the reformulation of performance measures emerge, HSCRC and the Hospital may agree to alternative savings models, including possible changes to the population and demographic adjustment.6
Test. Except as otherwise set forth in the Issue Price Certificate, the Issuer will determine the issue price of the Bonds based on the first price at which 10% of each maturity of the Bonds is sold to the Public (the “10% Test”) (if different interest rates apply within a maturity, each separate CUSIP number within that maturity will be subject to the 10% Test). The Issue Price Certificate will set forth the maturities, if any, of the Bonds for which the issue price will be the applicable Initial Offering Price because the 10% Test was satisfied as of the Sale Date.
