MEASUREMENT AND VERIFICATION The goal of this task is to report the benefits resulting from this project. Project team may use in- house expertise of the project demonstration site or use third party vendor for measurement and verification (M&V) of GHG and energy consumption reduction. The Recipient shall: • Enter into agreement with M&V subcontractor per Task 1.9 (if using outside vendor) • Coordinate site visits with the M&V subcontractor at the demonstration site(s) • Develop M&V protocol for pre-installation measurement (and calculations) following Section II.B.2 of the grant solicitation manual3: o Electric, natural gas and/or other fossil fuel consumption and greenhouse gas emissions (use appropriate emissions factor from Attachment 8 of the grant solicitation) of the equipment/process/system(s)/sub-system(s) that are be upgraded and/or replaced and/or modified; and o If necessary, ensure installation of sub-metering equipment and data loggers for pre/post data analysis. • Prepare and provide a detailed M&V Plan for each project demonstration site to include but not be limited to: o A description of the monitoring equipment and instrumentation which will be used; o A description of the key input parameters and output metrics which will be measured; o A description of the M&V protocol and analysis methods to be employed; and o A description of the independent, third-party measurement and verification services to be employed, if applicable. • Perform three months (or shorter period as approved in writing by the CAM) of pre- installation measurements (and calculations) based on the M&V protocol for pre- installation. • Prepare and provide a Pre-Installation M&V Findings Report that includes M&V protocol, pre-install measurements (and calculations), analysis, and results performed in this task. • Develop M&V protocol for post-installation measurements (and calculations) of: o Electric, natural gas and/or other fossil fuel consumption and greenhouse gas emissions (use appropriate emissions factor from Attachment 8 of the grant solicitation) of the equipment/process/system(s)/sub-system(s) that will be upgraded and/or replaced and/or modified. Perform 12 months (or shorter period as approved in writing by the CAM) of post- installation measurements based on M&V protocol for post-installation. • Provide a summary of post-installation M&V progress in Progress Report(s) (see subtask 1.5) which shall include but not be limited to: o A narrative on operational highlights from the reporting period, including any stoppages in operation and why; and o A summary of M&V findings from the reporting period. • Analyze post-installation electrical, natural gas and/or other fossil fuel consumption and GHG emissions. 3 GFO-18-903, Food Production Investment Program, California Energy Commission, November 2018. xxxxx://xxx.xxxxxx.xx.xxx/contracts/GFO-18-903/000_FPIP_Solicitation_Manual.docx • Prepare and provide a Post-installation M&V Findings Report that includes M&V protocol, pre and post install measurements (and calculations), analysis, and results performed in this task. Results should at a minimum report on the reduction of electricity, natural gas and/or other fossil fuel usage and reductions of GHG emissions that directly result from this project.
Accord and Satisfaction No payment by Tenant or receipt by Landlord of a lesser amount than the rent herein stipulated to be paid shall be deemed to be other than on account of the earliest stipulated rent, nor shall any endorsement or statement on any check or any letter accompanying any check or payment as rent be deemed an accord and satisfaction, and Landlord may accept such check or payment without prejudice to Landlord’s right to recover the balance of such rent or pursue any other remedy provided herein or by law.
Admission and Graduation Requirements A. The receiving institution’s admission and program admission requirements apply to both direct entry students and to students who transfer under this agreement.
COMPLIANCE AND PERFORMANCE EVALUATION Two (2) Mandatory Compliance and Performance Evaluation Meetings shall be conducted during each Term of this Agreement. Additional meetings may be scheduled at the discretion of Department to ensure Concessionaire’s effectiveness and compliance. The meetings shall review all aspects of the Concession Operation, ensuring that quality public services are being provided on a continuing basis in accordance with the Bid Specifications and this Agreement, that operational problems/concerns are addressed on a timely basis, and that all terms and conditions are clearly understood. The meetings shall be held on site with Department-designated State Park Service staff representative(s), the on-site concession manager, and a management/supervisory representative of Concessionaire’s firm. A report form shall be utilized to document the meeting, and to identify any deficiencies and the corrective action required. A copy of the completed report form shall be provided to the on- site concession manager or the management/supervisory representative of Concessionaire’s firm and shall be attached to and made a part of this Agreement. The Mandatory Compliance and Performance Evaluation Meetings shall be held as follows: • Meeting #1 - Prior to commencement of the Period of Operation or Memorial Day, whichever comes first. • Meeting #2 - Within ten (10) calendar days after the last approved day of the Period of Operation.
Inspections and Testing Each Interconnected Entity shall perform routine inspection and testing of its facilities and equipment in accordance with Good Utility Practice as may be necessary to ensure the continued interconnection of the Customer Facility with the Transmission System in a safe and reliable manner. Each Interconnected Entity shall have the right, upon advance written notice, to request reasonable additional testing of an Interconnected Entity’s facilities for good cause, as may be in accordance with Good Utility Practice.
Interface Requirements 9.3.1 BellSouth shall offer LIDB in accordance with the requirements of this subsection.
Customer Satisfaction 4.1 Services to be provided under Call Off Agreements to the satisfaction of Contracting Bodies 90% Confirmation by the Authority of the Supplier’s performance against customer satisfaction surveys
Inspections and Tests 26.1 The Supplier shall at its own expense and at no cost to the Procuring Entity carry out all such tests and/or inspections of the Goods and Related Services as are specified in the SCC.
Performance Requirements 1. Neither Party may impose or enforce any of the following requirements, or enforce any commitment or undertaking, in connection with the establishment, acquisition, expansion, management, conduct or operation of an investment of an investor of a Party or of a non-Party in its territory:
Procedural and Operational Requirements By accepting and using the Financial Assistance awarded under this Agreement and for this Program Element, LPHA agrees to conduct activities in accordance with the following requirements:
