Argyll and Bute Council Commitment. Community Engagement
Argyll and Bute Council Commitment Sample Clauses
Related to Argyll and Bute Council Commitment
Joint Labor/Management Committees Purpose and Membership. Joint Labor/Management Committees are established to provide a forum for communications and problem-solving between the two parties and to deal with matters of a general personnel Union/Employer concern, as well as professional practices within the hospital related to patient care and professional issues. The Committees will work toward the improvement of patient care and recommend ways and means to improve patient care; and will address problems and concerns related to staffing and workloads. The Committees’ function will be limited to an advisory capacity and shall not include any decision making or collective bargaining authority. Committee memberships:
Project Team Cooperation Partnering 1.1.3 Constitutional Principles Applicable to State Public Works Projects.
Continuing Professional Development The Official Agency shall provide appropriate training for staff performing official controls, enabling them to undertake their duties competently and to carry out official controls in a consistent manner, as per legislative requirements. The Official Agency shall identify training needs for staff performing official controls and ensure that staff carrying out official controls are kept up to date in their area of competence and develop specialised expertise, in partnership with the Authority and other Local Authorities. While the provision of training is the primary responsibility of the Official Agency, the Authority may provide training interventions where the Official Agency has highlighted areas where training is required. The Authority will endeavour to facilitate networking and collaboration with other Official Agencies to assist in improving knowledge in such areas. The Authority will provide e-learning resources and training for official control staff so as to promote a consistent understanding and application of new legislation, guidance or procedures, as appropriate. The Official Agency shall support participants in using e-learning resources, disseminating knowledge or skills acquired and encourage the application of learning gained through the Authority’s training in official control activities. The Official Agency shall ensure that contractors used in the performance of the Service Contract provide evidence of Continuous Professional Development and Compliance with this section. Where staff from the Official Agency need to travel outside the Official Agency functional area to attend training courses/meetings, this shall be facilitated by the Official Agency. The Official Agency in partnership with the Authority shall develop and implement training programmes for all staff engaged in the performance of the Service Contract. Where staff have participated in Better Training for Safer Food (BTSF) the training content shall be disseminated to relevant staff/contractors in the Official Agency and other local authorities in partnership with the Authority.
Recruitment Through Jobcentre Plus 5.1 One of the key objectives of the Department for Work and Pensions is to move people from welfare into work. DWP has a Great Britain-wide network of Jobcentre Plus offices that provide job broking services for unemployed people. The Contractor is therefore required to notify Jobcentre Plus when recruiting staff for any entry-level job vacancies located within Great Britain, which may arise from the delivery of their contract to the Authority.
JOINT LABOR MANAGEMENT COMMITTEE In order to encourage open communication, promote harmonious labor relations, and resolve matters of mutual concern, the parties agree to create a joint labor- management committee. The committee will be governed by the following principles:
Technical Advisory Committee (TAC The goal of this subtask is to create an advisory committee for this Agreement. The TAC should be composed of diverse professionals. The composition will vary depending on interest, availability, and need. TAC members will serve at the CAM’s discretion. The purpose of the TAC is to: • Provide guidance in project direction. The guidance may include scope and methodologies, timing, and coordination with other projects. The guidance may be based on: o Technical area expertise; o Knowledge of market applications; or o Linkages between the agreement work and other past, present, or future projects (both public and private sectors) that TAC members are aware of in a particular area. • Review products and provide recommendations for needed product adjustments, refinements, or enhancements. • Evaluate the tangible benefits of the project to the state of California, and provide recommendations as needed to enhance the benefits. • Provide recommendations regarding information dissemination, market pathways, or commercialization strategies relevant to the project products. The TAC may be composed of qualified professionals spanning the following types of disciplines: • Researchers knowledgeable about the project subject matter; • Members of trades that will apply the results of the project (e.g., designers, engineers, architects, contractors, and trade representatives); • Public interest market transformation implementers; • Product developers relevant to the project; • U.S. Department of Energy research managers, or experts from other federal or state agencies relevant to the project; • Public interest environmental groups; • Utility representatives; • Air district staff; and • Members of relevant technical society committees. The Recipient shall: • Prepare a List of Potential TAC Members that includes the names, companies, physical and electronic addresses, and phone numbers of potential members. The list will be discussed at the Kick-off meeting, and a schedule for recruiting members and holding the first TAC meeting will be developed. • Recruit TAC members. Ensure that each individual understands member obligations and the TAC meeting schedule developed in subtask 1.11. • Prepare a List of TAC Members once all TAC members have committed to serving on the TAC. • Submit Documentation of TAC Member Commitment (such as Letters of Acceptance) from each TAC member. Products: • List of Potential TAC Members • List of TAC Members • Documentation of TAC Member Commitment
JOINT LABOUR MANAGEMENT COMMITTEE 18.01 A Joint Labour Management Committee shall be established to attend to those matters which are of mutual interest. To ensure its effectiveness the Committee shall be separate and apart from the grievance procedure.
Joint Union/Management Committee It shall be appropriate for either the Union or the University to request that a Joint Union/Management committee be convened, with Environmental Health and Safety as a participating member, to discuss health and safety concerns and to explore options for addressing those concerns through appropriate training or other approaches.
Statewide HUB Program Statewide Procurement Division Note: In order for State agencies and institutions of higher education (universities) to be credited for utilizing this business as a HUB, they must award payment under the Certificate/VID Number identified above. Agencies, universities and prime contractors are encouraged to verify the company’s HUB certification prior to issuing a notice of award by accessing the Internet (xxxxx://xxxxx.xxx.xxxxx.xx.xx/tpasscmblsearch/index.jsp) or by contacting the HUB Program at 000-000-0000 or toll-free in Texas at 0-000-000-0000.
Union Negotiating Committee (a) The Employer shall recognize a Union Negotiating Committee that may include, as determined by the Union:
