Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.
Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.
Work Week and Work Day (a) (Applicable to full-time employees only) The normal or standard work week shall be an average of thirty-seven and one-half (37½) hours, with a normal or standard work day of seven and one-half (7½) hours except in those Hospitals where agreements already provide a standard or normal work week of less than thirty-seven and one-half (37½) hours per week and seven and one-half (7½) hours per day. (Those Hospitals with the lesser required hours shall reflect in the salary rates a pro-rata lesser amount compared with salaries for other Hospitals based on the ratio that the standard or normal hours of work at the Hospital concerned are to thirty-seven and one-half (37½) hours and shall appropriately reflect such hours in this Article). The length of time over which the hours of work per week are to be averaged shall be determined locally and shall be set out in the Local Provisions Appendix.
(b) (applicable to part-time employees only) The normal or standard work day shall be seven and one-half (7½) hours per day and the normal or standard full- time work week shall be an average of thirty-seven and one- half (37½) hours per week except in those hospitals where agreements already provide a normal or standard work day of less than seven and one-half hours and a normal or standard full-time work week of less than thirty-seven and one-half (37½) hours. (Those Hospitals with the lesser required hours shall reflect in the salary rates a pro-rata lesser amount compared with salaries for other Hospitals based on the ratio that the standard or normal hours work at the Hospital concerned are to thirty-seven and one-half (37½) hours and shall appropriately reflect such hours in this article.) Part-time employees shall be entitled to overtime pay at the rate of time and one-half their regular straight time hourly rate for all hours worked in excess of the normal or standard work day or in excess of the normal or standard full-time work week. The length of time over which the hours of work per week are to be averaged shall be determined locally and shall be set out in the Local Provisions Appendix.
(c) Where the Hospital and the Union agree, subject to the approval of the Ministry of Labour, other arrangements regarding hours of work may be entered into between parties on a local level with respect to tours beyond the normal or standard work day in accordance with the provisions set out in Article 25.01 of the collective agreement.
Standard Work Week The standard work week for full-time employees covered by this Agreement shall be forty (40) hours, exclusive of the time allotted for meal periods, consisting of five (5) consecutive work days followed by two (2) consecutive days off. The week shall commence with the shift that includes 12:01 A.M. Sunday of each calendar week and end at the start of the shift that includes 12:00 midnight the following Saturday. The Employer retains the right to modify the work schedules to meet operational needs.
Subscriber’s Compliance Nothing in this Section 4 shall affect in any way Subscriber’s obligations and agreements to comply with all applicable securities laws upon resale of the Securities.
Closing Location The Closing shall be held at the location designated by the Corporation or, if no such designation is made, at the office of Seller's Attorney.
Equipment Testing and Inspection 2.1.1 The Interconnection Customer shall test and inspect its Small Generating Facility and Interconnection Facilities prior to interconnection. The Interconnection Customer shall notify the NYISO and the Connecting Transmission Owner of such activities no fewer than five Business Days (or as may be agreed to by the Parties) prior to such testing and inspection. Testing and inspection shall occur on a Business Day. The Connecting Transmission Owner may, at its own expense, send qualified personnel to the Small Generating Facility site to inspect the interconnection and observe the testing. The Interconnection Customer shall provide the NYISO and Connecting Transmission Owner a written test report when such testing and inspection is completed. The Small Generating Facility may not commence parallel operations if the NYISO, in consultation with the Connecting Transmission Owner, finds that the Small Generating Facility has not been installed as agreed upon or may not be operated in a safe and reliable manner.
2.1.2 The NYISO and Connecting Transmission Owner shall each provide the Interconnection Customer written acknowledgment that it has received the Interconnection Customer’s written test report. Such written acknowledgment shall not be deemed to be or construed as any representation, assurance, guarantee, or warranty by the NYISO or Connecting Transmission Owner of the safety, durability, suitability, or reliability of the Small Generating Facility or any associated control, protective, and safety devices owned or controlled by the Interconnection Customer or the quality of power produced by the Small Generating Facility.
Work Location While employed by the Company hereunder, the Executive shall perform his duties (when not traveling or engaged elsewhere in the performance of his duties) at the offices of the Company in Bermuda. The Executive shall travel to such places on the business of the Company in such manner and on such occasions as the Company may from time to time reasonably require.
Standard Operating Procedures Standard Operating Procedures shall not contravene the Canada Labour Code, the Canadian Human Rights Code, or the Collective Agreement, and an allegation of such contravention is subject to the grievance procedure.
Data Location 1.1. The CONTRACTOR shall not store or transfer non-public COUNTY data outside of the United States. This includes backup data and Disaster Recovery locations. The CONTRACTOR will permit its personnel and contractors to access COUNTY data remotely only as required to provide technical support. (Remote access to data from outside the continental United States is prohibited unless approved in advance and in writing by the County.)
1.2. The CONTRACTOR must notify the COUNTY in advance and in writing of any location changes to CONTRACTOR’s data center(s) that will process or store County data.
