BID DECLARATION Sample Clauses

BID DECLARATION. 6.1 Bidders who claim points in respect of B-BBEE Status Level of Contribution must complete the following:
AutoNDA by SimpleDocs
BID DECLARATION. 6.1 Bidders who claim points in respect of B-BBEE Status Level of Contribution must complete the following: 7.1 B-BBEE Status Level of Contribution: = (maximum of 10 or 20 points) (Points claimed in respect of paragraph 7.1 must be in accordance with the table reflected in paragraph 5.1 and must be substantiated by means of a B-BBEE certificate issued by a Verification Agency accredited by SANAS or a Registered Auditor approved by IRBA or a sworn affidavit.
BID DECLARATION. 6.1 Bidders who claim points in respect of B-BBEE Status Level of Contribution must complete the following: 7.1 B-BBEE Status Level of Contribution: …………. = (maximum of 10 or 20 points)
BID DECLARATION. 7.1 Bidders who claim points in respect of equity ownership must complete the Bid Declaration at the end of this form.
BID DECLARATION. Bidders who wish to claim points in respect of this specific goal must complete the declaration part of this form.
BID DECLARATION. The terms and conditions given in the Bid Document are read, understood and hereby accepted unconditionally and shall be complied with. I/We agree to abide by the condition and guidelines of the Tender Document and shall form part of Contract conditions and provisions.

Related to BID DECLARATION

  • Development Agreement As soon as reasonably practicable following the ISO’s selection of a transmission Generator Deactivation Solution, the ISO shall tender to the Developer that proposed the selected transmission Generator Deactivation Solution a draft Development Agreement, with draft appendices completed by the ISO to the extent practicable, for review and completion by the Developer. The draft Development Agreement shall be in the form of the ISO’s Commission-approved Development Agreement for its reliability planning process, which is in Appendix C in Section 31.7 of Attachment Y of the ISO OATT, as amended by the ISO to reflect the Generator Deactivation Process. The ISO and the Developer shall finalize the Development Agreement and appendices as soon as reasonably practicable after the ISO’s tendering of the draft Development Agreement. For purposes of finalizing the Development Agreement, the ISO and Developer shall develop the description and dates for the milestones necessary to develop and construct the selected project by the required in-service date identified in the Generator Deactivation Assessment, including the milestones for obtaining all necessary authorizations. Any milestone that requires action by a Connecting Transmission Owner or Affected System Operator identified pursuant to Attachment P of the ISO OATT to complete must be included as an Advisory Milestone, as that term is defined in the Development Agreement. If the ISO or the Developer determines that negotiations are at an impasse, the ISO may file the Development Agreement in unexecuted form with the Commission on its own, or following the Developer’s request in writing that the agreement be filed unexecuted. If the Development Agreement is executed by both parties, the ISO shall file the agreement with the Commission for its acceptance within ten (10) Business Days after the execution of the Development Agreement by both parties. If the Developer requests that the Development Agreement be filed unexecuted, the ISO shall file the agreement at the Commission within ten (10) Business Days of receipt of the request from the Developer. The ISO will draft, to the extent practicable, the portions of the Development Agreement and appendices that are in dispute and will provide an explanation to the Commission of any matters as to which the parties disagree. The Developer will provide in a separate filing any comments that it has on the unexecuted agreement, including any alternative positions it may have with respect to the disputed provisions. Upon the ISO’s and the Developer’s execution of the Development Agreement or the ISO’s filing of an unexecuted Development Agreement with the Commission, the ISO and the Developer shall perform their respective obligations in accordance with the terms of the Development Agreement that are not in dispute, subject to modification by the Commission. The Connecting Transmission Owner(s) and Affected System Operator(s) that are identified in Attachment P of the ISO OATT in connection with the selected transmission Generator Deactivation Solution shall act in good faith in timely performing their obligations that are required for the Developer to satisfy its obligations under the Development Agreement.

  • Operating Agreement The Borrower will not amend, modify, waive or terminate any provision of its operating agreement without the prior written consent of the Administrative Agent.

  • Vendor Encouraging Members to bypass TIPS agreement Encouraging entities to purchase directly from the Vendor or through another agreement, when the Member has requested using the TIPS cooperative Agreement or price, and thereby bypassing the TIPS Agreement is a violation of the terms and conditions of this Agreement and will result in removal of the Vendor from the TIPS Program.

  • No Physical Presence of Quorum and Participation by Audio or Video; Disaster Declaration The ability of the Board to meet in person with a quorum physically present at its meeting location may be affected by the Governor or the Director of the Ill. Dept. of Public Health issuing a disaster declaration related to a public health emergency. The Board President or, if the office is vacant or the President is absent or unable to perform the office’s duties, the Vice President determines that an in- person meeting or a meeting conducted under the Quorum and Participation by Audio or Video Means subhead above, is not practical or prudent because of the disaster declaration; if neither the President nor Vice President are present or able to perform this determination, the Superintendent shall serve as the duly authorized designee for purposes of making this determination. The individual who makes this determination for the Board shall put it in writing, include it on the Board’s published notice and agenda for the audio or video meeting and in the meeting minutes, and ensure that the Board meets every OMA requirement for the Board to meet by video or audio conference without the physical presence of a quorum.

  • Special Record Dates The Company may, but is not required to, fix a record date for the purpose of determining the Holders entitled to consent or take any other action in connection with any amendment, supplement or waiver pursuant to this Article 8. If a record date is fixed, then, notwithstanding anything to the contrary in Section 8.04(A), only Persons who are Holders as of such record date (or their duly designated proxies) will be entitled to give such consent, to revoke any consent previously given or to take any such action, regardless of whether such Persons continue to be Holders after such record date; provided, however, that no such consent will be valid or effective for more than one hundred and twenty (120) calendar days after such record date.

  • Interconnection Agreement Seller shall comply with the terms and conditions of the Interconnection Agreement.

  • Special Resolution Regimes In the event that any Underwriter that is a Covered Entity becomes subject to a proceeding under a U.S. Special Resolution Regime, the transfer from such Underwriter of this Agreement, and any interest and obligation in or under this Agreement, will be effective to the same extent as the transfer would be effective under the U.S. Special Resolution Regime if this Agreement, and any such interest and obligation, were governed by the laws of the United States or a state of the United States.

  • Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from BellSouth’s Main Distribution Frame to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (“DAMLs”), and may have up to 6,000 feet of bridged tap between the end user’s premises and the serving wire center. The UCL-ND typically will be 1300 Ohms resistance and in most cases will not exceed 18,000 feet in length, although the UCL-ND will not have a specific length limitation. For loops less than 18,000 feet and with less than 1300 Ohms resistance, the loop will provide a voice grade transmission channel suitable for loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point. 2.4.3.2 The UCL-ND facilities may be mechanically assigned using BellSouth’s assignment systems. Therefore, the Loop Make Up process is not required to order and provision the UCL-ND. However, Lightyear can request Loop Make Up for which additional charges would apply. 2.4.3.3 At an additional charge, BellSouth also will make available Loop Testing so that Lightyear may request further testing on the UCL-ND. Rates for Loop Testing are as set forth in Exhibit B of this Attachment. 2.4.3.4 UCL-ND loops are not intended to support any particular service and may be utilized by Lightyear to provide a wide-range of telecommunications services so long as those services do not adversely affect BellSouth’s network. The UCL-ND will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the loop to the customer’s inside wire. 2.4.3.5 Order Coordination (OC) will be provided as a chargeable option and may be utilized when the UCL-ND provisioning is associated with the reuse of BellSouth facilities. Order Coordination -Time Specific (OC-TS) does not apply to this product. 2.4.3.6 Lightyear may use BellSouth’s Unbundled Loop Modification (ULM) offering to remove bridge tap and/or load coils from any loop within the BellSouth network. Therefore, some loops that would not qualify as UCL-ND could be transformed into loops that do qualify, using the ULM process.

  • Major Decisions (A) Subject to Sections 7.3(C) and 7.3(D) with respect to the Company, all major decisions of the Company set forth below in clauses (A)(1) through (A)(6) (“Major Decisions”) shall be subject to the Company’s Articles of Incorporation and joint approval by the Advisor and Sub-advisor. For the avoidance of doubt, Major Decisions specifically exclude any decisions regarding the day-to-day operations of the Company, the decision-making authority for which has been delegated to the Sub-advisor pursuant to this Agreement. Major Decisions shall consist of the following: (1) Decisions to recommend to the Board of Directors that the Company acquire or sell Properties, Loans and other Permitted Investments; (2) Retention of investment banks for the Company; (3) Marketing methods for the Company’s sale of Shares; (4) Extending, initiating or terminating the Initial Public Offering or any subsequent Offering of the Shares; (5) Issuing press releases involving the major decisions of the Company or the Advisor or Sub-advisor or their Affiliates with respect to the business or operations of the Company; provided, that the Sub-advisor need not obtain consent to any press releases regarding acquisitions or dispositions of Properties, Loans or other Permitted Investments; and provided further, however, that notwithstanding the immediately preceding proviso, any mention of the Advisor or its Affiliates in such press releases regarding acquisitions or dispositions shall be pre-approved by the Advisor; and (6) Merging or otherwise engaging in any change of control transaction for the Company. (B) Notwithstanding anything in this Agreement to the contrary, if the Parties do not agree to any action constituting a Major Decision that is described in any of clauses (A)(2) through (A)(6) above and that has been proposed by either Party, the Parties shall meet (in person or by phone) to discuss the issue in dispute in good faith over the five-business day period beginning with the delivery of notice of the proposed action to the other Party. (C) Notwithstanding anything in this Agreement to the contrary, with respect to Major Decisions described in clause (A)(1) above (but subject to Section 7.3(D)), (1) joint approval shall not be required, (2) the Sub-advisor and the Advisor shall discuss the proposed transaction (either in person or by phone) prior to either Party making any recommendation of the proposed transaction to the Board of Directors, and (3) the Sub-Advisor and the Advisor shall each give due consideration to the opinions of the other Party. Ordinarily, such discussions shall begin at least five business days before a recommendation is made to the Board of Directors; however, if in the sole discretion of the Sub-advisor it is in the best interest of the Company to make a recommendation to the Board of Directors more promptly, then the Sub-advisor may do so. In the event the Parties do not agree as to whether to recommend the proposed transaction to the Board of Directors, the Sub-advisor’s decision shall govern. (D) Notwithstanding the provisions of this Section 7.3 or any other provision in this Agreement to the contrary, in all events, including Major Decisions, the Company will be managed under the direction of the Board of Directors. (E) Notwithstanding anything in this Agreement to the contrary (but subject to Section 7.3(D)), the Sub-advisor shall have sole authority to act on behalf of the Company regarding amending the Advisory Agreement.

  • Membership Agreement Membership in USA Gymnastics is a privilege and may be (i) denied, withheld, or non-renewed at any time by USA Gymnastics and/or (ii) suspended or terminated in accordance with USA Gymnastics’ bylaws, policies and standards. You agree that USA Gymnastics has the right to deny, withhold, non-renew, suspend or terminate your membership if you engage in any sexual misconduct, or if USA Gymnastics has reason to believe you pose a threat to the safety of athletes or other members. You have read, understand and agree to be bound by this Agreement, the USA Gymnastics bylaws, Safe Sport Policy, SafeSport Investigation & Resolution Procedures, and Code of Ethical Conduct. You are bound by all safe sport rules, policies and procedures whether published by USA Gymnastics or the U.S. Center for Safe Sport (“Center”), as well as all applicable state, federal, and local laws, including applicable criminal laws. You consent to the jurisdiction of the Center. Any discipline imposed by the Center or USA Gymnastics extends to your participation in all aspects of the Olympic Movement. You agree that any disciplinary measure, whether interim or final, whether imposed before or after the date of this Agreement, whether expired or in effect, may be posted on our website or otherwise publicly published and may include information identifying you and describing the misconduct alleged. You authorize USA Gymnastics and its members to disclose, in good faith, any information or honestly held opinions about you, including without limitation any membership records, USA Gymnastics SafeSport or Center information, or other disciplinary information, with any current or potential employer of yours. You further agree that USA Gymnastics may disclose any information provided by, or about, you as USA Gymnastics determines is reasonably necessary to comply with any law, regulation, legal process, or any request by any governmental body or agency, the Center, or the United States Olympic and Paralympic Committee (“USOPC”). TO THE MAXIMUM EXTENT ALLOWED BY LAW, YOU FOREVER RELEASE AND DISCHARGE USA GYMNASTICS AND/OR ITS MEMBERS FROM ANY AND ALL LOSS, LIABILITY, DAMAGE OR CLAIM OF ANY KIND OR NATURE, WHETHER KNOWN OR UNKNOWN, WHETHER IN LAW OR IN EQUITY, WHETHER NOW EXISTING OR ACCRUING IN THE FUTURE, ARISING OUT OF OR IN CONNECTION WITH ANY INFORMATION OR OPINIONS DISCLOSED IN ACCORDANCE WITH THIS SECTION.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!