Tool Replacement Personal tools worn out and/or broken on the job will be replaced on a like- for-like basis by the Employer, provided the tool is turned in to the Employer and the Employer had knowledge the tool was being used on the job. If an employee has his/her tools stolen from a state vehicle, the Employer will replace those tools, as long as no employee negligence has occurred.
State Approval of Replacement Personnel The Engineer may not replace the project manager or key personnel without prior consent of the State. The State must be satisfied that the new project manager or other key personnel is qualified to provide the authorized services. If the State determines that the new project manager or key personnel is not acceptable, the Engineer may not use that person in that capacity and shall replace him or her with one satisfactory to the State within forty-five (45) days.
Removal or Replacement of a Manager Any Manager may be removed or replaced without “Cause” at any time by a majority of the Board and each Manager may be removed and or replaced and our Board can be reconstituted for any reason by the Class C Member, if any.
Removal or Replacement of a Lender Anything contained herein to the contrary notwithstanding, in the event that: (a) (i) any Lender (an “Increased Cost Lender”) shall give notice to Borrower that such Lender is an Affected Lender or that such Lender is entitled to receive payments under Section 2.18, 2.19 or 2.20, (ii) the circumstances which have caused such Lender to be an Affected Lender or which entitle such Lender to receive such payments shall remain in effect, and (iii) such Lender shall fail to withdraw such notice within five Business Days after Borrower’s request for such withdrawal; or (b) (i) any Lender shall become a Defaulting Lender, (ii) the Default Period for such Defaulting Lender shall remain in effect, and (iii) such Defaulting Lender shall fail to cure the default as a result of which it has become a Defaulting Lender within five Business Days after Borrower’s request that it cure such default; or (c) in connection with any proposed amendment, modification, termination, waiver or consent with respect to any of the provisions hereof as contemplated by Section 10.5(b), the consent of Requisite Lenders shall have been obtained but the consent of one or more of such other Lenders (each a “Non-Consenting Lender”) whose consent is required shall not have been obtained; then, with respect to each such Increased Cost Lender, Defaulting Lender or Non-Consenting Lender (the “Terminated Lender”), Borrower may, by giving written notice to Administrative Agent and any Terminated Lender of its election to do so, elect to cause such Terminated Lender (and such Terminated Lender hereby irrevocably agrees) to assign its outstanding Loans and its Revolving Commitments, if any, in full to one or more Eligible Assignees (each a “Replacement Lender”) in accordance with the provisions of Section 10.6 and Borrower shall pay the fees, if any, payable thereunder in connection with any such assignment from an Increased Cost Lender, a Non-Consenting Lender or Insolvency Defaulting Lender, and the Funds Defaulting Lender (if not also an Insolvency Defaulting Lender) shall pay the fees, if any, payable thereunder in connection with any such assignment from such Defaulting Lender; provided, (1) on the date of such assignment, the Replacement Lender shall pay to Terminated Lender an amount equal to the sum of (A) an amount equal to the principal of, and all accrued interest on, all outstanding Loans of the Terminated Lender, (B) an amount equal to all unreimbursed drawings that have been funded by such Terminated Lender, together with all then unpaid interest with respect thereto at such time and (C) an amount equal to all accrued, but theretofore unpaid fees owing to such Terminated Lender pursuant to Section 2.11; (2) on the date of such assignment, Borrower shall pay any amounts payable to such Terminated Lender pursuant to Section 2.18(c), 2.19 or 2.20; or otherwise as if it were a prepayment; (3) in the case of any assignment resulting from a claim for compensation under Section 2.19 or payments required to be made under Section 2.20, such assignment will result in a reduction in such compensation or payment and (4) in the event such Terminated Lender is a Non-Consenting Lender, each Replacement Lender shall consent, at the time of such assignment, to each matter in respect of which such Terminated Lender was a Non-Consenting Lender; provided that Borrower may not make such election with respect to any Terminated Lender that is also an Issuing Bank unless, prior to the effectiveness of such election, Borrower shall have caused each outstanding Letter of Credit issued thereby to be cancelled. Upon the prepayment of all amounts owing to any Terminated Lender and the termination of such Terminated Lender’s Revolving Commitments, if any, such Terminated Lender shall no longer constitute a “Lender” for purposes hereof; provided that any rights of such Terminated Lender to indemnification hereunder shall survive as to such Terminated Lender. Each Lender agrees that if Borrower exercises its option hereunder to cause an assignment by such Lender as a Terminated Lender, such Lender shall, promptly after receipt of written notice of such election, execute and deliver all documentation necessary to effectuate such assignment in accordance with Section 10.6. In the event that a Terminated Lender does not comply with the requirements of the immediately preceding sentence within one Business Day after receipt of such notice, each Lender hereby authorizes and directs the Administrative Agent to execute and deliver such documentation as may be required to give effect to an assignment in accordance with Section 10.6 on behalf of such Terminated Lender and any such documentation so executed by the Administrative Agent shall be effective for purposes of documenting an assignment pursuant to Section 10.6.
Emergency Replacement SAP may replace a Subprocessor without advance notice where the reason for the change is outside of SAP’s reasonable control and prompt replacement is required for security or other urgent reasons. In this case, SAP will inform Customer of the replacement Subprocessor as soon as possible following its appointment. Section 6.3 applies accordingly.
Removal of Equipment Subject, always, to the other terms and provisions of this Fee Agreement, the Company and any Sponsor Affiliates shall be entitled to remove and dispose of components of the Project from the Project in its sole discretion with the result that said components shall no longer be considered a part of the Project and, to the extent such constitute Economic Development Property, shall no longer be subject to the terms of this Fee Agreement. Economic Development Property is disposed of only when it is scrapped or sold or removed from the Project. If it is removed from the Project, it is subject to ad valorem property taxes to the extent the Property remains in the State and is otherwise subject to ad valorem property taxes.
Life support equipment (a) If a person living or intending to live at your premises requires life support equipment, you must: (i) register the premises with your retailer or with us; and (ii) provide medical confirmation for the premises. (b) Subject to satisfying the requirements in the Rules, your premises may cease to be registered as having life support equipment if medical confirmation is not provided to us or your retailer.
Equipment Procurement If responsibility for construction of the Connecting Transmission Owner’s Attachment Facilities or System Upgrade Facilities or System Deliverability Upgrades is to be borne by the Connecting Transmission Owner, then the Connecting Transmission Owner shall commence design of the Connecting Transmission Owner’s Attachment Facilities or System Upgrade Facilities or System Deliverability Upgrades and procure necessary equipment as soon as practicable after all of the following conditions are satisfied, unless the Developer and Connecting Transmission Owner otherwise agree in writing: 5.5.1 NYISO and Connecting Transmission Owner have completed the Interconnection Facilities Study pursuant to the Interconnection Facilities Study Agreement; 5.5.2 The NYISO has completed the required cost allocation analyses, and Developer has accepted his share of the costs for necessary System Upgrade Facilities and System Deliverability Upgrades in accordance with the provisions of Attachment S of the NYISO OATT; 5.5.3 The Connecting Transmission Owner has received written authorization to proceed with design and procurement from the Developer by the date specified in Appendix B hereto; and 5.5.4 The Developer has provided security to the Connecting Transmission Owner in accordance with Article 11.5 by the dates specified in Appendix B hereto.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.
Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.