CENTER OF GRAVITY Sample Clauses

CENTER OF GRAVITY. When the center of gravity is marked on a piece of machinery or crate, Seller shall load the flatrack, container, or truck according to these marks. If the Buyer instructs Seller to load otherwise, it shall be in writing. In the event that the marking or verbal instructions are incorrect, Seller shall not be responsible for fines by the department of transportation or rejection at the port or in the event that a load is tipped over during the transportation of the load. When the center of gravity is not marked on the machinery or crate, Seller shall determine or estimate the physical center of the machine or crate.
Sample 1Sample 2
AutoNDA by SimpleDocs
CENTER OF GRAVITY. The apparatus must meet the vehicle stability of the applicable NFPA Automotive Fire Apparatus Standard. A calculated center of gravity must be provided. The calculated or measured center of gravity (CG) must be no higher that 80-percent of the rear axle track width.
Sample 1
CENTER OF GRAVITY. The Instrument shall meet the requirements of the WV-3 Instrument to Spacecraft ICD.
Sample 1
CENTER OF GRAVITY. (1) All helicopters shall be configured so that the center of gravity will remain within the FAA approved Flight Manual published limits for all load requirements and full range of fuel conditions, including ferry with minimum crew without subtraction or addition of ballast. (2) All helicopters shall be loaded such that the center of gravity will remain within allowed limit during the flight. Actual weights will be used for flight calculation. (3) When the equipped weight of the helicopter, as noted by registration number in Section B, Schedule of Items changes, the Contractor shall notify the CO of the change and submit a new weight and balance as required by the Agreement.
Sample 1
CENTER OF GRAVITY. Lift Fixture for mounting to Turbine for removal or Install.
Sample 1

Related to CENTER OF GRAVITY

  • Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.

  • Usage Measurement Usage measurement for calls shall begin when answer supervision or equivalent Signaling System 7 (SS7) message is received from the terminating office and shall end at the time of call disconnect by the calling or called subscriber, whichever occurs first.

  • The FTPS Unit Servicing Agent shall transmit to each FTPS Unit holder of record any notice or other communication received from the Trustee and shall be solely responsible for soliciting and transmitting to the Trustee any notice required from FTPS Unit holders.

  • Measurement Should the State terminate this contract as herein provided, no fees other than fees due and payable at the time of termination shall thereafter be paid to the Engineer. In determining the value of the work performed by the Engineer prior to termination, the State shall be the sole judge. Compensation for work at termination will be based on a percentage of the work completed at that time. Should the State terminate this contract under paragraph (4) or (5) above, the Engineer shall not incur costs during the thirty-day notice period in excess of the amount incurred during the preceding thirty days.

  • Temperature Measurement Temperature will be measured by the nearest automatic Melbourne Bureau of Meteorology Monitoring Station for example (but not limited to): Melbourne, Moorabbin, Dunns Hill, Melbourne Airport, Frankston, and Point Xxxxxx. At the commencement of each project, the onsite management and employee representatives shall agree which is to be the applicable automatic weather monitoring station.

  • System for Award Management (XXX) Requirement Alongside a signed copy of this Agreement, Grantee will provide Florida Housing with a XXX.xxx proof of registration and Commercial and Government Entity (CAGE) number. Grantee will continue to maintain an active XXX registration with current information at all times during which it has an active award under this Agreement.

  • Use of Basement and Service Areas The basement(s) and service areas, if any, as located within the

  • Benchmarks for Measuring Accessibility For the purposes of this Agreement, the accessibility of online content and functionality will be measured according to the W3C’s Web Content Accessibility Guidelines (WCAG) 2.0 Level AA and the Web Accessibility Initiative Accessible Rich Internet Applications Suite (WAI-ARIA) 1.0 for web content, which are incorporated by reference.

  • Regional Value Content 1. Subject to Paragraphs 2 to 4 of this Article and Article 404, where Annex 4.1 requires goods to have a regional value content, the regional value content of particular goods shall be calculated as follows: x 100 where:

  • Mail Order Catalog Warnings In the event that, the Settling Entity prints new catalogs and sells units of the Products via mail order through such catalogs to California consumers or through its customers, the Settling Entity shall provide a warning for each unit of such Product both on the label in accordance with subsection 2.4 above, and in the catalog in a manner that clearly associates the warning with the specific Product being purchased. Any warning provided in a mail order catalog shall be in the same type size or larger than other consumer information conveyed for such Product within the catalog and shall be located on the same display page of the item. The catalog warning may use the Short-Form Warning content described in subsection 2.3(b) if the language provided on the Product label also uses the Short-Form Warning.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!