Right of Way and Real Property The party named in Article 1, Responsible Parties, under AGREEMENT is responsible for the provision and acquisition of any needed right of way or real property. The Local Government shall be responsible for the following:
GEOGRAPHIC AREA AND SECTOR SPECIFIC ALLOWANCES, CONDITIONS AND EXCEPTIONS The following allowances and conditions shall apply where relevant: Where the company does work which falls under the following headings, the company agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
Prohibition Against Selecting and Installing Products Containing Hazardous Materials The Contractor shall not select, install or otherwise incorporate any products or materials containing Hazardous Materials within the boundaries of the Site. Should the Contractor or any Subcontractors have knowledge that, or believe that, an item, component, material, substance, or accessory within a product or assembly selected by the Contractor or any Subcontractor may contain Hazardous Materials it is the Contractor’s responsibility to secure a written certification from the manufacturer of any suspected material which identifies the specific Hazardous Material(s) contained, together with the Material Safety Data Sheets (MSDS) for such materials which shall be submitted to the Owner and Design Professional.
Occupational First Aid Requirements and Courses (a) The Union and the Employer agree that First Aid Regulations made pursuant to the Workers' Compensation Act shall be fully complied with.
Obligation to Notify Owner of Existing Hazardous Materials The Contractor shall immediately notify the Owner and the Design Professional, both orally and in writing, of the presence and location of any physical evidence of, or information regarding the presence of Hazardous Materials at the Site of which it becomes aware. If the Contractor encounters Hazardous Materials on the Site the Contractor shall (i) immediately stop performance of Work or that portion of the Work affected by or affecting such Hazardous Materials; (ii) secure the contaminated area against intrusion; (iii) not disturb or remove the Hazardous Materials; (iv) not proceed, or allow any subcontractor or supplier to proceed, with any Work or other activities in the area affected by such Hazardous Materials until such materials have been properly remediated and until directed in writing to do so by the Owner; and, (v) take any other steps necessary to protect life and health and the surrounding environment. The Contractor shall be entitled to adjustment of the Contract Time and the Contract Sum pursuant to Section 5, Part 2 of these General Conditions in order to compensate for the impact of any required demolition, re-work, shutdown, delay, protection of work, disruption, and start-up resulting from the encountering of such Hazardous Materials on the Site for which the Contractor is not responsible.
Funding Restrictions and Order Quantities The Agency reserves the right to reduce or increase estimated or actual quantities in whatever amount necessary without prejudice or liability to the Agency, if:
Visitors to and Conduct on School Property Petitions or written correspondence to the Board shall be presented to the Board in the next regular Board packet. LEGAL REF.: 5 ILCS 120/2.06, Open Meetings Act. 105 ILCS 5/10-6 and 5/10-16. CROSS REF.: 2:220 (School Board Meeting Procedure), 8:10 (Connection with the Community), 8:30 (Visitors to and Conduct on School Property) Adopted: September 5, 2019 Meridian CUSD 223 2:240 Board Policy Development The School Board governs using written policies. Written policies ensure legal compliance, establish Board processes, articulate District ends, delegate authority, and define operating limits. Board policies also provide the basis for monitoring progress toward District ends. Policy Development Anyone may propose new policies, changes to existing policies, or elimination of existing policies. Staff suggestions should be processed through the Superintendent. Suggestions from all others should be made to the Board President or the Superintendent. A Board Policy Committee will consider all policy suggestions, and provide information and recommendations to the Board. The Superintendent is responsible for: (1) providing relevant policy information and data to the Board,
Musculoskeletal Injury Prevention and Control (a) The Hospital in consultation with the Joint Health and Safety Committee (JHSC) shall develop, establish and put into effect, musculoskeletal prevention and control measures, procedures, practices and training for the health and safety of employees.
Certain Notifications Until Closing From the Signing Date until the Closing, the Company shall promptly notify the Investor of (i) any fact, event or circumstance of which it is aware and which would reasonably be expected to cause any representation or warranty of the Company contained in this Agreement to be untrue or inaccurate in any material respect or to cause any covenant or agreement of the Company contained in this Agreement not to be complied with or satisfied in any material respect and (ii) except as Previously Disclosed, any fact, circumstance, event, change, occurrence, condition or development of which the Company is aware and which, individually or in the aggregate, has had or would reasonably be expected to have a Company Material Adverse Effect; provided, however, that delivery of any notice pursuant to this Section 3.4 shall not limit or affect any rights of or remedies available to the Investor; provided, further, that a failure to comply with this Section 3.4 shall not constitute a breach of this Agreement or the failure of any condition set forth in Section 1.2 to be satisfied unless the underlying Company Material Adverse Effect or material breach would independently result in the failure of a condition set forth in Section 1.2 to be satisfied.
Specific Order Processes and Requirements 1. Distributor will order Software from SAP using and filling out completely such forms and minimum order requirements as SAP may prescribe from time to time and must comply with any then-current order process for the specific Software product. Where applicable, Distributor agrees to use the electronic means provided by SAP for placing orders.