School Official Designation Pursuant to Article I, Paragraph 1 of the DPA Standard Clauses, and in accordance with FERPA, ISSRA and SOPPA, in performing its obligations under the DPA, the Provider is acting as a school official with legitimate educational interest; is performing an institutional service or function for which the LEA would otherwise use its own employees; is under the direct control of the LEA with respect to the use and maintenance of Student Data; and is using Student Data only for an authorized purpose and in furtherance of such legitimate educational interest.
WITNESS my hand and official seal Signature of Notary (Affix seal in the above blank space) ================================================================================ EXHIBIT S-2 FORM OF POWER OF ATTORNEY FOR SPECIAL SERVICER RECORDING REQUESTED BY: GMAC COMMERCIAL MORTGAGE CORPORATION AND WHEN RECORDED MAIL TO: GMAC COMMERCIAL MORTGAGE CORPORATION 000 Xxxxxxxxxx Xxxxxx, 00xx Xxxxx Xxx Xxxxxxxxx, XX 00000 Attention: Commercial Mortgage Pass- Through Certificates Series 2005-HQ5 Space above this line for Recorder's use -------------------------------------------------------------------------------- LIMITED POWER OF ATTORNEY (SPECIAL) KNOW ALL MEN BY THESE PRESENTS, that XXXXX FARGO BANK, N.A., as trustee for Xxxxxx Xxxxxxx Capital I Inc., Commercial Mortgage Pass-Through Certificates, Series 2005-HQ5 ("Trustee"), under that certain Pooling and Servicing Agreement dated as of March 1, 2005 (the "Pooling and Servicing Agreement"), does hereby nominate, constitute and appoint GMAC COMMERCIAL MORTGAGE CORPORATION, as Special Servicer under the Pooling and Servicing Agreement ("GMAC"), as its true and lawful attorney-in-fact for it and in its name, place, stead and for its use and benefit: To perform any and all acts which may be necessary or appropriate to enable GMAC to service and administer the Mortgage Loans (as defined in the Pooling and Servicing Agreement) in connection with the performance by GMAC of its duties as Special Servicer under the Pooling and Servicing Agreement, giving and granting unto GMAC full power and authority to do and perform any and every act necessary, requisite, or proper in connection with the foregoing and hereby ratifying, approving or confirming all that GMAC shall lawfully do or cause to be done by virtue hereof.
COMMISSIONER OR AUTHORIZED USER Contractor warrants, covenants and represents that any confidential information obtained by Contractor, its agents, Subcontractors, officers, distributors, resellers or employees in the course of performing its obligations, including without limitation, security procedures, business operations information, or commercial proprietary information in the possession of the State or any Authorized User hereunder or received from another third party, will not be divulged to any third parties without the written consent of the Commissioner or Authorized User. Contractor shall not be required to keep confidential any such material that is publicly available through no fault of Contractor, independently developed by Contractor without reliance on confidential information of the Authorized User, or otherwise obtained under the Freedom of Information Law or other applicable New York State laws and regulations. This warranty shall survive termination of this Contract. Contractor further agrees to take commercially reasonable steps as to its agents, Subcontractors, officers, distributors, resellers or employees regarding the obligations arising under this clause to insure such confidentiality.
Application Submission Submissions of a rental application does not guarantee approval or acceptance. It does not bind us to accept the application or to sign a Lease contact.
Official Representatives 18. The Association may select as many as five (5) members of the Association to attend during regular duty or work hours without loss of compensation, meetings scheduled with the Civil Service Commission, the Department of Human Resources, the Director of Employee Relations, or designee, when such meetings have been scheduled for the purpose of meeting and conferring on matters within the scope of representation affecting such appropriate unit, and to participate in the discussions, deliberations, and decisions at such meetings. 19. Release time shall be provided for MEA representatives to participate in disciplinary meetings, grievance meetings, meet and confer sessions and other labor relations matters with the City. Release time shall not be withheld unreasonably. 20. In scheduling meetings, reasonable consideration shall be given to the operating needs and work schedules of the particular employee's and representatives' department(s). 21. No representative may leave the duty or work station without specific approval of his supervisor. 22. Representatives shall be responsible for the performance of their work load consistent with release time approved pursuant to rules established herein.
BID SUBMISSION All Bids are to be packaged, sealed and submitted to the location stated in the Bid Specifications. Bidders are solely responsible for timely delivery of their Bids to the location set forth in the Bid Specifications prior to the stated Bid opening date/time. A Bid return envelope, if provided with the Bid Specifications, should be used with the Bid sealed inside. If the Bid response does not fit into the envelope, the Bid envelope should be attached to the outside of the sealed box or package with the Bid inside. If using a commercial delivery company that requires use of their shipping package or envelope, Bidder’s sealed Bid, labeled as detailed below, should be placed within the shipper’s sealed envelope to ensure that the Bid is not prematurely opened. All Bids must have a label on the outside of the package or shipping container outlining the following information: “BID ENCLOSED (bold print, all capitals) • Group Number • IFB or RFP Number • Bid Submission date and time” In the event that a Bidder fails to provide such information on the return Bid envelope or shipping material, the receiving entity reserves the right to open the shipping package or envelope to determine the proper Bid number or Product group, and the date and time of Bid opening. Bidder shall have no claim against the receiving entity arising from such opening and such opening shall not affect the validity of the Bid or the procurement. Notwithstanding the receiving agency’s right to open a Bid to ascertain the foregoing information, Bidder assumes all risk of late delivery associated with the Bid not being identified, packaged or labeled in accordance with the foregoing requirements. All Bids must be signed by a person authorized to commit the Bidder to the terms of the Bid Documents and the content of the Bid (offer).
Authority of Representative The Representative shall have the power, on behalf of each Holder, to pursue such remedies as may be available by law and pursuant to this Revenue Sharing Agreement, for the purpose of maximizing the return to the Holders as a group, and to settle the claims of each Holder on such terms as the Representative may determine in its sole and unlimited discretion, subject to the other provisions of this Revenue Sharing Agreement. The Representative may pursue such remedies notwithstanding that the Representative does not have physical possession of the Notes and without naming the Holders as parties.
Application Form To apply for a pole attachment or conduit occupancy license under this Agreement, Applicant shall submit to SWBT two signed copies of the appropriate application forms. SWBT represents that the forms specified in subsections (a)-(b) are forms in use prior to the effective date of this Agreement and that SWBT is in the process of revising such forms to conform to the provisions of this Agreement and to streamline the application process. The parties therefore agree that the forms specified in subsections (a) and (b) will be interim forms only. SWBT reserves the right to change the format and content of these forms upon 60 days written notice to Applicant. (a) To apply for a pole attachment license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make- Ready Authorization”) together with completed Form SW-9433 (“Pole Attachments”). An application for a pole attachment license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9433 and SW-9434 are attached to this Agreement as parts of APPENDIX III. (b) To apply for a conduit occupancy license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make-Ready Authorization”) together with completed Form SW-9435 (“Conduit Occupancy”). An application for a conduit occupancy license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9434 and SW-9435 are attached to this Agreement as parts of APPENDIX III. (c) Each application for a license under this Agreement shall include, at a minimum, the following information: (1) the poles, ducts, and conduits (including all manholes) along Applicant’s proposed route to or within which Applicant desires to attach or place its facilities; (2) a description of the facilities to be attached to SWBT’s poles and a description of the facilities to be placed within each component of SWBT’s conduit system (including but not limited to ducts, conduits, manholes, and handholes) along the proposed route; (3) for poles, the proposed points of attachment; (4) for building entrance or building distribution ducts or conduits or other space within a building, a conspicuous statement, as required by Section 5.06 of this Agreement, that the application pertains to a building entrance or building distribution duct or conduit or other space within a building; (5) if applicable, a conspicuous notation that the space requested is not to be assigned (or billed) to Applicant until SWBT has received Applicant’s written instruction to make such assignment or issued a license authorizing Applicant to occupy the space requested; and (6) if applicable, a conspicuous statement that Applicant intends to occupy the space before the issuance of a license, as provided in Section 8.03 of this Agreement. (d) Facilities descriptions which apply to multiple pole attachments or conduit occupancies need only be described once on any form. Facilities descriptions shall include, at a minimum, the following information: (1) the number and types of cables, including the physical size (diameter) and weight (weight per foot); (2) the number and types of strands, if any, which will be used to support the cables, including the rated holding capacity expressed in thousand pound increments (e.g., 2.2M) of such strands; and (3) sufficient information to identify and describe the physical characteristics (size, dimensions, and weight) of apparatus enclosures and other facilities to be attached to SWBT’s poles or placed in SWBT’s conduit system. (e) When it appears to Applicant that facilities modification, capacity expansion, or make-ready work may be required to accommodate Applicant’s access requests, Applicant shall describe the facilities modification, capacity expansion, or make-ready work which Applicant proposes. Applicant shall also describe its plans, if any, to use any infrequent construction technique or connectivity solution authorized under Section 6.03 to avoid high or unusual expenditures and state its reasons for the use of such technique or solution. (f) Applicant acknowledges that the poles along a particular pole line or route may include poles owned by firms (such as electric utilities) other than SWBT, that it may be necessary for SWBT to rearrange its facilities or perform other make-ready work on poles other than poles it owns or controls in order to accommodate Applicant’s request for access to SWBT’s poles and that, at the time an application is submitted, it may be difficult for Applicant to determine with certainty whether a particular pole is owned or controlled by SWBT or by another entity. Accordingly, the application shall, to the extent feasible, identify all poles utilized by SWBT (without regard to ownership) along Applicant’s proposed route. (g) Each application for a license under this Agreement shall be accompanied by a construction schedule showing Applicant’s projected dates for beginning and completing construction at the sites specified in the application. Information on this schedule may be used by SWBT’s engineering and outside plant construction personnel in scheduling work required to process Applicant’s applications and scheduling such capacity expansions, make- ready work, and facilities modifications, if any, as may be necessary to accommodate Applicant’s facilities. (h) Applicant may include multiple cables in a single license application and may provide multiple services (e.g., CATV and non-CATV services) under the same cable sheath or jacket. When both CATV and non-CATV services are provided under the same cable sheath or jacket, or CATV and non-CATV services are provided using different cables attached or lashed to the same strand or otherwise occupying the same space on a pole or the same duct or inner duct within a conduit, Applicant will so advise SWBT and SWBT shall, if permitted by law, adjust its charges to enable SWBT to charge Applicant the rate applicable to telecommunications carriers rather than the rate applicable to cable television systems solely to provide cable service.
Designation of Representatives 9.2.1 TxDOT and DB Contractor shall each designate Authorized Representative(s) who shall be authorized to make decisions and bind the Parties on matters relating to the Contract Documents. Exhibit 19 hereto provides the initial Authorized Representative designations. Such designations may be changed by a subsequent writing delivered to the other Party in accordance with Section 9.1. 9.2.2 The Parties may also designate technical representatives who shall be authorized to investigate and report on matters relating to the administration, design and construction of the Project and negotiate on behalf of each of the Parties, but who do not have authority to bind TxDOT or DB Contractor.
Submitting Investigator An investigator who submitted a genomic dataset to an NIH designated data repository (e.g., dbGaP).
