Dry docks’ Side Walls Sample Clauses

Dry docks’ Side Walls. (1) The dry docks’ side walls consist of ‘L’ shaped cantilever walls with the toes projecting into the dry dock. The rear of the walls and bottom of the toes only are reinforced. The wall base slab shall be cast in lengths not exceeding 10m. The dock walls may be cast in full height from the top of the base slab to the underside of the cope structure. The dock face wall shall be cast in lengths not exceeding 10m. The dock walls are not designed to be resistant to sliding with full earth or water pressure against them if the dock floor slab is not present. Backfilling shall be not permitted, therefore, above the base slab until the corresponding section of floor slab is completed from wall to wall. CONTRACTOR shall plan his construction in such a way that stability is maintained throughout the construction.
Sample 1
AutoNDA by SimpleDocs

Related to Dry docks’ Side Walls

  • Trunk Side A Central Office Switch connection that is capable of, and has been programmed to treat the circuit as, connecting to another switching entity, for example, to another carrier’s network. Trunk side connections offer those transmission and signaling features appropriate for the connection of switching entities and cannot be used for the direct connection of ordinary telephone station sets.

  • Line Side An End Office connection that provides transmission, switching and optional features suitable for Customer connection to the public switched network, including loop start supervision, ground start supervision and signaling for BRI- ISDN service.

  • Porcupine Site Highway 11

  • Developer Attachment Facilities Developer shall design, procure, construct, install, own and/or control the Developer Attachment Facilities described in Appendix A hereto, at its sole expense.

  • Exterior Drainage Does water stand on the property for more than 24 hours after a heavy rain? Yes No Unknown Comments Are gutters and downspouts in good repair? Yes No Unknown Comments:

  • Road Surfaces (1) Grade, shape, crown, and/or outslope surface and shoulders.

  • Video Display Terminals ‌ The Employer shall ensure that any new office equipment or facility required for use in conjunction with VDTs shall meet the standards recommended by the Workers' Compensation Board.

  • wire Unbundled ISDN Digital Loops These will be provisioned according to industry standards for 2-Wire Basic Rate ISDN services and will come standard with a test point, OC, and a DLR. NewPhone will be responsible for providing BellSouth with a Service Profile Identifier (SPID) associated with a particular ISDN-capable Loop and customer. With the SPID, BellSouth will be able to adequately test the circuit and ensure that it properly supports ISDN service.

  • ROAD DIMENSIONS Purchaser shall perform road work in accordance with the dimensions shown on the TYPICAL SECTION SHEET and the specifications within this road plan.

  • Laundry Facilities SF State University assumes no responsibility in the use of laundry equipment or for lost items.

Time is Money Join Law Insider Premium to draft better contracts faster.