Duty-Day Parameters Clause Samples

The Duty-Day Parameters clause defines the specific limits and conditions under which an employee or contractor is expected to perform their work duties within a given day. It typically outlines the maximum number of working hours, required rest periods, and any exceptions or special circumstances that may apply, such as extended shifts or emergency situations. By clearly establishing these boundaries, the clause helps prevent overwork, ensures compliance with labor regulations, and provides both parties with a mutual understanding of daily work expectations.
Duty-Day Parameters. The regular duty days of members of the unit shall begin no earlier than 7:00 a.m. (for a regular six (6) period day) or 6:20 a.m. (for a zero (0) period day), and not end later than 5:00 p.m. Individual work hours shall be consecutive.
View SourceView Similar (4)
Duty-Day Parameters. Instructional minute requirements shall be based on legally required grade level totals for the school year. The instructional minute requirements are as follows: K 36,000 minutes 1-3 50,400 minutes 4-5 54,000 minutes
View Source

Related to Duty-Day Parameters

  • Measuring EPP parameters Every 5 minutes, EPP probes will select one “IP address” of the EPP servers of the TLD being monitored and make an “EPP test”; every time they should alternate between the 3 different types of commands and between the commands inside each category. If an “EPP test” result is undefined/unanswered, the EPP service will be considered as unavailable from that probe until it is time to make a new test.

  • Measuring DNS parameters Every minute, every DNS probe will make an UDP or TCP “DNS test” to each of the public-­‐DNS registered “IP addresses” of the name servers of the domain name being monitored. If a “DNS test” result is undefined/unanswered, the tested IP will be considered unavailable from that probe until it is time to make a new test.

  • Rates Applicable After Default Notwithstanding anything to the contrary contained in Section 2.9 or 2.10, during the continuance of a Default or Unmatured Default the Required Lenders may, at their option, by notice to the Borrower (which notice may be revoked at the option of the Required Lenders notwithstanding any provision of Section 8.2 requiring consent of affected Lenders to changes in interest rates), declare that no Advance may be made as, converted into or continued as a LIBOR Rate Advance. During the continuance of a Default the Required Lenders may, at their option, by notice to the Borrower (which notice may be revoked at the option of the Required Lenders notwithstanding any provision of Section 8.2 requiring consent of affected Lenders to changes in interest rates), declare that (i) each LIBOR Rate Advance shall bear interest for the remainder of the applicable Interest Period at the LIBOR Rate otherwise applicable to such LIBOR Rate Advance for such Interest Period plus 4% per annum and (ii) each Floating Rate Advance shall bear interest at a rate per annum equal to the Floating Rate otherwise applicable to the Floating Rate Advance plus 4% per annum; provided, however, that the Default Rate shall become applicable automatically if a Default occurs under Section 7.1 or 7.2, unless waived by the Required Lenders.

  • Number Resources, Rate Center Areas and Routing Points 13.1 Nothing in this Agreement shall be construed to limit or otherwise adversely affect in any manner either Party’s right to employ or to request and be assigned any Central Office Codes (“NXX”) pursuant to the Central Office Code Assignment Guidelines and any relevant FCC or Commission orders, as may be amended from time to time, or to establish, by Tariff or otherwise, Rate Center Areas and Routing Points corresponding to such NXX codes. 13.2 It shall be the responsibility of each Party to program and update its own switches and network systems pursuant to information provided on ASRs as well as the LERG in order to recognize and route traffic to the other Party’s assigned NXX codes. Except as expressly set forth in this Agreement, neither Party shall impose any fees or charges whatsoever on the other Party for such activities. 13.3 Unless otherwise required by Commission order, the Rate Center Areas will be the same for each Party. During the term of this Agreement, Onvoy shall adopt the Rate Center Area and Rate Center Points that the Commission has approved for Frontier within the LATA and Tandem serving area. Onvoy shall assign whole NPA-NXX codes to each Rate Center Area unless otherwise ordered by the FCC, the Commission or another governmental entity of appropriate jurisdiction, or the LEC industry adopts alternative methods of utilizing NXXs. 13.4 Onvoy will also designate a Routing Point for each assigned NXX code. Onvoy shall designate one location for each Rate Center Area in which the Onvoy has established NXX code(s) as the Routing Point for the NPA-NXXs associated with that Rate Center Area, and such Routing Point shall be within the same LATA as the Rate Center Area but not necessarily within the Rate Center Area itself. Unless specified otherwise, calls to subsequent NXXs of Onvoy will be routed in the same manner as calls to ▇▇▇▇▇’s initial NXXs. 13.5 Notwithstanding anything to the contrary contained herein, nothing in this Agreement is intended, and nothing in this Agreement shall be construed, to in any way constrain Onvoy’s choices regarding the size of the local calling area(s) that Onvoy may establish for its Customers, which local calling areas may be larger than, smaller than, or identical to Frontier’s local calling areas.

  • PRICING OF After Hours Coefficient What is your after hours coefficient for the RS Means Price Book for work performed after normal working hours?