Food and Cash EBT-Only POS Equipment Requirements Sample Clauses

Food and Cash EBT-Only POS Equipment Requirements. Requirement 1427 The EBT-only POS device profile load shall enable compliance with ISO 8583, ANSI X9.58, and the Quest® Operating Rules. 1428 The EBT-only POS device profile load shall support the full Food and Cash EBT POS transaction set specified in the Quest® Operating Rules, including cash transactions, with the exception of the store-and-forward transaction.
AutoNDA by SimpleDocs

Related to Food and Cash EBT-Only POS Equipment Requirements

  • Equipment Requirements No Equipment is provided to Customer as part of this Service.

  • Payment Requirements ‌ If funding levels are significantly affected by state or federal budget and funds are not allocated and available for the continuance of the function performed by Subrecipient, the Contract may be terminated by the County at the end of the period for which funds are available. The County shall notify Subrecipient at the earliest possible time of any service, which will or may be affected by a shortage of funds. No penalty shall accrue to the County in the event this provision is exercised and the County shall not be obligated nor liable for any damages as a result of termination under this provision of this Contract, and nothing herein shall be construed as obligating the County to expend or as involving the County in any Contract or other obligation for future payment of money in excess of appropriations authorized by law.

  • Procurement Requirements The below listed provisions of State Procurement requirements shall be complied with throughout the contract period:

  • Minimum System Requirements The following summarizes the minimum office system requirements for all Contractors and Architect/Engineer to possess in order to participate. It is the responsibility of all Contractors and Architect/Engineer to possess these minimum requirements at no additional cost to Princeton University.

  • U.S. Federal Procurement Requirements Without limiting Section 12.1, in light of DXC’s status as a U.S. Federal contractor and subcontractor, all applicable procurement regulations required by federal statute or regulation to be inserted in contracts or subcontracts apply to this Order, including but not limited to FAR 52.219-8 (Utilization of Small Business Concerns), FAR 52.219.-9 (Small Business Subcontracting Plan), FAR 52.219-16 (Liquidated Damages Subcontracting Plan), FAR 52.222-26 (Equal Opportunity), FAR 52.222-35 (Equal Opportunity for Special Disabled Veterans, Veterans of the Vietnam Era, and other Eligible Veterans), FAR 52.222-36 (Affirmative Action for Workers with Disabilities), FAR 52.222-39 ( Notification of Employee Rights Concerning Payment of Union Dues or Fees), FAR 52.222-41 (Service Contract Act of 1965), and FAR 52.247-64 (Preference for Privately Owned U.S. Flag Commercial Vessels).

  • Initial Forecasts/Trunking Requirements Because Verizon’s trunking requirements will, at least during an initial period, be dependent on the Customer segments and service segments within Customer segments to whom CSTC decides to market its services, Verizon will be largely dependent on CSTC to provide accurate trunk forecasts for both inbound (from Verizon) and outbound (to Verizon) traffic. Verizon will, as an initial matter, provide the same number of trunks to terminate Reciprocal Compensation Traffic to CSTC as CSTC provides to terminate Reciprocal Compensation Traffic to Verizon. At Verizon’s discretion, when CSTC expressly identifies particular situations that are expected to produce traffic that is substantially skewed in either the inbound or outbound direction, Verizon will provide the number of trunks CSTC suggests; provided, however, that in all cases Verizon’s provision of the forecasted number of trunks to CSTC is conditioned on the following: that such forecast is based on reasonable engineering criteria, there are no capacity constraints, and CSTC’s previous forecasts have proven to be reliable and accurate.

  • Support Requirements If there is a dispute between the awarded vendor and TIPS Member, TIPS or its representatives may assist, at TIPS sole discretion, in conflict resolution or third party (mandatory mediation), if requested by either party. TIPS, or its representatives, reserves the right to inspect any project and audit the awarded vendors TIPS project files, documentation and correspondence. Status of TIPS Members as Related to This Agreement TIPS Members stand in the place of TIPS as related to this agreement and have the same access to the proposal information and all related documents. TIPS Members have all the same rights under the awarded Agreement as TIPS.

  • Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.

  • Minimum Customer Support Requirements for TIPS Sales Vendor shall provide timely and commercially reasonable support for TIPS Sales or as agreed to in the applicable Supplemental Agreement.

  • Ongoing Trunk Forecast Requirements Where the Parties have already established interconnection in a LATA, Onvoy shall provide a new or revised traffic forecast that complies with the Frontier Interconnection Trunking Forecast Guide when Xxxxx develops plans or becomes aware of information that will materially affect the Parties’ interconnection in that LATA. Instances that require a new or revised forecast include, but are not limited to: (a) Onvoy plans to deploy a new switch; (b) Onvoy plans to implement a new POI or network architecture; (c) Onvoy plans to rearrange its network; (d) Onvoy plans to convert a One-Way Interconnection Trunk group to a Two-Way Interconnection Trunk group; (e) Onvoy plans to convert a Two-Way Interconnection Trunk group to a One-Way Interconnection Trunk group; or (f) Onvoy expects a significant change in interconnection traffic volume. In addition, upon request by either Party, the Parties shall meet to: (i) review traffic and usage data on End Office and Tandem Interconnection Trunk groups and (ii) determine whether the Parties should establish new Interconnection Trunk groups, augment existing Interconnection Trunk groups, or disconnect existing Interconnection Trunks.

Time is Money Join Law Insider Premium to draft better contracts faster.