Garden 3.15.1 To keep gardens, window boxes or grounds in good order; the paths tidy, the grass cut and borders weeded and in the same style and condition as at the commencement of the Tenancy. The Tenant has no obligation to top lop, prune or trim any tree, xxxx or shrub which is the responsibility of the Landlord. 3.15.2 To cut the grass regularly during the growing season. 3.15.3 Not, alter the existing design, content or layout of the garden or grounds without the prior written consent of the Landlord or Landlord’s Agent and will water all plants during any dry periods subject to any restrictions relating to the watering of gardens imposed by the relevant local water supplier. 3.15.4 Keep the garden patio or decking (if any) clear and free from any surface deposits, such as algae and xxxx during the Tenancy. 3.15.5 Not permit, keep or bring into the garden or grounds portable buildings, vans, commercial vehicles, boats, huts or sheds without the prior written consent of the Landlord or Landlord’s Agent, which cannot be unreasonably withheld. At the end of this Tenancy the Tenant will remove all such items and make good the garden or grounds to the Landlord’s reasonable satisfaction.
Gardens 3.8.1 If your property has a garden you must keep this tidy and not allow your garden to become a nuisance to other neighbours. You should keep lawns cut and xxxxxx trimmed. 3.8.2 If you have a communal garden you must not install a trampoline or leave a paddling pool with water in unattended. 3.8.3 You must make sure that your refuse is put out ready for collection in accordance with the Council’s waste collection and recycling service. 3.8.4 If you live in a flat or maisonette, you may be expected to deposit rubbish in the bins provided in the designated area. You must use these bins and not leave household waste in any other parts of the internal communal areas or external areas. 3.8.5 You must not deposit or allow rubbish to accumulate in your garden. We may charge you the costs for clearing any rubbish that you have not disposed of correctly. 3.8.6 You must not use the garden or the drive to the property to store, load or unload materials such as scrap metal. If you do we may remove the items and charge you for doing this. We will give you written notice that we will be removing the items. 3.8.7 You must not erect a greenhouse, garage or shed at the property without our written permission. We may withdraw our permission if the building causes nuisance or becomes unsafe. If we grant you permission in our capacity as landlord you may still require planning permission and/or comply with building regulations. 3.8.8 You must not build a fish pond, swimming pool, water feature or patio in your garden without our written permission. If we give you permission to carry out this work you will have to remove these at the end of your tenancy at your own expense. If we have to remove these items we will charge you the cost of this. 3.8.9 You must not remove, replace or reposition any hedge or fence at the property without getting our written permission. 3.8.10 You must not plant large types of trees in your garden for example leylandii, conifers, willow, oak, ash and so on. These may damage the structure of your home and cause subsidence. 3.8.11 You must not allow any hedge to grow more than two metres high or overhang pavements or your neighbours’ gardens. 3.8.12 If you continually fail to look after your garden and it is considered an eyesore we may ask you to move to a property without a garden. If you refuse we may ask the Court to end your tenancy. You may also be charged the cost of clearing your garden when your tenancy ends.
Heating, Ventilating and Air Conditioning General Office Area: The building shall be equipped with a combination heating, ventilation and air conditioning system. The system shall have ducted supply and return air. The space above the ceiling shall not be used as a supply or return plenum. The systems shall be sized in accordance with the
International Shopping Goods estimated to cost less than $100,000 equivalent per contract may be procured under contracts awarded on the basis of international shopping procedures in accordance with the provisions of paragraphs 3.5 and 3.6 of the Guidelines.
Heating, Ventilation and Air Conditioning Landlord shall furnish to the Premises heating, ventilation and air-conditioning (“HVAC”) in accordance with the Design Standards set forth in Exhibit D during Ordinary Business Hours. Landlord shall have access to all air-cooling, fan, ventilating and machine rooms and electrical closets and all other mechanical installations of Landlord (collectively, “Mechanical Installations”), and Tenant shall not construct partitions or other obstructions which may interfere with Landlord’s access thereto or the moving of Landlord’s equipment to and from the Mechanical Installations. No Tenant Party shall at any time enter the Mechanical Installations or tamper with, adjust, or otherwise affect such Mechanical Installations. Landlord shall not be responsible if the HVAC System fails to provide cooled or heated air, as the case may be, to the Premises in accordance with the Design Standards by reason of (i) any equipment installed by, for or on behalf of Tenant, which has an electrical load in excess of the average electrical load and human occupancy factors for the HVAC System as designed, or (ii) any rearrangement of partitioning or other Alterations made or performed by, for or on behalf of Tenant. Tenant shall install, if missing, blinds or shades on all windows, which blinds and shades shall be subject to Landlord’s approval, and shall keep operable windows in the Premises closed, and lower the blinds when necessary because of the sun’s position, whenever the HVAC System is in operation or as and when required by any Requirement. Tenant shall cooperate with Landlord and shall abide by the rules and regulations which Landlord may reasonably prescribe for the proper functioning and protection of the HVAC System. Tenant acknowledges that the server room in the Premises currently has three heat pumps installed, being two 4-ton units, and one 2.5-ton unit (the “Existing Heat Pumps”). The 2.5-ton unit is currently connected and operational. Tenant shall determine whether it is satisfied with the condition of the Existing Heat Pumps and Landlord shall not have any responsibility or liability for the condition, operation, maintenance, repair or replacement of the Existing Heat Pumps. Tenant may operate the Existing Heat Pumps. Tenant shall be responsible for, and pay directly for, all necessary maintenance and repairs to the Existing Heat Pumps. Tenant shall reimburse Landlord monthly for the cost of all utility services used to operate the Existing Heat Pumps within 10 Business Days after receipt of Landlord’s invoice for such amount. Landlord may measure Tenant’s usage of such utility services by either a sub-meter or by other reasonable methods such as by temporary check meters or by survey. Tenant, at its cost, may replace the Existing Heat Pumps with one or more new heat pumps, provided, however, that the capacity of such replacement heat pump(s) shall not exceed the 10.5-ton capacity cooling capacity of the Existing Heat Pumps.
Coffee Breaks The Company will provide two (2) fifteen (15) minute coffee breaks during each work day, one in the morning and one in the afternoon.
Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Subloop that may diminish the capability of the Loop or Subloop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the BellSouth’s TR 73600 Unbundled Local Loop Technical Specification. 2.5.2 BellSouth will remove load coils only on copper Loops and Subloops that are less than eighteen thousand (18,000) feet in length. 2.5.3 For any copper loop being ordered by NewPhone which has over six thousand (6,000) feet of combined bridged tap will be modified, upon request from NewPhone, so that the loop will have a maximum of six thousand (6,000) feet of bridged tap. This modification will be performed at no additional charge to NewPhone. Loop conditioning orders that require the removal of bridged tap that serves no network design purpose on a copper Loop that will result in a combined total of bridged tap between two thousand five hundred (2,500) and six thousand (6,000) feet will be performed at the rates set forth in Exhibit A. 2.5.4 NewPhone may request removal of any unnecessary and non-excessive bridged tap (bridged tap between zero (0) and two thousand five hundred (2,500) feet which serves no network design purpose), at rates pursuant to BellSouth’s SC Process as mutually agreed to by the Parties. 2.5.5 Rates for ULM are as set forth in Exhibit A. 2.5.6 BellSouth will not modify a Loop in such a way that it no longer meets the technical parameters of the original Loop type (e.g., voice grade, ADSL, etc.) being ordered. 2.5.7 If NewPhone requests ULM on a reserved facility for a new Loop order, BellSouth may perform a pair change and provision a different Loop facility in lieu of the reserved facility with ULM if feasible. The Loop provisioned will meet or exceed specifications of the requested Loop facility as modified. NewPhone will not be charged for ULM if a different Loop is provisioned. For Loops that require a DLR or its equivalent, BellSouth will provide LMU detail of the Loop provisioned. 2.5.8 NewPhone shall request Loop make up information pursuant to this Attachment prior to submitting a service inquiry and/or a LSR for the Loop type that NewPhone desires BellSouth to condition. 2.5.9 When requesting ULM for a Loop that BellSouth has previously provisioned for NewPhone, NewPhone will submit a SI to BellSouth. If a spare Loop facility that meets the Loop modification specifications requested by NewPhone is available at the location for which the ULM was requested, NewPhone will have the option to change the Loop facility to the qualifying spare facility rather than to provide ULM. In the event that BellSouth changes the Loop facility in lieu of providing ULM, NewPhone will not be charged for ULM but will only be charged the service order charges for submitting an order.
CONCEALED CONDITIONS 12.2.1 Should concealed conditions encountered in the performance of the Work below the surface of the ground, or should concealed or unknown conditions in an existing structure be at variance with the conditions indicated by the Contract Documents or should unknown physical conditions below the surface of the ground or should concealed or unknown conditions in an existing structure of an unusual nature, differing materially from those ordinarily encountered and generally recognized as inherent in work of the character provided for in this Contract, be encountered, the Contract Sum shall be equitably adjusted by Change Order upon claim by either
National Shopping Goods estimated to cost less than $50,000 equivalent per contract, may be procured under contracts awarded on the basis of national shopping procedures in accordance with the provisions of paragraphs 3.5 and 3.6 of the Guidelines.
Standard Conditions This Agreement shall include all of the standard conditions as detailed in Exhibit B, attached hereto and by this reference incorporated herein.
