General Standards for Teaching Assignments. 12.7.1 Discrete sections of the same course that meet at distinct times in a given semester are to each be considered one course.
General Standards for Teaching Assignments Sample Clauses
Related to General Standards for Teaching Assignments
Certification of Meeting or Exceeding Tobacco-Free Workplace Policy Minimum Standards A. Grantee certifies that it has adopted and enforces a Tobacco-Free Workplace Policy that meets or exceeds all of the following minimum standards of:
LICENSES AND STANDARDS 17 5.1 CONTRACTOR warrants that it has all necessary licenses and permits 18 required by the laws of the United States, State of California, County of 19 Orange and all other appropriate governmental agencies to perform the services 20 described in this Agreement, and agrees to maintain these licenses and permits 21 in effect for the duration of this Agreement. Further, CONTRACTOR warrants 22 that its employees shall conduct themselves in compliance with such laws and 23 licensure requirements including, without limitation, compliance with laws 24 applicable to sexual harassment and ethical behavior.
Teaching Assignments No employee shall be assigned to teach in a grade level and/or subject area not within the scope of his/her teaching certificate, except where a position within his/her certification is unavailable or when mutually agreed to by the affected employee and principal, or when determined necessary by the principal. Employees assigned to positions outside the scope of their certificates shall be assigned as soon as possible to positions for which they hold certification.
Technical Standards The Generation System shall be installed and operated by the Interconnection Customer consistent with the requirements of this Agreement; the Technical Requirements; the applicable requirements located in the National Electrical Code (NEC); the applicable standards published by the American National Standards Institute (ANSI) and the Institute of Electrical and Electronic Engineers (IEEE); and local building and other applicable ordinances in effect at the time of the installation of the Generation System.
ETHICAL STANDARDS 10.7.1 Within 90 days after the Effective Date, Developer shall adopt written policies establishing ethical standards of conduct for all Developer-Related Entities (other than NTTA), including Developer’s supervisory and management personnel, in dealing with (a) TxDOT and the Independent Engineer and (b) employment relations. Such policy shall be subject to review and comment by TxDOT prior to adoption. Such policy shall include standards of ethical conduct concerning the following:
Standards for Network Elements 1.8.1 BellSouth shall comply with the requirements set forth in the technical references, as well as any performance or other requirements identified in this Agreement, to the extent that they are consistent with the greater of BellSouth’s actual performance or applicable industry standards.
Training Assignments The Supervisor or designee may establish written training assignments to enable an employee to gain the additional experience and training required for the job for a period of time not to exceed two years. At the completion of the training assignment, the employee’s pay will be set no less than the entry rate of pay for the occupational pay band.
