Fuel Upon redelivery of the Aircraft to Lessor, an adjustment will be made in respect of fuel on board on the Previous Delivery Date and the Expiry Date at the price then prevailing at the Redelivery Location.
Underground Tanks If underground or other storage tanks storing Hazardous Materials located on the Premises or the Project are used by Tenant or are hereafter placed on the Premises or the Project by Tenant, Tenant shall install, use, monitor, operate, maintain, upgrade and manage such storage tanks, maintain appropriate records, obtain and maintain appropriate insurance, implement reporting procedures, properly close any underground storage tanks, and take or cause to be taken all other actions necessary or required under applicable state and federal Legal Requirements, as such now exists or may hereafter be adopted or amended in connection with the installation, use, maintenance, management, operation, upgrading and closure of such storage tanks.
Underground Storage Tanks Borrower shall not install or permit to be installed on the Property any underground storage tank.
Storage Any storage space at any time leased to Tenant hereunder shall be used exclusively for storage. Notwithstanding any other provision of this Lease to the contrary, (i) Landlord shall have no obligation to provide heating, cleaning, water or air conditioning therefor, and (ii) Landlord shall be obligated to provide to such storage space only such electricity as will, in Landlord’s judgment, be adequate to light said space as storage space.
Samples Distributor shall provide to Subdistributor samples and prototypes that are not intended for resale to the extent such are made available by its Suppliers and at the same cost (if any) assessed by its Suppliers. Subdistributor shall promptly return all samples and prototypes to Distributor on the expiration or earlier termination of this Agreement as provided for in 0. Distributor retains all rights, title, and interest in and to all samples and prototypes before, during, and after the Term; and Loaned Instruments. Within a reasonable amount of time following the execution of this Agreement, Distributor will loan up to 2 sets of Instruments to the Subdistributor. Thereafter, Distributor may, at its discretion, loan additional sets of Instruments to Subdistributor from time to time pursuant to this provision. Any Instruments loaned to Subdistributor pursuant to this provision are referred to as “Loaned Instruments”. Subdistributor shall be permitted, in turn, to loan the Loaned Instruments to Customers that have purchased Products for use in connection with the Products; however, such Loaned Instruments will remain the property of Distributor and may be retrieved and retaken by Distributor at any time. Orders for Products and Instruments Purchase Orders. Subdistributor shall submit to Distributor written purchase orders for the Products and Instruments it elects to purchase and distribute pursuant to this Agreement, which orders shall include: (i) a list of the Products and Instruments ordered, (ii) the quantities of such Products and Instruments, and (iii) precise instructions for packaging, invoicing and shipping.
Storage Tanks If storage tanks storing Hazardous Materials located on the Premises or the Project are used by Tenant or are hereafter placed on the Premises or the Project by Tenant, Tenant shall install, use, monitor, operate, maintain, upgrade and manage such storage tanks, maintain appropriate records, obtain and maintain appropriate insurance, implement reporting procedures, properly close any storage tanks, and take or cause to be taken all other actions necessary or required under applicable state and federal Legal Requirements, as such now exists or may hereafter be adopted or amended in connection with the installation, use, maintenance, management, operation, upgrading and closure of such storage tanks. Notwithstanding anything to the contrary contained herein, Tenant shall have no right to use or install any underground storage tanks at the Project.
Year 2000 Compatibility Borrower shall take all action necessary to assure that Borrower's computer based systems are able to operate and effectively process data including dates on and after January 1, 2000. At the request of Bank, Borrower shall provide Bank assurance acceptable to Bank of Borrower's Year 2000 compatibility.
Plant An electrical generating alternative energy resource facility developed by Producer for which IID shall provide transmission service, as specified in Exhibit(s) II, Transmission Service, and in any subsequent Plant Amendments.
Computational Materials and ABS Term Sheets (a) Not later than 10:30 a.m., New York City time, on a date no later than four business days before delivery of the Final Prospectus to the Underwriter, the Underwriter shall deliver to the Company five complete copies of all materials provided by the Underwriter to prospective investors in the Securities which constitute either (i) "Computational ------------- Materials" within the meaning of the no-action letter dated May 20, 1994 --------- issued by the Division of Corporation Finance of the Commission to Xxxxxx, Xxxxxxx Acceptance Corporation I, Xxxxxx, Peabody & Co. Incorporated, and Xxxxxx Structured Asset Corporation and the no-action letter dated May 27, 1994 issued by the Division of Corporation Finance of the Commission to the Public Securities Association (together, the "Xxxxxx Letters") or (ii) "ABS -------------- --- Term Sheets" within the meaning of the no-action letter dated February 17, ----------- 1995 issued by the Division of Corporation Finance of the Commission to the Public Securities Association (the "PSA Letter" and together with the ---------- Xxxxxx Letters, the "No-Action Letters"), if the filing of such materials ----------------- with the Commission is a condition of the relief granted in such letters. In the case of any such materials that constitute "Collateral Term Sheets" ---------------------- within the meaning of the PSA Letter, if such Collateral Term Sheets have not previously been delivered to the Company as contemplated by Section 10(b)(i) below, five complete copies of such Collateral Term Sheets shall be delivered by the Underwriter to the Company no later than 10:30 a.m., New York City time, on the first business day following the date on which such Collateral Term Sheets were initially provided to a potential investor. Each delivery of Computational Materials, Collateral Term Sheets and/or ABS Term Sheets to the Company pursuant to this paragraph (a) shall be effected by delivering four copies of such materials to counsel for the Company on behalf of the Company at the address specified in Section 15 hereof and one copy of such materials to the Company.
Materials and Equipment Except for materials or Equipment to be supplied by Subcontractors identified on part B of Schedule 7, whenever materials or Equipment are specified or described in this Contract (including the Specifications) by using the name of a proprietary item or the name of a particular supplier, the naming of the item is intended to establish the type, function and quality required, and substitute materials or Equipment may nonetheless be used, provided that such materials or Equipment are equivalent or equal to that named. If the Vendor wishes to furnish or use a substitute item of material or Equipment, the Vendor must first certify that the proposed substitute will perform at least as well the functions and achieve the results called for by this Contract, will be substantially similar or of equal substance to that specified and be suited for the same use as that specified. The Owner may require the Vendor to furnish, at the Vendor's expense, additional data about the proposed substitute as required to evaluate the substitution. For Major Portions of the Work, or materials or Equipment listed on part B of Schedule 7, the Vendor must first receive prior written approval of the Owner for any substitution. The Owner will be allowed a reasonable time within which to evaluate each proposed substitute. Notwithstanding the foregoing, with respect to PCS Products, prior to the shipment of such PCS Products pursuant to the terms of this Contract, the Vendor may at any time without notice to or consent of the Owner make changes in a Vendor PCS Product furnished pursuant to this Contract, or modify the drawings and published specifications relating thereto, or substitute Products of similar or later design to fulfill its obligations under this Contract or otherwise fill an order, provided that the changes, modifications or substitutions will in no way affect or otherwise impact upon the form, fit, or function of an ordered Product pursuant to and in accordance with the applicable Specifications. With respect to changes, modifications and substitutions which do in fact affect the form, fit, or function of an ordered Product pursuant to and in accordance with the Specifications, the Vendor must notify the Owner in writing at least thirty (30) days prior to the effective dates of any such changes, modifications or substitutions. In the event that any such change, modification or substitution is not desired by the Owner, the Owner will notify the Vendor within thirty (30) days from the date of notice and the Vendor will not furnish any such changed Products to the Owner on any orders in process at the time the Owner is so notified; provided that nothing contained herein will otherwise modify the Vendor's obligations under the terms of this Contract.
