Additional Responsibilities You agree to: reasonably clean and maintain Covered Items; not harm/damage a Covered Item or Component; provide a safe working environment for Contractors; not damage property of a Contractor; and not threaten/harm us or a Contractor via phone, email, personal interaction, internet, social media or otherwise.
Emergency Response Partners must develop, maintain, and carry out a response plan for public water system emergencies, including disease outbreaks, spills, operational failures, and water system contamination. Partners must notify DWS in a timely manner of emergencies that may affect drinking water supplies.
Reactive Power and Primary Frequency Response 9.6.1 Power Factor Design Criteria
Financial Responsibility You understand that you remain, solely and exclusively responsible for any and all financial risks, including, without limitation, insufficient funds associated with accessing the Service. The Credit Union shall not be liable in any manner for such risk unless Credit Union fails to follow the procedures described in materials for use of the service. You assume exclusive responsibility for the consequences of any instructions you give to the Credit Union, for your failures to access the Service properly in a manner prescribed by the Credit Union, and for your failure to supply accurate input information, including, without limitation, any information contained in an application.
PROFESSIONAL RESPONSIBILITY CLAUSE In the interest of safe patient care and safe nursing practice, the parties agree to the following problem solving process to address employee concerns relative to patient care including:
Primary Frequency Response Developer shall ensure the primary frequency response capability of its Large Generating Facility by installing, maintaining, and operating a functioning governor or equivalent controls. The term “functioning governor or equivalent controls” as used herein shall mean the required hardware and/or software that provides frequency responsive real power control with the ability to sense changes in system frequency and autonomously adjust the Large Generating Facility’s real power output in accordance with the droop and deadband parameters and in the direction needed to correct frequency deviations. Developer is required to install a governor or equivalent controls with the capability of operating: (1) with a maximum 5 percent droop ± 0.036 Hz deadband; or (2) in accordance with the relevant droop, deadband, and timely and sustained response settings from an approved Applicable Reliability Standard providing for equivalent or more stringent parameters. The droop characteristic shall be: (1) based on the nameplate capacity of the Large Generating Facility, and shall be linear in the range of frequencies between 59 and 61 Hz that are outside of the deadband parameter; or (2) based on an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. The deadband parameter shall be: the range of frequencies above and below nominal (60 Hz) in which the governor or equivalent controls is not expected to adjust the Large Generating Facility’s real power output in response to frequency deviations. The deadband shall be implemented: (1) without a step to the droop curve, that is, once the frequency deviation exceeds the deadband parameter, the expected change in the Large Generating Facility’s real power output in response to frequency deviations shall start from zero and then increase (for under-frequency deviations) or decrease (for over-frequency deviations) linearly in proportion to the magnitude of the frequency deviation; or (2) in accordance with an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. Developer shall notify NYISO that the primary frequency response capability of the Large Generating Facility has been tested and confirmed during commissioning. Once Developer has synchronized the Large Generating Facility with the New York State Transmission System, Developer shall operate the Large Generating Facility consistent with the provisions specified in Articles 9.5.5.1 and 9.5.5.2 of this Agreement. The primary frequency response requirements contained herein shall apply to both synchronous and non-synchronous Large Generating Facilities.
