Safety Inspection During inspection of County facilities conducted by the State Division of Occupational Safety and Health for the purpose of determining compliance with the California OSHA requirements, an OCEA designated employee shall be allowed to accompany the inspector while the inspector is in the employee's agency/department. The employee so designated shall suffer no loss of pay when this function is performed during the employee's regularly scheduled work hours.
Goods Inspection The Commissioner of DAS, in consultation with the Client Agency, shall determine the manner and prescribe the inspection of all Goods and the tests of all samples submitted to determine whether they comply with all of the specifications in the Contract. If any Goods fail in any way to meet the specifications in the Contract, the Client Agency or the Commissioner of DAS may, in its sole discretion, either reject it and owe nothing or accept it and pay for it on an adjusted price basis, depending on the degree to which the Goods meet the specifications. Any decision pertaining to any such failure or rejection shall be final and binding.
Physical Inspection Subject to the limitations set forth in this Section 4.1(c) and notwithstanding any provision to the contrary in this Agreement, commencing on the Effective Date and continuing through the Closing or any earlier termination of this Agreement, Buyer shall have the right, at Buyer’s expense, to make inspections (including tests, surveys and other studies) of the Real Property and all matters relating thereto, including, but not limited to, soils and geologic conditions, location of property lines, utility availability and use restrictions, environmental conditions, the manner or quality of the construction of the Improvements, the habitability, merchantability, marketability, profitability or fitness for a particular purpose of the Real Property, the effect of applicable planning, zoning and subdivision statutes, ordinances, regulations, restrictions and permits, the character and amount of any fees or charges that must be paid to further develop, improve and/or occupy the Real Property and all other matters relating to the Real Property. Prior to Closing, Buyer and its agents, contractors and subcontractors shall have the right to enter upon the Real Property, at reasonable times during ordinary business hours, to make inspections and tests as Buyer deems reasonably necessary and which may be accomplished without causing any material damage to the Real Property including, without limitation, the right to conduct a phase I environmental audit and an investigation with respect to the Real Property’s compliance with the requirements of Title III of the Americans with Disabilities Act of 1990. Notwithstanding the foregoing, in no event shall Buyer, its agents, contractors or subcontractors conduct any invasive testing on the Real Property without Seller’s prior written approval, which approval shall not be unreasonably withheld, conditioned or delayed. Buyer shall not materially interfere with any Tenant, occupant or invitee of the Real Property in making such inspections or tests, and shall return and restore the Property to substantially its original condition prior to such inspections or tests. Buyer shall not permit any liens or encumbrances to be placed against the Real Property in connection with Buyer’s investigation and inspection of the Real Property and/or in connection with Buyer’s activities on the Real Property. Buyer hereby agrees to and shall indemnify, defend and hold harmless Seller and Seller’s members, managers, partners, officers, directors, shareholders, employees, agents, representatives, invitees, successors and assigns (each, a “Seller Group Indemnitee”), from and against any and all claims, demands, and causes of action for personal injury or property damage, and all damages, judgments, liabilities, costs, fees and expenses (including reasonable attorneys’ fees) resulting therefrom, arising out of any entry onto the Real Property by Buyer, its agents, employees, contractors and/or subcontractors, pursuant to this Section 4.1(c) hereof, provided, however, Buyer shall not be obligated to indemnify, defend or hold harmless Seller or any Seller Group Indemnitee for any such claims, demands and/or causes of action or any such damages, judgments, liabilities, costs, fees or expenses caused by: (i) the discovery of conditions that were present before Buyer or its representatives entered onto the Real Property, or the accidental or inadvertent release of any Hazardous Materials that were in, on or under the Real Property prior to such entry; or (ii) the negligent or willful misconduct of Seller or any Seller Group Indemnitee. The covenants, agreements and obligations of Buyer set forth in this Section 4.1(c) shall survive the termination of this Agreement and the Closing, as applicable.
Equipment Testing and Inspection 2.1.1 The Interconnection Customer shall test and inspect its Small Generating Facility and Interconnection Facilities prior to interconnection. The Interconnection Customer shall notify the NYISO and the Connecting Transmission Owner of such activities no fewer than five Business Days (or as may be agreed to by the Parties) prior to such testing and inspection. Testing and inspection shall occur on a Business Day. The Connecting Transmission Owner may, at its own expense, send qualified personnel to the Small Generating Facility site to inspect the interconnection and observe the testing. The Interconnection Customer shall provide the NYISO and Connecting Transmission Owner a written test report when such testing and inspection is completed. The Small Generating Facility may not commence parallel operations if the NYISO, in consultation with the Connecting Transmission Owner, finds that the Small Generating Facility has not been installed as agreed upon or may not be operated in a safe and reliable manner.
2.1.2 The NYISO and Connecting Transmission Owner shall each provide the Interconnection Customer written acknowledgment that it has received the Interconnection Customer’s written test report. Such written acknowledgment shall not be deemed to be or construed as any representation, assurance, guarantee, or warranty by the NYISO or Connecting Transmission Owner of the safety, durability, suitability, or reliability of the Small Generating Facility or any associated control, protective, and safety devices owned or controlled by the Interconnection Customer or the quality of power produced by the Small Generating Facility.
Final Inspection The Contractor shall complete the list of items identified on the Pre-Final Punchlist prior to requesting a Final Inspection. Unless otherwise specified, or otherwise agreed in writing by the parties as documented on the Certificate of Substantial Completion, the Contractor shall complete and/or correct all Work within thirty (30) days of the Substantial Completion date. Upon completion of the Pre-Final Punchlist work, the Contractor shall give written notice to the ODR and A/E that the Work will be ready for Final Inspection on a specific date. The Contractor shall accompany this notice with a copy of the updated Pre-Final Punchlist indicating resolution of all items. On the date specified or as soon thereafter as is practicable, the ODR, A/E and the Contractor will inspect the Work. The A/E will submit to the Contractor a Final Punchlist of open items that the inspection team requires corrected or completed before final acceptance of the Work.
12.1.2.1 The Contractor must correct or complete all items on the Final Punchlist before requesting Final Payment. Unless otherwise agreed to in writing by the parties, complete this work within seven (7) days of receiving the Final Punchlist. Upon completion of the Final Punchlist, the Contractor shall notify the A/E and ODR in writing stating the disposition of each Final Punchlist item. The A/E, Owner and Contractor shall promptly inspect the completed items. When the Final Punchlist is complete, and the Contract is fully satisfied according to the Contract Documents the ODR will issue a certificate establishing the date of Final Completion. Completion of all Work is a condition precedent to the Contractor's right to receive Final Payment.
SITE INSPECTION Where a site inspection is required by the Bid Specifications or Project Definition, Bidder shall be required to inspect the site, including environmental or other conditions for pre-existing deficiencies that may affect the installed Product, equipment, or environment or services to be provided and, which may affect Bidder’s ability to properly deliver, install or otherwise provide the required Product. All inquiries regarding such conditions shall be made in writing. Bidder shall be deemed to have knowledge of any deficiencies or conditions which such inspection or inquiry might have disclosed. Bidder must provide a detailed explanation with its Bid if additional work is required under this clause in order to properly complete the delivery and installation of the required Product or provide the requested service.
Inspection/Testing In order to assess Supplier’s work quality and/or compliance with this Order, upon reasonable notice by Buyer: (a) all goods, materials and services related to the items purchased hereunder, including, raw materials, components, assemblies, work in process, tools and end products shall be subject to inspection and testing by Buyer, its customer, representative or regulatory authorities at all places, including sites where the goods are made or located or the services are performed, whether at Supplier’s premises or elsewhere; and (b) all of Supplier’s facilities, books and records relating to this Order shall be subject to inspection by Buyer or its designee. If specific Buyer and/or Buyer’s customer tests, inspection and/or witness points are included in this Order, the goods shall not be shipped without an inspector’s release or a written waiver of test/inspection/witness with respect to each such point; however, Buyer shall not be permitted to unreasonably delay shipment; and Supplier shall notify Buyer in writing at least twenty (20) days prior to each of Supplier’s scheduled final and, if applicable, intermediate test/inspection/witness points. Supplier agrees to cooperate with such/audit inspection including, completing and returning questionnaires and making available its knowledgeable representatives. Buyer’s failure to inspect or test goods, materials or services or Buyer’s failure to reject or detect defects by inspection or testing shall not relieve Supplier from its warranty obligations or any of its other obligations or responsibilities under this Order. Supplier agrees to provide small business as well as minority and/or women owned business utilization and demographic data upon request.
IN INSPECTION Before, at the time of the Tenant accepting possession, or shortly thereafter, the Landlord and Tenant: (check one)
MOVE-IN INSPECTION Before, at the time of the Tenant accepting possession, or shortly thereafter, the Landlord and Tenant: (check one) ☐ - Agree to inspect the Premises and write any present damages or needed repairs on a move-in checklist. ☐ - Shall not inspect the Premises or complete a move-in checklist.
Property Inspections The Servicer shall conduct property inspections in accordance with the milestones of the repair and rehabilitation plan for such Mortgaged Property and prepare Property Inspection Reports on any Mortgaged Property involving property damage over $15,000. The Servicer shall furnish a copy of the repair and rehabilitation plan for such Mortgaged Property to the Master Servicer upon request.
