Loading Certificate and measuring methods Sample Clauses

Loading Certificate and measuring methods. Seven (7) Days at the latest before the start of the Window of Arrival or at the latest the Day after the Loading, if the Vessel loads less than seven (7) Days before the start of the Window of Arrival, the Shipper shall send the Operator a full Loading Certificate in accordance with Appendix 4, indicating the characteristics of the LNG measured on Loading, on the one hand, expected on Unloading, on the other hand. This certificate shall be sent by email or any other means to the Operator at the address shown in the Specific Conditions. The Shipper shall ensure that the methods used during the Loading to determine the characteristics of the LNG comply with internationally recognised standards. The Operator may ask the Shipper for all of the information defined in Appendix 4 concerning these methods and the Shipper shall be obliged to send it as soon as possible. The Operator may also request verification of these methods by an independent audit company. If this verification highlights a non-compliance, the Shipper shall pay for the verification costs and take the necessary steps to correct the non-compliance(s).
AutoNDA by SimpleDocs

Related to Loading Certificate and measuring methods

  • ODUF Packing Specifications 6.3.1 A pack will contain a minimum of one message record or a maximum of 99,999 message records plus a pack header record and a pack trailer record. One transmission can contain a maximum of 99 packs and a minimum of one pack.

  • Determination of Pass-Through Rates for LIBOR Certificates (a) On each Interest Determination Date so long as any LIBOR Certificates are outstanding, the Trustee will determine LIBOR on the basis of the British Bankers' Association ("BBA") "Interest Settlement Rate" for one-month deposits in U.S. dollars as found on Telerate page 3750 as of 11:00 a.m. London time on each LIBOR Determination Date. "Telerate Page 3750" means the display page currently so designated on the Moneyline Telerate Service (formerly the Dow Jones Markets) (or such other pagx xx may replace that page on that service for the purpose of displaying comparable rates or prices).

  • Determination of Pass-Through Rates for COFI Certificates The Pass-Through Rate for each Class of COFI Certificates for each Interest Accrual Period after the initial Interest Accrual Period shall be determined by the Trustee as provided below on the basis of the Index and the applicable formulae appearing in footnotes corresponding to the COFI Certificates in the table relating to the Certificates in the Preliminary Statement. Except as provided below, with respect to each Interest Accrual Period following the initial Interest Accrual Period, the Trustee shall not later than two Business Days prior to such Interest Accrual Period but following the publication of the applicable Index determine the Pass-Through Rate at which interest shall accrue in respect of the COFI Certificates during the related Interest Accrual Period. Except as provided below, the Index to be used in determining the respective Pass-Through Rates for the COFI Certificates for a particular Interest Accrual Period shall be COFI for the second calendar month preceding the Outside Reference Date for such Interest Accrual Period. If at the Outside Reference Date for any Interest Accrual Period, COFI for the second calendar month preceding such Outside Reference Date has not been published, the Trustee shall use COFI for the third calendar month preceding such Outside Reference Date. If COFI for neither the second nor third calendar months preceding any Outside Reference Date has been published on or before the related Outside Reference Date, the Index for such Interest Accrual Period and for all subsequent Interest Accrual Periods shall be the National Cost of Funds Index for the third calendar month preceding such Interest Accrual Period (or the fourth preceding calendar month if such National Cost of Funds Index for the third preceding calendar month has not been published by such Outside Reference Date). In the event that the National Cost of Funds Index for neither the third nor fourth calendar months preceding an Interest Accrual Period has been published on or before the related Outside Reference Date, then for such Interest Accrual Period and for each succeeding Interest Accrual Period, the Index shall be LIBOR, determined in the manner set forth below. With respect to any Interest Accrual Period for which the applicable Index is LIBOR, LIBOR for such Interest Accrual Period will be established by the Trustee on the related Interest Determination Date as provided in Section 4.08. In determining LIBOR and any Pass-Through Rate for the COFI Certificates or any Reserve Interest Rate, the Trustee may conclusively rely and shall be protected in relying upon the offered quotations (whether written, oral or on the Reuters Screen) from the Reference Banks or the New York City banks as to LIBOR or the Reserve Interest Rate, as appropriate, in effect from time to time. The Trustee shall not have any liability or responsibility to any Person for (i) the Trustee's selection of New York City banks for purposes of determining any Reserve Interest Rate or (ii) its inability, following a good-faith reasonable effort, to obtain such quotations from the Reference Banks or the New York City banks or to determine such arithmetic mean, all as provided for in this Section 4.07. The establishment of LIBOR and each Pass-Through Rate for the COFI Certificates by the Trustee shall (in the absence of manifest error) be final, conclusive and binding upon each Holder of a Certificate and the Trustee.

  • Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.

  • Calculations and Certificates 34.1 ACCOUNTS In any litigation or arbitration proceedings arising out of or in connection with a Finance Document, the entries made in the accounts maintained by a Finance Party are PRIMA FACIE evidence of the matters to which they relate.

  • Changes to Specifications All Specifications and any changes thereto agreed to by the parties from time to time shall be in writing, dated and signed by the parties. Any change to the Process shall be deemed a Specification change. No change in the Specifications shall be implemented by Catalent, whether requested by Client or requested or required by any Regulatory Authority, until the parties have agreed in writing to such change, the implementation date of such change, and any increase or decrease in costs, expenses or fees associated with such change (including any change to Unit Pricing). Catalent shall respond promptly to any request made by Client for a change in the Specifications, and both parties shall use commercially reasonable, good faith efforts to agree to the terms of such change in a timely manner. As soon as possible after a request is made for any change in Specifications, Catalent shall notify Client of the costs associated with such change and shall provide such supporting documentation as Client may reasonably require. Client shall pay all costs associated with such agreed upon changes. If there is a conflict between the terms of this Agreement and the terms of the Specifications, this Agreement shall control. Catalent reserves the right to postpone effecting changes to the Specifications until such time as the parties agree to and execute the required written amendment.

  • Packing Specifications 7.3.1 A pack will contain a minimum of one message record or a maximum of 99,999 message records plus a pack header record and a pack trailer record. One transmission can contain a maximum of 99 packs and a minimum of one pack.

  • Specific Provisions for Access Rights to Software For the avoidance of doubt, the general provisions for Access Rights provided for in this Section 9 are applicable also to Software. Parties’ Access Rights to Software do not include any right to receive source code or object code ported to a certain hardware platform or any right to receive respective Software documentation in any particular form or detail, but only as available from the Party granting the Access Rights.

  • Minimum Customer Support Requirements for TIPS Sales Vendor shall provide timely and commercially reasonable support for TIPS Sales or as agreed to in the applicable Supplemental Agreement.

  • Commercial Operation Date Testing and Modifications Prior to the Commercial Operation Date, the Connecting Transmission Owner shall test the Connecting Transmission Owner’s Attachment Facilities and System Upgrade Facilities and System Deliverability Upgrades and Developer shall test the Large Generating Facility and the Developer Attachment Facilities to ensure their safe and reliable operation. Similar testing may be required after initial operation. Developer and Connecting Transmission Owner shall each make any modifications to its facilities that are found to be necessary as a result of such testing. Developer shall bear the cost of all such testing and modifications. Developer shall generate test energy at the Large Generating Facility only if it has arranged for the injection of such test energy in accordance with NYISO procedures.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!