Local Switching 4.1.1 BellSouth shall provide non-discriminatory access to local circuit switching capability, and local tandem switching capability, on an unbundled basis, except as set forth below in Section 4.1.
Word Usage Words used in the masculine shall apply to the feminine where applicable, and wherever the context of this Agreement dictates, the plural shall be read as the singular and the singular as the plural.
Personal Car Usage 7.1 Personal vehicle usage will be reimbursed in an amount equal to the standard mileage rate allowed by the IRS.
7.2 Per code of Federal Regulations, Title 26, Subtitle A, Chapter 1, Subchapter B, Part IX, Section 274(d), all expense reimbursement requests must include the following:
7.2.1.1 Date
7.2.1.2 Destination
7.2.1.3 Purpose
7.2.1.4 Name of traveler(s)
7.2.1.5 Correspondence that verifies business purpose of the expense
7.3 The mileage for a personal vehicle must document the date, location of travel to/from, number of miles traveled and purpose of trip.
7.4 Mileage will be reimbursed on the basis of the most commonly used route.
7.5 Reimbursement for mileage shall not exceed the cost of a round trip coach airfare.
7.6 Reimbursement for mileage shall be prohibited between place of residence and usual place of work.
7.7 Mileage should be calculated from employee’s regular place of work or their residence, whichever is the shorter distance when traveling to a meeting or traveling to Williamson County, Texas for vendors who are located outside of the Williamson County Courthouse, 000 Xxxx Xxxxxx, Xxxxxxxxxx, Xxxxx 00000 by at least a 45-mile radius.
7.8 When more than one person travels in same vehicle, only one person may claim mileage reimbursement.
7.9 Tolls, if reasonable, are reimbursable. Receipts are required for reimbursement. If a receipt is not obtainable, then written documentation of expense must be submitted for reimbursement (administrative fees on Tolls will not be reimbursed).
7.10 Parking fees, if reasonable are reimbursable for meetings and hotel stays. For vendors who contract with a third party for visitor parking at vendor’s place of business, Williamson County will not reimburse a vendor based on a percentage of its contracted visitor parking fees. Rather, Williamson County will reimburse Vendor for visitor parking on an individual basis for each time a visitor uses Vendor’s visitor parking. Receipts are required for reimbursement. If a receipt is not obtainable, then written documentation of expense must be submitted for reimbursement.
7.11 Operating and maintenance expenses as well as other personal expenses, such as parking tickets, traffic violations, and car repairs and collision damage are not reimbursable.
Excess Usage If during a Billing Period, In Energy is greater than zero (0), then Excess Usage for that Billing Period will be calculated. If Excess Usage is greater than zero (0), then for the Facility and any secondary account at the conclusion of that Billing Period: (i) kilowatt-hour usage will equal the value of Excess Usage and (ii) Unused Credits are equal to zero (0). If Excess Usage is equal to zero (0), then for the Facility and secondary accounts at the conclusion of that Billing Period: (i) kilowatt-hour usage is equal to zero (0) and (ii) Unused Credits are reduced by the value of In Energy, determined for that Billing Period, and that reduced value, in accordance with paragraph (C) Unused Credits of this Article IV, will remain for possible future application.
Originating Switched Access Detail Usage Data A category 1101XX record as defined in the EMI Telcordia Practice BR-010-200- 010.
DNS name server availability Refers to the ability of a public-‐DNS registered “IP address” of a particular name server listed as authoritative for a domain name, to answer DNS queries from an Internet user. All the public DNS-‐registered “IP address” of all name servers of the domain name being monitored shall be tested individually. If 51% or more of the DNS testing probes get undefined/unanswered results from “DNS tests” to a name server “IP address” during a given time, the name server “IP address” will be considered unavailable.
Foreign Exchange Sublimit As part of the Revolving Line, Borrower may enter into foreign exchange contracts with Bank under which Borrower commits to purchase from or sell to Bank a specific amount of Foreign Currency (each, a “FX Forward Contract”) on a specified date (the “Settlement Date”). FX Forward Contracts shall have a Settlement Date of at least one (1) FX Business Day after the contract date and shall be subject to a reserve of ten percent (10%) of each outstanding FX Forward Contract (the “FX Reserve”). The aggregate amount of FX Forward Contracts at any one time may not exceed ten (10) times the lesser of (A) One Million Dollars ($1,000,000), minus (i) the sum of all amounts used for Cash Management Services, and minus (ii) the Dollar Equivalent of the face amount of any outstanding Letters of Credit (including drawn but unreimbursed Letters of Credit and any Letter of Credit Reserve), or (B) the lesser of Revolving Line or the Borrowing Base, minus (i) the sum of all outstanding principal amounts of any Advances (including any amounts used for Cash Management Services), and minus (ii) the Dollar Equivalent of the face amount of any outstanding Letters of Credit (including drawn but unreimbursed Letters of Credit and any Letter of Credit Reserve). The amount otherwise available for Credit Extensions under the Revolving Line shall be reduced by an amount equal to ten percent (10%) of each outstanding FX Forward Contract (the “FX Reduction Amount”). Any amounts needed to fully reimburse Bank for any amounts not paid by Borrower in connection with FX Forward Contracts will be treated as Advances under the Revolving Line and will accrue interest at the interest rate applicable to Advances.
Leave Usage Full shift absences on vacation, sick leave, compensating time off, or holiday in lieu taken by employees on a scheduled twelve-hour workshift shall result in the deduction of twelve (12) hours from the employees’ accrued leave balances.
Tandem Switching 4.5.1 The Tandem Switching capability Network Element is defined as:
(i) trunk-connect facilities, which include, but are not limited to, the connection between trunk termination at a cross-connect panel and switch trunk card; (ii) the basic switch trunk function of connecting trunks to trunks; and (iii) the functions that are centralized in the Tandem Switches (as distinguished from separate end office switches), including but not limited to call recording, the routing of calls to operator services and signaling conversion features.
4.5.2 Where <<customer_short_name>> utilizes portions of the BellSouth network in originating or terminating traffic, the Tandem Switching rates are applied in call scenarios where the Tandem Switching Network Element has been utilized. Because switch recordings cannot accurately indicate on a per call basis when the Tandem Switching Network Element has been utilized for an interoffice call originating from a UNE port and terminating to a BellSouth, Independent Company or Facility-Based CLEC office, BellSouth has developed, based upon call studies, a melded rate that takes into account the average percentage of calls that utilize Tandem Switching in these scenarios. BellSouth shall apply the melded Tandem Switching rate for every call in these scenarios. BellSouth shall utilize the melded Tandem Switching Rate until BellSouth has the capability to measure actual Tandem Switch usage in each call scenario specifically mentioned above, at which point the rate for the actual Tandem Switch usage shall apply. The UNE Local Call Flows set forth on BellSouth's website, as amended from time to time and incorporated herein by this reference, illustrate when the full or melded Tandem Switching rates apply for specific scenarios.
Local Circuit Switching Capability, including Tandem Switching Capability 4.1.3.1 Definition
4.1.3.2 Notwithstanding BellSouth’s general duty to unbundle local circuit switching, BellSouth shall not be required to unbundle local circuit switching for <<customer_name>> when <<customer_name>> serves end-users with four (4) or more voice-grade (DS-0) equivalents or lines in locations served by BellSouth’s local circuit switches, which are in the following MSAs: Atlanta, GA; Miami, FL; Orlando, FL; Ft. Lauderdale, FL; Charlotte-Gastonia-Rock Hill, NC; Greensboro-Winston Salem-High Point, NC; Nashville, TN; and New Orleans, LA, and BellSouth has provided non-discriminatory cost based access to the Enhanced Extended Link (EEL) throughout Density Zone 1 as determined by NECA Tariff No. 4 as in effect on January 1, 1999.
4.1.3.3 In the event that <<customer_name>> orders local circuit switching for a single end user account name at a single physical end user location with four (4) or more 2-wire voice-grade loops from a BellSouth central office in an MSA listed above, BellSouth shall charge <<customer_name>> the market based rate in Exhibit C for use of the local circuit switching functionality for the affected facilities.
4.1.3.4 A featureless port is one that has a line port, switching facilities, and an interoffice port. A featured port is a port that includes all features then capable or a number of then capable features specifically requested by <<customer_name>>. Any features that are not currently then capable but are technically feasible through the switch can be requested through the NBR/BFR process.
4.1.3.5 BellSouth will provide to <<customer_name>> customized routing of calls: (i) to a requested directory assistance services platform; (ii) to an operator services platform pursuant to Section 10 of Attachment 2; (iii) for <<customer_name>>’s PIC’ed toll traffic in a two (2) PIC environment to an alternative OS/DA platform designated by <<customer_name>>. <<customer_name>> customers may use the same dialing arrangements as BellSouth customers.
4.1.3.6 Remote Switching Module functionality is included in Switching Capability. The switching capabilities used will be based on the line side features they support.
4.1.3.7 Switching Capability will also be capable of routing local, intraLATA, interLATA, and calls to international customer’s preferred carrier; call features (e.g. call forwarding) and Centrex capabilities.
4.1.3.8 Where required to do so in order to comply with an effective Commission order, BellSouth will provide to <<customer_name>> purchasing local BellSouth switching and reselling BellSouth local exchange service under Attachment 1, selective routing of calls to a requested directory assistance services platform or operator services platform. <<customer_name>> customers may use the same dialing arrangements as BellSouth customers, but obtain a <<customer_name>> branded service.
