Managed Assets Condition Deficiency Sample Clauses

Managed Assets Condition Deficiency. In the event the final audit establishes a maintenance, repair and replacement deficiency under this Section that requires action in order to comply with Applicable Law or the Permit to Operate, or that could reasonably result in harm to the Transfer Facility or the COUNTY, the CONTRACTOR shall either remedy the deficiency or make a cash payment to the COUNTY sufficient to enable the COUNTY to remedy the deficiency.
AutoNDA by SimpleDocs

Related to Managed Assets Condition Deficiency

  • Performance Deficiency The Department or Customer may, in its sole discretion, notify the Contractor of the deficiency to be corrected, which correction must be made within a time-frame specified by the Department or Customer. The Contractor must provide the Department or Customer with a corrective action plan describing how the Contractor will address all issues of contract non-performance, unacceptable performance, and failure to meet the minimum performance levels, deliverable deficiencies, or contract non-compliance.

  • Surplus; Shortage and Deficiency of Funds In accordance with RESPA, if there is a surplus of Funds held in escrow, Xxxxxx will account to Borrower for such surplus. If Xxxxxxxx’s Periodic Payment is delinquent by more than 30 days, Xxxxxx may retain the surplus in the escrow account for the payment of the Escrow Items. If there is a shortage or deficiency of Funds held in escrow, Lender will notify Borrower and Borrower will pay to Lender the amount necessary to make up the shortage or deficiency in accordance with RESPA. Upon payment in full of all sums secured by this Security Instrument, Xxxxxx will promptly refund to Borrower any Funds held by Xxxxxx.

  • Timber Cut Through Mistake Undesig- nated timber meeting Utilization Standards, cut by Pur- chaser through mistake and included by Contracting Offi- cer under B2.14, shall be removed and paid for at Current Contract Rates and Required Deposits, unless such ma- terial is not listed in A2. In such event, Contracting Offi- cer, in accord with standard Forest Service methods, shall establish rates to be paid.

  • PROJECT CONDITIONS A. The Grantee agrees to the following Project Conditions:

  • SAFETY CONDITIONS 1.0 The responsibility for providing for safe working conditions that are in conformance with applicable law and which are within fiscal constraints shall be the District’s. Employees shall be responsible for complying with safety procedures and practices and for reporting any unsafe condition, facility, or equipment of which he/she is aware. The District shall be responsible for informing employees of necessary safety procedures and practices. There shall be no reprisal against an employee for reporting any real or potentially unsafe condition, facility, or equipment.

  • Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Sub-loop that may diminish the capability of the Loop or Sub-loop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, but are not limited to, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the XxxxXxxxx XX 00000.

  • Test conditions 6.1.1. The test shall be performed on a flat, dry concrete or asphalt surface affording good adhesion.

  • Possible Deficiency Insufficient cooling. Performance Standard – Builder will correct if the cooling system is not capable of maintaining a temperature of 78 degrees Fahrenheit under normal operating conditions. The temperature shall be measured in the center of the room, five feet above the floor. On extremely hot days where outside temperature exceeds 95 degrees Fahrenheit, a difference of 15 degrees from outside temperature will be maintained. All doors must remain open to ensure proper performance and rooms may vary by as much as four degrees and between floors the variance can be as much as 6 degrees. These conditions are specified in the ASHRAE handbook. Homes designed with open foyers, stairways, cathedral ceilings and bonus rooms over garages will usually cause abnormal variations from these standards. Any such variations are specifically excluded from this Warranty.

  • Certification Regarding Debarment, Suspension, Ineligibility and Voluntary Exclusion - Lower Tier Covered Transactions (a) The prospective lower tier participant certifies, by submission of this proposal, that neither it nor its principals is presently debarred, suspended, proposed for debarment, declared ineligible, or voluntarily excluded from participation in this transaction by any federal department or agency.

  • Failure to Make Good a Deficiency If the Contractor does not make good a deficiency within a reasonable space of time fixed in a Notice of Non-Compliant Work, the Owner may do any of the following:

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!