OPERATIVE PROVISIONS In consideration of the disclosure of Proprietary Information by the Disclosing Party, the Receiving Party hereby agrees: (i) to hold the Proprietary Information in strict confidence and to take all reasonable precautions to protect such Proprietary Information (including, without limitation, all precautions the Receiving Party employs with respect to its own confidential materials), (ii) not to disclose any such Proprietary Information or any information derived therefrom to any third person, (iii) not to make any use whatsoever at any time of such Proprietary Information except to evaluate internally its relationship with the Disclosing Party, and (iv) not to copy or reverse engineer any such Proprietary Information. The Receiving Party shall procure that its employees, agents and sub-contractors to whom Proprietary Information is disclosed or who have access to Proprietary Information sign a nondisclosure or similar agreement in content substantially similar to this Agreement
Protective Provisions In addition to any other vote or consent required herein or by law, unless the directors designated by the holders of the shares of the Series A Preferred Stock originally issued under the Purchase Agreement (as defined herein) control the Board of Directors of the Corporation with respect to all actions, for so long as any shares of the Series A Preferred Stock originally issued under the Purchase Agreement remain outstanding (subject to equitable adjustments for stock splits, stock dividends and the like with respect to the Series A Preferred Stock), except where the vote or written consent of the holders of a greater number of shares of the Corporation is required by law or by the Amended and Restated Articles of Incorporation, and in addition to any other vote required by law or by the Amended and Restated Articles of Incorporation, the Corporation shall not, and the Corporation shall cause its subsidiaries not to, as applicable, without the prior vote or written consent of the holders of at least 75% of the shares of the Series A Preferred Stock originally issued under the Purchase Agreement then outstanding: (a) amend the articles or bylaws in any manner that would alter or change any of the rights, preferences, privileges or restrictions of the Series A Preferred Stock or the shares issuable upon conversion of the Series A Preferred Stock; (b) reclassify any outstanding securities into securities having rights, preferences or privileges senior to, or on a parity with, the Series A Preferred Stock; (c) authorize or issue any additional shares of capital stock (other than to holders of the Series A Preferred Stock); (d) merge or consolidate with or into any corporation or other Person; (e) sell all or substantially all their respective assets in a single transaction or series of related transactions; (f) license all or substantially all of their respective intellectual property in a single transaction or series of related transactions; (g) liquidate or dissolve; (h) alter any rights of the holders of the Series A Preferred Stock or change the size of the Board of Directors; (i) declare or pay any dividends (other than dividends payable to the Corporation or its subsidiaries) on or declare or make any other distribution, directly or indirectly, on account of any shares of Common Stock now or hereafter outstanding; (j) repurchase any outstanding shares of capital stock (other than repurchases or redemptions of the Series A Preferred Stock in accordance with the terms hereof); (k) approve or modify by 10% or more the aggregate amount of any annual or other operating or capital budget, or approve or modify by 50% or more any single line item of any such operating or capital budget; (l) increase the salary of any officer or employee or pay any bonus to any officer, director or employee not contemplated in a budget or bonus plan approved by directors designated by the holders of the shares of the Series A Preferred Stock originally issued under the Purchase Agreement then outstanding; (m) retain, terminate or enter into any salary or employment negotiations or employment agreement with any employee or any future employee; (n) incur indebtedness (other than trade payables) or enter into contracts or leases that require payments in excess of $5,000 in the aggregate; (o) make or incur any single capital expenditure; (p) award stock options, stock appreciation rights or similar employee benefits or determine vesting schedules, exercise prices or similar features; (q) make any material change in the nature of its business or enter into any new line of business, joint venture or similar arrangement; (r) pledge its assets or guarantee the obligations of any other individual or entity; (s) recommend approval of any new equity incentive plan; (t) form or acquire any subsidiary, joint venture or similar business entity; or (u) directly or indirectly enter into, or permit to exist, any material transaction with any affiliate of the Corporation, any director or officer or any affiliate of a director or officer, or transfer, pay, loan or otherwise obligate the Corporation to give cash, services, assets or other items of value to affiliates, officers or directors or any affiliate of a officer or director or commit to do any of the preceding after the date hereof, except for employee compensation or for reimbursement of ordinary business expenses.
General Leave Provisions 21.1.1 Except where explicitly noted in Article 00 Xxxxx Xxxxx, the Employer may implement, modify, or eliminate the leaves of absence as outlined in this Article and consistent with all state and federal leave requirements. The Employer reserves the right to modify its Leave of Absence policies. The Employer will inform the Union of any material and substantial changes in its Leave of Absence policies prior to implementation.
Firearm and Ammunition Industries (Tex Gov. Code 2274)
Governing Provisions This Agreement is made under and subject to the provisions of the Plan, and all of the provisions of the Plan are also provisions of this Agreement. If there is a difference or conflict between the provisions of this Agreement and the provisions of the Plan, the provisions of the Plan will govern. By signing this Agreement, the Grantee confirms that he or she has received a copy of the Plan.
Insurance Provisions Prior to the provision of services under this Contract, the Contractor agrees to purchase all required insurance at Contractor’s expense, including all endorsements required herein, necessary to satisfy the County that the insurance provisions of this Contract have been complied with. Contractor agrees to keep such insurance coverage, Certificates of Insurance, and endorsements on deposit with the County during the entire term of this Contract. The County reserves the right to request the declarations pages showing all endorsements and a complete certified copy of the policy. In addition, all Subcontractors performing work on behalf of Contractor pursuant to this Contract shall obtain insurance subject to the same terms and conditions as set forth herein for Contractor. Contractor shall ensure that all Subcontractors performing work on behalf of Contractor pursuant to this Contract shall be covered under Contractor's insurance as an Additional Insured or maintain insurance subject to the same terms and conditions as set forth herein for Contractor. Contractor shall not allow Subcontractors to work if Subcontractors have less than the level of coverage required by County from Contractor under this Contract. It is the obligation of Contractor to provide notice of the insurance requirements to every Subcontractor and to receive proof of insurance prior to allowing any Subcontractor to begin work. Such proof of insurance must be maintained by Contractor through the entirety of this Contract for inspection by County representative(s) at any reasonable time. All self-insured retentions (SIRs) shall be clearly stated on the Certificate of Insurance. Any self- insured retention (SIR) in an amount in excess of Fifty Thousand Dollars ($50,000) shall specifically be approved by the County’s Risk Manager, or designee, upon review of Contractor’s current audited financial report. If Contractor’s SIR is approved, Contractor, in addition to, and without limitation of, any other indemnity provision(s) in this Contract, agrees to all of the following: a. In addition to the duty to indemnify and hold the County harmless against any and all liability, claim, demand or suit resulting from Contractor’s, its agents, employee’s or Subcontractor’s performance of this Contract, Contractor shall defend the County at its sole cost and expense with counsel approved by Board of Supervisors against same; and b. Contractor’s duty to defend, as stated above, shall be absolute and irrespective of any duty to indemnify or hold harmless; and c. The provisions of California Civil Code Section 2860 shall apply to any and all actions to which the duty to defend stated above applies, and the Contractor’s SIR provision shall be interpreted as though the Contractor was an insurer and the County was the insured. Upon notice of any actual or alleged claim or loss arising out of Subcontractor’s work hereunder, Subcontractor shall immediately satisfy in full the SIR provisions of the policy in order to trigger coverage for the Contractor and Additional Insureds. If the Contractor fails to maintain insurance acceptable to the County for the full term of this Contract, the County may terminate this Contract.
CLOSING PROVISIONS (a) Subscriber agrees to be identified as a customer of JetBrains and agrees that JetBrains may refer to Subscriber by name, trade name and trademark, if applicable, and may briefly describe Subscriber’s business in JetBrains marketing materials, on JetBrains Site, and in public or legal documents. Subscriber hereby grants JetBrains a worldwide, non- exclusive, royalty-free license to use Subscriber’s name and any of Subscriber’s trade names and trademarks solely pursuant to this marketing section. (b) This Agreement is governed by the laws of the Czech Republic. All disputes arising from the present Agreement and/or in connection with it shall be finally brought to and decided by any relevant competent common court in the Czech Republic. The parties agree that the United Nations Convention on Contracts for the International Sale of Goods does not apply to this Agreement. (c) JetBrains may modify this Agreement at any time by posting a revised version of the Agreement on JetBrains Site. The modified terms will become effective upon posting of a revised version of the Agreement on JetBrains Site. By continuing to use Service after the effective date of any modification to this Agreement, Subscriber agrees to be bound by the modified terms. It is Subscriber’s responsibility to check JetBrains Site regularly for modifications to this Agreement. (d) The parties are independent contractors. This Agreement does not create a partnership, franchise, joint venture, agency, or a fiduciary or employment relationship between the parties. (e) Sections 7, 8, 9, 10, 12 (c), 12(d), 14(a), 14(b), and 14(c) shall survive any termination or expiration of this Agree- ment. (f) There are no third-party beneficiaries to this Agreement. (g) If any provision of this Agreement is held by a court of competent jurisdiction to be contrary to law, the provision shall be modified by the court and interpreted so as best to accomplish the objectives of the original provision to the fullest extent permitted by law, and the remaining provisions of this Agreement shall remain in effect.
Charter Provisions Each Seller Entity shall take all necessary action to ensure that the entering into of this Agreement and the consummation of the Merger and the other transactions contemplated hereby do not and will not result in the grant of any rights to any Person under the Articles of Incorporation, Bylaws, or other governing instruments of any Seller Entity or restrict or impair the ability of Buyer or any of its Subsidiaries to vote, or otherwise to exercise the rights of a shareholder with respect to, shares of any Seller Entity that may be directly or indirectly acquired or controlled by them.
Leave Provisions Clause No. Title
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “ (1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “ (1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.