METAL DOORS AND FRAMES. All interior base building door frames shall be welded type or three piece, pressed metal, single and/or double rabbet door frames with proper anchors for partitions. Provide fire rated frames as required by code.
METAL DOORS AND FRAMES Sample Clauses
Related to METAL DOORS AND FRAMES
Income Protection, Trauma and Journey Insurance The Employer is, and will remain during the life of this Agreement, a participating employer in the Nominated Redundancy Fund and an employer member of IPT Agency Co Ltd. IPT Agency Co Ltd administers the insurance schemes covering income protection, trauma and journey accidents (Income Protection, Trauma and Journey Accidents Insurance Schemes).
Access to PHI Business Associate shall provide access to PHI in a Designated Record Set to Covered Entity or as directed by Covered Entity to an Individual to meet the requirements under 45 CFR § 164.524. Business Associate shall provide such access in the time and manner reasonably designated by Covered Entity. Within three (3) business days, Business Associate shall forward to Covered Entity for handling any request for access to PHI that Business Associate directly receives from an Individual.
Information Technology Enterprise Architecture Requirements If this Contract involves information technology-related products or services, the Contractor agrees that all such products or services are compatible with any of the technology standards found at xxxxx://xxx.xx.xxx/iot/2394.htm that are applicable, including the assistive technology standard. The State may terminate this Contract for default if the terms of this paragraph are breached.
Access to NID 2.7.3.1 NewPhone may access the customer’s premises wiring by any of the following means and NewPhone shall not disturb the existing form of electrical protection and shall maintain the physical integrity of the NID: 2.7.3.1.1 BellSouth shall allow NewPhone to connect its Loops directly to BellSouth’s multi-line residential NID enclosures that have additional space and are not used by BellSouth or any other telecommunications carriers to provide service to the premises; 2.7.3.1.2 Where an adequate length of the customer’s premises wiring is present and environmental conditions permit, either Party may remove the customer premises wiring from the other Party’s NID and connect such wiring to that Party’s own NID; 2.7.3.1.3 Either Party may enter the subscriber access chamber or dual chamber NID enclosures for the purpose of extending a cross-connect or spliced jumper wire from the customer premises wiring through a suitable “punch-out” hole of such NID enclosures; or 2.7.3.1.4 NewPhone may request BellSouth to make other rearrangements to the customer premises wiring terminations or terminal enclosure on a time and materials cost basis. 2.7.3.2 In no case shall either Party remove or disconnect the other Party’s loop facilities from either Party’s NIDs, enclosures, or protectors unless the applicable Commission has expressly permitted the same and the disconnecting Party provides prior notice to the other Party. In such cases, it shall be the responsibility of the Party disconnecting loop facilities to leave undisturbed the existing form of electrical protection and to maintain the physical integrity of the NID. It will be NewPhone’s responsibility to ensure there is no safety hazard, and NewPhone will hold BellSouth harmless for any liability associated with the removal of the BellSouth Loop from the BellSouth NID. Furthermore, it shall be the responsibility of the disconnecting Party, once the other Party’s loop has been disconnected from the NID, to reconnect the disconnected loop to a nationally recognized testing laboratory listed station protector, which has been grounded as per Article 800 of the National Electrical Code. If no spare station protector exists in the NID, the disconnected loop must be appropriately cleared, capped and stored. 2.7.3.3 NewPhone shall not remove or disconnect ground wires from BellSouth’s NIDs, enclosures, or protectors. 2.7.3.4 NewPhone shall not remove or disconnect NID modules, protectors, or terminals from BellSouth’s NID enclosures. 2.7.3.5 Due to the wide variety of NID enclosures and outside plant environments, BellSouth will work with NewPhone to develop specific procedures to establish the most effective means of implementing this section if the procedures set forth herein do not apply to the NID in question.
CLOTHING AND EQUIPMENT (a) Employees required by the Employer to wear uniforms will be supplied with an adequate number of uniforms appropriate to the occupation free of cost to Employees. Such items are to remain the property of the Employer and be laundered and maintained by such Employer free of cost to the Employee. (b) Instead of the provision of such uniforms, the Employer may, by agreement with the Employee, pay such Employee a uniform allowance at the rate set out in Item 1 of Table 5. This rate is expressed as per shift or part thereof, or as a weekly rate – an Employee is to be paid whichever is the lesser amount. (c) Where an Employee’s uniforms are not laundered by or at the expense of the Employer, the Employee will be paid a laundry allowance. For Aged Care, Health Professionals and Home Care Employees this will be paid at the rate set out in Item 2 of Table 5. This allowance is also expressed as a payment per shift of part thereof of as a weekly payment – an Employee is to be paid whichever is the lesser amount. For Nursing Employees this will be paid at the rate set out in Item 3 of Table 5. (d) The uniform allowance, but not the laundry allowance, will be paid during all absences on paid leave, except absences on long service leave and absence on personal/carer’s leave beyond 21 days. Where, prior to the taking of leave, an Employee was paid a uniform allowance other than at the weekly rate, the rate to be paid during absence on leave will be the average of the allowance paid during the four weeks immediately preceding the taking of leave. (e) Where an Employer requires an Employee to wear rubber gloves, special clothing or where safety equipment is required for the work performed by an Employee, the Employer must reimburse the Employee for the cost of purchasing such special clothing or safety equipment, except where such clothing or equipment is provided by the Employer.
Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers. 5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem. 5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.
Cleanliness and Safety; Entry Resident agrees to maintain the assigned bedroom space, the apartment and the common areas of the Property in a clean, safe and sanitary condition, to exercise all due care in the use of same, and to cooperate fully with the Property pest control program as requested. Resident will be responsible for the cost of treatment for bedbugs and similar pests to the extent Owner’s pest control vendor reasonably determines that an infestation has originated within Resident’s assigned space and during Resident’s occupancy. Resident will place all trash in provided receptacles and will be responsible for the cost of cleaning the interior or exterior of the apartment if not kept in sanitary condition. When outdoor temperatures are below 40 degrees Fahrenheit, Resident will keep the apartment’s heat turned on to prevent frozen or burst pipes, including during vacations. When outdoor temperatures exceed 85 degrees Fahrenheit, Resident will keep the apartment’s air conditioning turned on and set to a reasonable temperature to prevent mold or mildew growth, including during vacations. Owner and its agents, employees and contractors may enter any apartment and bedroom space to perform routine maintenance, inspections, showings and other ordinary functions, provided that Owner will provide advance notice to residents of an apartment before such entry. Owner reserves the right to enter an apartment and any bedroom space without prior notice (including a passkey and/or disarming the alarm or other means of entry if locks have been changed) for emergency maintenance or repair purposes, or when there is reasonable cause to believe that a situation exists that could cause danger to life, safety, health or property. Owner may confiscate any item deemed to cause a danger and is under no obligation to pay compensation for or to return such items.
Provisions governing staff and subcontractors A. To require any subcontractor to execute documents that binds the subcontractor to comply with the provisions of this Contract. Subcontractor means an individual or entity to which the Contractor has contracted with or delegated some of its management functions or responsibilities of providing all or a part of the services required of the Contractor under this Contract. B. That it is responsible for the behavior of its staff and subcontractors to ensure a violence-free contractual relationship. The Contractor understands that any remarks, gestures or actions toward HHSC employees, volunteers or clients that carry an implied threat of any kind, even if intended to be in jest, will be taken seriously and may lead to corrective action, up to and including terminating this contractor. C. To comply with the requirements of the Immigration Reform and Control Act of 1986 regarding employment verification and retention of verification forms for an individual hired on or after November 6, 1986, who will perform any labor or services under this Contract. D. To certify and ensure that it utilizes and will continue to utilize, for the term of this Contract, the U. S. Department of Homeland Security's e- Verify system to determine the eligibility of: 1. all people employed during the Contract term to perform duties within Texas; and 2. all people (including subcontractors). E. That representatives of HHSC, AG-MFCU and HHS may conduct interviews of Contractor personnel, subcontractors and their personnel, witnesses, and clients without a Contractor's representative present unless the person interviewed voluntarily requests that the representative be present. The Contractor must not coerce its personnel, subcontractors and their personnel, witnesses, or clients to accept representation by the Contractor, and the Contractor agrees that no retaliation will occur to a person who denies the Contractor's offer of representation. Nothing in the Contract limits a person's right to counsel of his or her choice. Requests for interviews are to be complied with in the form and the manner requested. The Contractor must ensure by contract or other means that its personnel and subcontractors cooperate fully in any investigation conducted by representatives of HHSC, AG-MFCU and HHS. F. That if it is a Home and Community Support Services agency ("HCSSA"), the Contractor will hire Personal Assistance Services and Community Support Services providers chosen by the client or the client's legally authorized representative, if requested, and provided the individual who will provide the services: 1. meets minimum qualifications for the service; 2. is willing to be employed as an attendant by the Contractor; and 3. is willing, and determined competent by the Contractor, to deliver the service(s) according to the client's individual service plan.
Registry Interoperability and Continuity Registry Operator shall comply with the Registry Interoperability and Continuity Specifications as set forth in Specification 6 attached hereto (“Specification 6”).
Moonlighting Employment as a physician in a professional capacity outside of what is outlined in this Agreement, whether temporary special medical activity (“TSMA”) or external moonlighting, must be approved in writing, in advance, by the Departmental Chair, Program Director and Director of Graduate Medical Education (or designee). Even if approved, professional and general liability insurance as outlined in Section 5.4 is not provided to Trainee engaged in external moonlighting. Trainee acknowledges he or she has the responsibility to obtain insurance for such engagement. TSMA and external moonlighting must be included and reported as part of Trainee's hours spent on clinical experience and education. Trainee shall not be required to engage in any outside work.
