Shipping Axon may make partial shipments and ship Axon Devices from multiple locations. All shipments are FOB shipping point via common carrier. Title and risk of loss pass to Agency upon Axon’s delivery to the common carrier. Agency is responsible for any shipping charges in the Quote.
Packaging and Shipping All shipping containers shall be packed and packaged to: (i) ensure safe arrival to final destination; (ii) secure the lowest transportation costs;(iii) comply with requirements of common carriers; (iv) meet Buyer's written instructions; and (v) meet the requirements of all applicable laws, ordinances, rules and regulations.
Drop Shipped Off loaded by carrier to an Agency loading dock or designated area. There will be no charge to the ordering Agency for this delivery method.
PACKING AND SHIPPING a. Seller shall pack the goods and materials to prevent damage and deterioration. Unless otherwise set forth in this Contract, Seller shall package the goods in accordance with the requirements of Boeing Document D37522-6 “Supplier Packaging”. Buyer may charge Seller for damage to or deterioration of any goods resulting from improper packing or packaging. b. If the Contract specifies FOB destination (place of delivery), then in addition to any other shipping instructions, Seller shall forward goods freight prepaid. Seller shall make the transportation arrangements, pay the shipping costs, and remain responsible for the goods and materials until the goods and materials are delivered and the Buyer takes possession at the destination. c. If the Contract specifies FOB origin (place of shipment), then in addition to any other shipping instructions, Seller shall forward goods collect. For goods shipped within the United States, Seller shall make no declaration concerning the value of the goods shipped except on goods where the tariff rating is dependent upon released or declared value. In such event, Seller shall release or declare such value at the maximum value within the lowest rating. Seller will ship the goods in accordance with the provisions set forth in the Boeing Domestic Shipment Routing Guide to be accessed through Buyer’s supplier portal at xxxxx://xxxxxx.xxxxxxx.xxx/. Sellers need a One Time Password (OTP) token to log into the Boeing Supplier Portal. Upon Xxxxx’s request, Seller will identify packaging charges showing material and labor costs for container fabrication. d. Seller shall provide with each container shipped under this Contract an Advanced Shipping Notice (“ASN”). For each container shipped, Seller shall provide two (2) readable copies of the ASN barcode as follows: one (1) copy is to be securely affixed to the outside of each container and one (1) copy is to be loose inside each container. Non- conforming shipments are subject to rejection and repackaging at Seller’s expense. Instructions and guidelines related to the ASN process can be found on the Boeing Supplier Portal. Seller shall access by selecting the “Enterprise ASN Instructions” hyper-link under the header “Exostar Resources”. A copy of these instructions can also be found at xxx.xxxxxxx.xxx.
Bulk Migration 2.1.9.1 If Southern Telecom requests to migrate twenty-five (25) or more UNE- Port/Loop Combination (UNE-P) customers to UNE-Loop (UNE-L) in the same Central Office on the same due date, Southern Telecom must use the Bulk Migration process, which is described in the BellSouth CLEC Information Package, “UNE-Port/Loop Combination (UNE-P) to UNE-Loop (UNE-L) Bulk Migration.” This CLEC Information package, incorporated herein by reference as it may be amended from time to time, is located at xxx.xxxxxxxxxxxxxxx.xxxxxxxxx.xxx/xxxxxx/xxxx/xxxx.xxxx. The rates for the Bulk Migration process shall be the nonrecurring rates associated with the Loop type being requested on the Bulk Migration, as set forth in Exhibit A of this Attachment. Additionally, OSS charges will also apply per LSR generated per customer account as provided for in the Bulk Migration Request. The migration of loops from Integrated Digital Loop Carrier (IDLC) will be done pursuant to Section 2.6 of this Attachment.
Vessels (A) All of the vessels described in the Registration Statement, the General Disclosure Package and the Prospectus, except for the Contracted Vessels (each of which a Subsidiary has contracted to acquire), are owned directly by Subsidiaries); each of the vessels listed on Schedule F-1 (the “Owned Vessels”) hereto has been duly registered as a vessel under the laws and regulations and flag of the jurisdiction set forth opposite its name on Schedule F-1 in the sole ownership of the Subsidiary set forth opposite its name on Schedule F-1 and no other action is necessary to establish and perfect such entity’s title to and interest in such vessel as against any charterer or third party; each such Subsidiary has good title to the applicable Owned Vessel, free and clear of all mortgages, pledges, liens, security interests and claims and all defects of the title of record except for those liens arising under Credit Facilities, each as disclosed in the Registration Statement, the General Disclosure Package and the Prospectus, and such other encumbrances which would not, in the aggregate, result in a Material Adverse Effect; and each such Owned Vessel is in good standing with respect to the payment of past and current taxes, fees and other amounts payable under the laws of the jurisdiction where it is registered as would affect its registry with the ship registry of such jurisdiction except for failures to be in good standing which would not, in the aggregate, result in a Material Adverse Effect. Upon delivery to and acceptance by the relevant Subsidiary under the MoAs and the Newbuilding Contracts described in the Registration Statement, General Disclosure Package and Prospectus, each of the vessels listed on Schedule F-2 hereto and specified as being under contract (the “Contracted Vessels”) for delivery to and acceptance by a Subsidiary will be duly registered as a vessel under the laws of the jurisdiction set forth opposite its name on Schedule F-2, or under the laws of a generally accepted shipping industry flag jurisdiction, in the sole ownership of the Subsidiary set forth opposite its name on Schedule F-2, on such date, each such Subsidiary will have good title to the applicable Contracted Vessel, free and clear of all mortgages, pledges, liens, security interests, claims and all defects of the title of record, except for any mortgages, pledges, liens, security interests or claims arising from any financing arrangement which the Company or Subsidiary may enter to finance the acquisition of the Contracted Vessel and except such encumbrances which would not, in the aggregate, result in a Material Adverse Effect; and each such Contracted Vessel will be in good standing with respect to the payment of past and current taxes, fees and other amounts payable under the laws of the jurisdiction where it is registered as would affect its registry with the ship registry of such jurisdiction. (B) Each Owned Vessel is, and the Company will use reasonable commercial efforts to ensure that each Contracted Vessel will be, operated in compliance with the rules, codes of practice, conventions, protocols, guidelines or similar requirements or restrictions imposed, published or promulgated by any Governmental Authority, classification society or insurer applicable to the respective vessel (collectively, “Maritime Guidelines”) and all applicable international, national, state and local conventions, laws, regulations, orders, Governmental Licenses and other requirements (including, without limitation, all Environmental Laws), except where such failure to be in compliance would not have, individually or in the aggregate, a Material Adverse Effect. The Company and each applicable Subsidiary are, and with respect to the Contracted Vessels will be, qualified to own or lease, as the case may be, and operate such vessels under all applicable international, national, state and local conventions, laws, regulations, orders, Governmental Licenses and other requirements (including, without limitation, all Environmental Laws) and Maritime Guidelines, including the laws, regulations and orders of each such vessel’s flag state, except where such failure to be so qualified would not have, individually or in the aggregate, a Material Adverse Effect. (C) Each Owned Vessel is, and each Contracted Vessel will be, classed by any of Lloyd’s Register of Shipping, American Bureau of Shipping, Det Norske Veritas or a classification society which is a full member of the International Association of Classification Societies and each Owned Vessel is, and the Company will use reasonable commercial efforts to ensure each Contracted Vessel will be, in class with valid class and trading certificates, without any overdue recommendations.
Load Shedding The systematic reduction of system demand by temporarily decreasing Load in response to a transmission system or area Capacity shortage, system instability, or voltage control considerations under the ISO OATT. Local Furnishing Bonds. Tax-exempt bonds issued by a Transmission Owner under an agreement between the Transmission Owner and the New York State Energy Research and Development Authority (“NYSERDA”), or its successor, or by a Transmission Owner itself, and pursuant to Section 142(f) of the Internal Revenue Code, 26 U.S.C. § 142(f). Locality. A single LBMP Load Zone or set of adjacent LBMP Load Zones within one Transmission District within which a minimum level of Installed Capacity must be maintained. Local Reliability Rule. A Reliability Rule established by a Transmission Owner, and adopted by the NYSRC to meet specific reliability concerns in limited areas of the NYCA, including without limitation, special conditions and requirements applicable to nuclear plants and special requirements applicable to the New York City metropolitan area. Locational Based Marginal Pricing (“LBMP”). A pricing methodology under which the price of Energy at each location in the NYS Transmission System is equivalent to the cost to supply the next increment of Load at that location (i.e., the short-run marginal cost). The short-run marginal cost takes generation Bid Prices and the physical aspects of the NYS Transmission System into account. The short-run marginal cost also considers the impact of Out-of-Merit Generation (as measured by its Bid Price) resulting from the Congestion and Marginal Losses occurring on the NYS Transmission System which are associated with supplying an increment of Load. The term LBMP also means the price of Energy bought or sold in the LBMP Markets at a specific location.
PACKING AND SHIPMENT (a) Unless otherwise specified, all Work is to be packed in accordance with good commercial practice. (b) A complete packing list shall be enclosed with all shipments. SELLER shall mark containers or packages with necessary lifting, loading, and shipping information, including the LOCKHEED XXXXXX Contract number, item number, dates of shipment, and the names and addresses of consignor and consignee. Bills of lading shall include this Contract number. (c) Unless otherwise specified, delivery shall be FOB Place of Shipment.
SHIPPING AND SHIPPING COSTS All delivered Equipment and Products must be properly packaged. Damaged Equipment and Products may be rejected. If the damage is not readily apparent at the time of delivery, Supplier must permit the Equipment and Products to be returned within a reasonable time at no cost to Sourcewell or its Participating Entities. Participating Entities reserve the right to inspect the Equipment and Products at a reasonable time after delivery where circumstances or conditions prevent effective inspection of the Equipment and Products at the time of delivery. In the event of the delivery of nonconforming Equipment and Products, the Participating Entity will notify the Supplier as soon as possible and the Supplier will replace nonconforming Equipment and Products with conforming Equipment and Products that are acceptable to the Participating Entity. Supplier must arrange for and pay for the return shipment on Equipment and Products that arrive in a defective or inoperable condition. Sourcewell may declare the Supplier in breach of this Contract if the Supplier intentionally delivers substandard or inferior Equipment or Products.
Safety Glasses Section 1. The City shall supply prescription safety glasses with plastic lenses to employees who are required to wear safety glasses and who are members of the classifications contained in Appendix C to this contract. Safety glasses which are authorized must be industrial grade safety glasses which meet or exceed the requirements of ANSI Specification Z87. 1. All employees who are required to wear safety glasses shall also be required to wear side xxxxxxx, either permanent or snap-on, whenever an eye hazard exists. Solid tinted glasses will not be approved unless required by prescription. Photogray, progressive, scratch coating and/or anti-glare lenses may be considered for those employees who primarily work outdoors or as prescribed. In the event that additional classes are identified as needing either prescription safety glasses or protective eyewear, such classes may be added to the classification list in Appendix C upon approval of PAGE and the City. Section 2. The City agrees to pay the full cost of required prescription safety glasses, with frames not to exceed $75.00. This excludes the cost of the eye examination which will be the responsibility of the employee. The effected employees will be allowed one (1) replacement of safety glasses every two (2) years. In the event the safety glasses become lost, unserviceable, or broken on the job, the employee must present a written request for replacement to the Department Head and Human Resources Director. If the employee breaks his safety glasses while on the job, the Department shall replace the glasses at no cost to the employee. The replacement of lost glasses or glasses that are broken off the job will be at the discretion of the Department Head and Human Resources Director. If an employee has been provided safety glasses by the City, the employee shall be permitted to retain possession of the glasses after separation from the City without reimbursing the City for any costs associated with the glasses. Section 3. An employee who is required to wear prescription safety glasses must present a written request to his department head or designated representative. Section 4. The employee must obtain a current prescription and the employee is authorized the use of sick leave not to exceed two (2) hours to accomplish this examination. The employee will obtain a purchase order from the Department Head prior to ordering the safety glasses. The employee will present the purchase order to the appropriate vendor when ordering. The vendor will contact the appropriate Department Head when the glasses are ready for delivery. The Department Head will then notify the employee who will present himself at the vendor for fitting and pickup. Section 5. In the event a probationary employee has been issued safety glasses and terminates his employment with the City for any reason during the probationary period, he shall be required to reimburse the City for any expenses incurred in the purchase of safety glasses.
