Shift Workers All shift workers (i.e. workers whose shift commences at or after the end of the ordinary day work hours) presenting for work when the temperature is at or over 35°C will remain on site in air conditioned amenities for a minimum two hours, holding themselves available to commence work should the temperature fall below 35°C.
CONTRACT WORK HOURS AND SAFETY STANDARDS As per the Contract Work Hours and Safety Standards Act (40 U.S.C. 3701-3708), where applicable, all Customer Purchase Orders in excess of ,000 that involve the employment of mechanics or laborers must include a provision for compliance with 40 U.S.C. 3702 and 3704, as supplemented by Department of Labor regulations (29 CFR Part 5). Under 40 U.S.C. 3702 of the Act, each contractor must be required to compute the wages of every mechanic and laborer on the basis of a standard work week of 40 hours. Work in excess of the standard work week is permissible provided that the worker is compensated at a rate of not less than one and a half times the basic rate of pay for all hours worked in excess of 40 hours in the work week. The requirements of 40 U.S.C. 3704 are applicable to construction work and provide that no laborer or mechanic must be required to work in surroundings or under working conditions which are unsanitary, hazardous or dangerous. These requirements do not apply to the purchases of supplies or materials or articles ordinarily available on the open market, or contracts for transportation or transmission of intelligence.
Contract Work Hours and Safety Standards Act The following clauses apply to any Federal-aid construction contract in an amount in excess of $100,000 and subject to the overtime provisions of the Contract Work Hours and Safety Standards Act. These clauses shall be inserted in addition to the clauses required by 29 CFR 5.5(a) or 29 CFR 4.6. As used in this paragraph, the terms laborers and mechanics include watchmen and guards.
Period of Work Work under this Agreement shall begin no sooner than the date on which this Agreement has been fully executed by the parties and approved by the Controller and the State Purchases Review Committee. Unless terminated earlier, this Agreement shall expire on the date set out on the first page of this Agreement, or at the completion and acceptance of all specified tasks, and delivery of all contracted products and services as defined in this Agreement, including performance of any warranty and/or maintenance agreements, whichever is the later date.
PROTECTION OF WORK 12.1 Subcontractor shall effectually secure and protect the work done hereunder and assume full responsibility for the condition thereof until final acceptance by the OWNER and Contractor. Subcontractor further agrees to provide such protection as is necessary to protect the work and the workmen of Contractor, the OWNER, and other subcontractors from its operations. 12.2 Subcontractor shall be liable for any loss or damage to any work in place or to any equipment and materials on the job site caused by Subcontractor or its agents, employees or guests.
Subproviders and Suppliers List Pursuant to requirements of 43 Texas Administrative Code §9.350 et seq., the Engineer must provide the State a list (Exhibit H-5/DBE or Exhibit H-6/HUB) of all Subproviders and suppliers that submitted quotes or proposals for subcontracts. This list shall include subproviders and suppliers names, addresses, telephone numbers, and type of work desired.
Anti-Money Laundering and Red Flag Identity Theft Prevention Programs The Trust acknowledges that it has had an opportunity to review, consider and comment upon the written procedures provided by USBFS describing various tools used by USBFS which are designed to promote the detection and reporting of potential money laundering activity and identity theft by monitoring certain aspects of shareholder activity as well as written procedures for verifying a customer’s identity (collectively, the “Procedures”). Further, the Trust and USBFS have each determined that the Procedures, as part of the Trust’s overall Anti-Money Laundering Program and Red Flag Identity Theft Prevention Program, are reasonably designed to: (i) prevent each Fund from being used for money laundering or the financing of terrorist activities; (ii) prevent identity theft; and (iii) achieve compliance with the applicable provisions of the Bank Secrecy Act, Fair and Accurate Credit Transactions Act of 2003 and the USA Patriot Act of 2001 and the implementing regulations thereunder. Based on this determination, the Trust hereby instructs and directs USBFS to implement the Procedures on the Trust’s behalf, as such may be amended or revised from time to time. It is contemplated that these Procedures will be amended from time to time by the parties as additional regulations are adopted and/or regulatory guidance is provided relating to the Trust’s anti-money laundering and identity theft responsibilities. USBFS agrees to provide to the Trust: (a) Prompt written notification of any transaction or combination of transactions that USBFS believes, based on the Procedures, evidence money laundering or identity theft activities in connection with the Trust or any Fund shareholder; (b) Prompt written notification of any customer(s) that USBFS reasonably believes, based upon the Procedures, to be engaged in money laundering or identity theft activities, provided that the Trust agrees not to communicate this information to the customer; (c) Any reports received by USBFS from any government agency or applicable industry self-regulatory organization pertaining to USBFS’ Anti-Money Laundering Program or the Red Flag Identity Theft Prevention Program on behalf of the Trust; (d) Prompt written notification of any action taken in response to anti-money laundering violations or identity theft activity as described in (a), (b) or (c) immediately above; and (e) Certified annual and quarterly reports of its monitoring and customer identification activities pursuant to the Procedures on behalf of the Trust. The Trust hereby directs, and USBFS acknowledges, that USBFS shall (i) permit federal regulators access to such information and records maintained by USBFS and relating to USBFS’ implementation of the Procedures, on behalf of the Trust, as they may request, and (ii) permit such federal regulators to inspect USBFS’ implementation of the Procedures on behalf of the Trust.
Safe Workplace A) The Employer and employees recognize the need for a safe and healthful workplace and agree to take appropriate measures in order that risks of accidents and/or occupational disease are reduced and/or eliminated. Employers will take all reasonable steps to eliminate, reduce and/or minimize threats to the safety of employees. B) An employee performing visitation to clients in the community shall have the right to request backup to attend where there is reasonable cause to expect a violent situation and will have access to appropriate communication equipment. C) When the Employer is aware that a patient/resident/client has a history of violent behaviour, the Employer shall make such information available to the employee. Upon admission or transfer the Employer will make every reasonable effort to identify the potential for aggressive behaviour. In- services and/or instruction in caring for the violent patient will be provided by the Employer. D) The Employer will provide orientation and/or in-service which is necessary for the safe performance of work including universal precautions, the safe use of equipment, safe techniques for lifting and supporting patients/residents/clients and the safe handling of materials and products. The Employer will also make readily available information, manuals and procedures for these purposes. The Employer will provide appropriate safety clothing and equipment.
PROPRIETARY/RESTRICTIVE SPECIFICATIONS If a prospective bidder considers the specification contained herein to be proprietary or restrictive in nature, thus potentially resulting in reduced competition, they are urged to contact the Procurement Division prior to bid opening. Specifications which are unrelated to performance will be considered for deletion via addendum to this Invitation for Bids.
Contract Work Contract work means capital project work within existing plant facilities, major maintenance and/or revamp work, plant modifications and/or shutdown work, minor maintenance and/or repair work, breakdown maintenance.
