OBD test procedure Sample Clauses

Open Split View

Download

Share

Cite

OBD test procedure. 6.1. The operating cycle on the chassis dynamometer shall meet the requirements of Annex 4a to this Regulation.

Sample 1

Save

Copy

Related to OBD test procedure

• Test procedure The engine speed shall be gradually increased from idle to the target engine speed, not exceeding the tolerance band of ±3 per cent of the target engine speed, and held constant. Then the throttle control shall be rapidly released and the engine speed shall be returned to idle. The sound pressure level shall be measured during a period of operation consisting of a maintaining constant engine speed of 1 second and throughout the entire deceleration period. The maximum sound level meter reading during this period of operation, mathematically rounded to the first decimal place, is taken as the test value.

• Test Procedures For an Asset Review, the Asset Representations Reviewer will perform for each Asset Review Receivable the procedures listed under “Procedures to be Performed” in Schedule A for each representation and warranty (each, a “Test”), using the Asset Review Materials listed for each such Test in Schedule A. For each Test and Asset Review Receivable, the Asset Representations Reviewer will determine if the Test has been satisfied (a “Test Pass”) or if the Test has not been satisfied (a “Test Fail”).

• Acceptance Testing At the time of installation of a LIS trunk group, and at no additional charge, acceptance tests will be performed to ensure that the service is operational and meets the applicable technical parameters.

• Payment Procedure (a) The Lead Securitization Note Holder (or the Master Servicer acting on its behalf), in accordance with the priorities set forth in Section 3 and subject to the terms of the Lead Securitization Servicing Agreement, shall deposit or cause to be deposited all payments allocable to the Notes to the Collection Account and/or related Companion Distribution Account (each as defined in the Lead Securitization Servicing Agreement) pursuant to and in accordance with the Lead Securitization Servicing Agreement. The Lead Securitization Note Holder (or the Master Servicer acting on its behalf) shall deposit such payments to the applicable account within one Business Day of receipt of properly identified and available funds by the Lead Securitization Note Holder (or the Master Servicer acting on its behalf) from or on behalf of the Mortgage Loan Borrower (provided, that to the extent that any payment is received after 2:00 p.m. (Eastern Time) on any given Business Day, the Master Servicer is required to use commercially reasonable efforts to deposit such payments into the applicable account within one (1) Business Day of receipt of such properly identified and available funds but, in any event, the Master Servicer is required to deposit such payments into the applicable account within two (2) Business Days of receipt of such properly identified and available funds). (b) If the Lead Securitization Note Holder determines, or a court of competent jurisdiction orders, at any time that any amount received or collected in respect of any Note must, pursuant to any insolvency, bankruptcy, fraudulent conveyance, preference or similar law, be returned to the Mortgage Loan Borrower or paid to any Note Holder or any Servicer or paid to any other Person, then, notwithstanding any other provision of this Agreement, the Lead Securitization Note Holder shall not be required to distribute any portion thereof to any Non-Lead Securitization Note Holder and each Non-Lead Securitization Note Holder shall promptly on demand by the Lead Securitization Note Holder repay to the Lead Securitization Note Holder any portion thereof that the Lead Securitization Note Holder shall have theretofore distributed to such Non-Lead Securitization Note Holder, together with interest thereon at such rate, if any, as the Lead Securitization Note Holder shall have been required to pay to any Mortgage Loan Borrower, Master Servicer, Special Servicer or such other Person with respect thereto. (c) If, for any reason, the Lead Securitization Note Holder makes any payment to any Non-Lead Securitization Note Holder before the Lead Securitization Note Holder has received the corresponding payment (it being understood that the Lead Securitization Note Holder is under no obligation to do so), and the Lead Securitization Note Holder does not receive the corresponding payment within five (5) Business Days of its payment to such Non-Lead Securitization Note Holder, such Non-Lead Securitization Note Holder shall, at the Lead Securitization Note Holder’s request, promptly return that payment to the Lead Securitization Note Holder. (d) Each Note Holder agrees that if at any time it shall receive from any sources whatsoever any payment on account of the Mortgage Loan in excess of its distributable share thereof, it shall promptly remit such excess to the applicable Note Holder, subject to this Agreement and the Lead Securitization Servicing Agreement. The Lead Securitization Note Holder shall have the right to offset any amounts due hereunder from a Non-Lead Securitization Note Holder with respect to the Mortgage Loan against any future payments due to such Non-Lead Securitization Note Holder under the Mortgage Loan. Such Non-Lead Securitization Note Holder’s obligations under this Section 8 constitute absolute, unconditional and continuing obligations.

• Acceptance Tests 11.1 If the Contract provides acceptance tests for Goods and/or the result of Services after their completion and/or delivery to the Purchaser, the acceptance shall only be considered as definitive when such tests have demonstrated the compliance of the Goods and/or the result of the Services to the requirements in the Contract. 11.2 Where the Contract provides for an acceptance procedure in the presence of both parties, at the successful completion of such procedure, the Purchaser shall issue the Supplier with an acceptance certificate which shall authorise the Supplier to invoice the Purchaser for any payment due on such acceptance. 11.3 The Purchaser shall at its discretion be entitled to issue and acceptancecertificate with reserves. The Supplier shall be obliged to remedy any non-conformities within the period set out in the acceptance certificate. Any payment which would otherwise have been due on acceptance may be withheld by the Purchaser in whole or part until the non- conformities underlying the reserves have been remedied.

• Performance Testing 7.2.1 The Design-Builder shall direct and supervise the tests and, if necessary, the retests of the Plant using Design-Builder’s supervisory personnel and the Air Emissions Tester shall conduct the air emissions test, in each case, in accordance with the testing procedures set forth in Exhibit A (the “Performance Tests”), to demonstrate, at a minimum, compliance with the Performance Guarantee Criteria. Owner is responsible for obtaining Air Emissions Tester and for ensuring Air Emissions Tester’s timely performance. Design-Builder shall cooperate with the Air Emissions Tester to facilitate performance of all air emissions tests. Design-Builder shall not be held responsible for the actions of Owner’s employees and third parties involved in the Performance Testing, including but not limited to Air Emissions Tester. 7.2.2 No later than thirty (30) Days prior to the earlier of the Scheduled Substantial Completion Date or Substantial Completion, Design-Builder shall provide to Owner for review a detailed testing plan for the Performance Tests (other than for air emissions). Owner and Design-Builder shall agree upon a testing plan that shall be consistent with the Performance Test Protocol contained in Exhibit A hereto. After such agreement has been reached, Design-Builder shall notify the Owner five (5) business days prior to the date Design-Builder intends to commence the Performance Tests and shall notify the Owner upon commencement of the Performance Tests. Owner and Independent Engineer each have the right to witness all testing, including the Performance Tests and any equipment testing, whether at the Site or at the Subcontractor’s or equipment supplier’s premises during the course of this Agreement. Notwithstanding the foregoing sentence, Owner shall bear the costs of providing a witness to any such testing and all such witnesses shall comply at all times with Design-Builder’s, Subcontractor’s or equipment supplier’s safety and security procedures and other reasonable requirements, and otherwise conduct themselves in a manner that does not interfere with Design-Builder’s, Subcontractor’s or equipment supplier’s activities or operations. 7.2.3 Design-Builder shall provide to Owner a Performance Test report (excluding results from air emissions testing), including all applicable test data, calculations and certificates indicating the results of the Performance Tests and, within five (5) business days of Owner’s receipt of such results, Owner, Independent Engineer and Design-Builder will jointly inspect such Work and review the results of the Performance Tests to verify that the Performance Guarantee Criteria have been met. If Owner or Independent Engineer reasonably determines that the Performance Guarantee Criteria have not been met, Owner shall notify Design-Builder the reasons why Owner determined that the Performance Guarantee Criteria have not been met and Design-Builder shall promptly take such action or perform such additional work as will achieve the Performance Guarantee Criteria and shall issue to the Owner another notice in accordance with Section 7.2.2; provided however that if the notice relates to a retest, the notice may be provided no less than two (2) business days prior to the Performance Tests. Such procedure shall be repeated as necessary until Owner and Independent Engineer verifies that the Performance Guarantee Criteria have been met. 7.2.4 If Owner, for whatever reason, prevents Design-Builder from demonstrating the Performance Guarantee Criteria within thirty (30) Days of Design-Builder’s notice that the Plant is ready for Performance Testing, then Design-Builder shall be excused from demonstrating compliance with the Performance Guarantee Criteria during such period of time that Design-Builder is prevented from demonstrating compliance with the Performance Guarantee Criteria; provided however that Design-Builder will be deemed to have fulfilled all of its obligations to demonstrate that the Plant meets the Performance Guarantee Criteria should such period of time during which Design-Builder is prevented from demonstrating the Performance Criteria exceed thirty (30) Days or extend beyond the Final Completion Date.

• Random Testing Notwithstanding any provisions of the Collective Agreement or any special agreements appended thereto, section 4.6 of the Canadian Model will not be applied by agreement. If applied to a worker dispatched by the Union, it will be applied or deemed to be applied unilaterally by the Employer. The Union retains the right to grieve the legality of any imposition of random testing in accordance with the Grievance Procedure set out in this Collective Agreement.

• Drug Testing (A) The state and the PBA agree to drug testing of employees in accordance with section 112.0455, F.S., the Drug-Free Workplace Act. (B) All classes covered by this Agreement are designated special risk classes for drug testing purposes. Special risk means employees who are required as a condition of employment to be certified under Chapter 633 or Chapter 943, F.S. (C) An employee shall have the right to grieve any disciplinary action taken under section 112.0455, the Drug-Free Workplace Act, subject to the limitations on the grievability of disciplinary actions in Article 10. If an employee is not disciplined but is denied a demotion, reassignment, or promotion as a result of a positive confirmed drug test, the employee shall have the right to grieve such action in accordance with Article 6.

• Random Drug Testing All employees covered by this Agreement shall be subject to random drug testing in accordance with Appendix D.

• Performance Tests Contractor shall perform Performance Tests in accordance with Section 11.2 of the Agreement and Attachment S.