Obligations Under MRTU or Equivalent Successor Market. (a) If SCE Bids the Forecast-Derived Energy into the Day-Ahead Market and the CAISO awards a Schedule as a result of that Bid:
Obligations Under MRTU or Equivalent Successor Market Sample Clauses
Related to Obligations Under MRTU or Equivalent Successor Market
Licensor Performance Obligations 1. The Licensor will use reasonable efforts to ensure that its performance will meet or exceed industry standards and practices. Additionally, the Licensor agrees to the following performance standards.
Excuse for Nonperformance or Delayed Performance Except with respect to defaults of subcontractors, Contractor/Vendor shall not be in default by reason of any failure in performance of this contract in accordance with its terms (including any failure by Contractor/Vendor to make progress in the prosecution of the work hereunder which endangers such performance) if Contractor/Vendor has notified the Commission or designee within 15 days after the cause of the delay and the failure arises out of causes such as: acts of God; acts of the public enemy; acts of the State and any other governmental entity in its sovereign or contractual capacity; fires; floods; epidemics; quarantine restrictions; strikes or other labor disputes; freight embargoes; or unusually severe weather. If the failure to perform is caused by the failure of a subcontractor to perform or to make progress, and if such failure arises out of causes similar to those set forth above, Contractor/Vendor shall not be deemed to be in default, unless the services to be furnished by the subcontractor were reasonably obtainable from other sources in sufficient time to permit Contractor to meet the contract requirements. Upon request of Contractor, the Commission or designee shall ascertain the facts and extent of such failure, and, if such officer determines that any failure to perform was occasioned by any one or more of the excusable causes, and that, but for the excusable cause, Contractor’s progress and performance would have met the terms of the contract, the delivery schedule shall be revised accordingly, subject to the rights of the State under the clause entitled (in fixed-price contracts, “Termination for Convenience,” in cost-reimbursement contracts, “Termination”). (As used in this Paragraph of this clause, the term “subcontractor” means subcontractor at any tier).
Particular Methods of Procurement of Consultants’ Services 1. Quality- and Cost-based Selection. Except as otherwise provided in paragraph 2 below, consultants’ services shall be procured under contracts awarded on the basis of Quality and Cost-based Selection.
Failed or Returned Transactions In using the Service, you are requesting the Service to make payments for you from your Payment Account. If we are unable to complete the transaction for any reason associated with your Payment Account (for example, there are insufficient funds in your Payment Account to cover the transaction), the transaction will not be completed. In some instances, you will receive a return notice from the Service. In such case, you agree that:
Performance Obligations The Purchaser shall have performed in all respects all obligations required to be performed by it under this Agreement at or prior to the Closing.
Noon Meal Lunch reimbursement may be claimed only if the employee is in travel status and is performing required work more than thirty-five (35) miles from his/her temporary or permanent work station and the work assignment extends over the normal noon meal period.
Other Methods of Procurement of Consultants’ Services The following table specifies methods of procurement, other than Quality and Cost-based Selection, which may be used for consultants’ services. The Procurement Plan shall specify the circumstances under which such methods may be used. Procurement Method
Unbundled Network Terminating Wire (UNTW) 2.8.3.1 UNTW is unshielded twisted copper wiring that is used to extend circuits from an intra-building network cable terminal or from a building entrance terminal to an individual End User’s point of demarcation. It is the final portion of the Loop that in multi-subscriber configurations represents the point at which the network branches out to serve individual subscribers.
Conditions to Payment, Transfer or Exchange Freddie Mac, its agent or any other person potentially required to withhold with respect to payments on a Note shall have the right to require a Holder of a Note, as a condition to payment of principal of or interest on such Note, or as a condition to transfer or exchange such Note, to present at such place as Freddie Mac, its agent or such other person shall designate a certificate in such form as Freddie Mac, its agent or such other person may from time to time prescribe, to enable Freddie Mac, its agent or such other person to determine its duties and liabilities with respect to (i) any taxes, assessments or governmental charges which Freddie Mac, the Global Agent, the Exchange Administrator or such other person, as the case may be, may be required to deduct or withhold from payments in respect of such Note under any present or future law of the United States or jurisdiction therein or any regulation or interpretation of any taxing authority thereof; and (ii) any reporting or other requirements under such laws, regulations or interpretations. Freddie Mac, its agent or such other person shall be entitled to determine its duties and liabilities with respect to such deduction, withholding, reporting or other requirements on the basis of information contained in such certificate or, if no certificate shall be presented, on the basis of any presumption created by any such law, regulation or interpretation, and shall be entitled to act in accordance with such determination.
Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Sub-loop that may diminish the capability of the Loop or Sub-loop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, but are not limited to, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the XxxxXxxxx XX 00000.
