Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.
Please see the current Washtenaw Community College catalog for up-to-date program requirements Conditions & Requirements
COOPERATIVE PURCHASING PROGRAM PARTICIPATION Arkansas' Purchasing Law provides that local public procurement units (counties, municipalities, school districts, certain nonprofit corporations, etc.) may participate in state purchasing contracts. The contractor therefore agrees to sell to Cooperative Purchasing Program participants at the option of the program participants. Unless otherwise stated, all standard and special terms and conditions listed within the contract must be equally applied to such participants.
Interconnection Customer Compensation If the CAISO requests or directs the Interconnection Customer to provide a service pursuant to Articles 9.6.3 (Payment for Reactive Power) or 13.5.1 of this LGIA, the CAISO shall compensate the Interconnection Customer in accordance with the CAISO Tariff.
Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.
Durable Medical Equipment (DME), Medical Supplies, Prosthetic Devices, Enteral Formula or Food, and Hair Prosthesis (Wigs) This plan covers durable medical equipment and supplies, prosthetic devices and enteral formula or food as described in this section. DME is equipment which: • can withstand repeated use; • is primarily and customarily used to serve a medical purpose; • is not useful to a person in the absence of an illness or injury; and • is for use in the home. DME includes supplies necessary for the effective use of the equipment. This plan covers the following DME: • wheelchairs, hospital beds, and other DME items used only for medical treatment; and • replacement of purchased equipment which is needed due to a change in your medical condition or if the device is not functional, no longer under warranty, or cannot be repaired. DME may be classified as a rental item or a purchased item. In most cases, this plan only pays for a rental DME up to our allowance for a purchased DME. Repairs and supplies for rental DME are included in the rental allowance. Medical supplies are consumable supplies that are disposable and not intended for re- use. Medical supplies require an order by a physician and must be essential for the care or treatment of an illness, injury, or congenital defect. Covered medical supplies include: • essential accessories such as hoses, tubes and mouthpieces for use with medically necessary DME (these accessories are included as part of the rental allowance for rented DME); • catheters, colostomy and ileostomy supplies, irrigation trays and surgical dressings; and • respiratory therapy equipment. This plan covers diabetic equipment and supplies for the treatment of diabetes in accordance with R.I. General Law §27-20-30. Covered diabetic equipment and supplies include: • therapeutic or molded shoes and inserts for custom-molded shoes for the prevention of amputation; • blood glucose monitors including those with special features for the legally blind, external insulin infusion pumps and accessories, insulin infusion devices and injection aids; and • lancets and test strips for glucose monitors including those with special features for the legally blind, and infusion sets for external insulin pumps. The amount you pay differs based on whether the equipment and supplies are bought from a durable medical equipment provider or from a pharmacy. See the Summary of Pharmacy Benefits and the Summary of Medical Benefits for details. Coverage for some diabetic equipment and supplies may only be available from either a DME provider or from a pharmacy. Visit our website to determine if this is applicable or call our Customer Service Department. Prosthetic devices replace or substitute all or part of an internal body part, including contiguous tissue, or replace all or part of the function of a permanently inoperative or malfunctioning body part and alleviate functional loss or impairment due to an illness, injury or congenital defect. Prosthetic devices do not include dental prosthetics. This plan covers the following prosthetic devices as required under R.I. General Law § 27-20-52: • prosthetic appliances such as artificial limbs, breasts, larynxes and eyes; • replacement or adjustment of prosthetic appliances if there is a change in your medical condition or if the device is not functional, no longer under warranty and cannot be repaired; • devices, accessories, batteries and supplies necessary for prosthetic devices; • orthopedic braces except corrective shoes and orthotic devices used in connection with footwear; and • breast prosthesis following a mastectomy, in accordance with the Women’s Health and Cancer Rights Act of 1998 and R.I. General Law 27-20-29. The prosthetic device must be ordered or provided by a physician, or by a provider under the direction of a physician. When you are prescribed a prosthetic device as an inpatient and it is billed by a provider other than the hospital where you are an inpatient, the outpatient benefit limit will apply. Enteral formula or food is nutrition that is absorbed through the intestinal tract, whether delivered through a feeding tube or taken orally. Enteral nutrition is covered when it is the sole source of nutrition and prescribed by the physician for home use. In accordance with R.I. General Law §27-20-56, this plan covers enteral formula taken orally for the treatment of: • malabsorption caused by Crohn’s Disease; • ulcerative colitis; • gastroesophageal reflux; • chronic intestinal pseudo obstruction; and • inherited diseases of amino acids and organic acids. Food products modified to be low protein are covered for the treatment of inherited diseases of amino acids and organic acids. Preauthorization may be required. The amount that you pay may differ depending on whether the nutrition is delivered through a feeding tube or taken orally. When enteral formula is delivered through a feeding tube, associated supplies are also covered. This plan covers hair prosthetics (wigs) worn for hair loss suffered as a result of cancer treatment in accordance with R.I. General Law § 27-20-54 and subject to the benefit limit and copayment listed in the Summary of Medical Benefits. This plan will reimburse the lesser of the provider’s charge or the benefit limit shown in the Summary of Medical Benefits. If the provider’s charge is more than the benefit limit, you are responsible for paying any difference. This plan covers Early Intervention Services in accordance with R.I. General Law §27- 20-50. Early Intervention Services are educational, developmental, health, and social services provided to children from birth to thirty-six (36) months. The child must be certified by the Rhode Island Department of Human Services (DHS) to enroll in an approved Early Intervention Services program. Services must be provided by a licensed Early Intervention provider and rendered to a Rhode Island resident. Members not living in Rhode Island may seek services from the state in which they reside; however, those services are not covered under this plan. Early Intervention Services as defined by DHS include but are not limited to the following: • speech and language therapy; • physical and occupational therapy; • evaluation; • case management; • nutrition; • service plan development and review; • nursing services; and • assistive technology services and devices.
PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS If any portion of work being Bid is subject to the prevailing wage rate provisions of the Labor Law, the following shall apply:
PROPOSED MOBILITY PROGRAMME The proposed mobility programme includes the indicative start and end months of the agreed study programme that the student will carry out abroad. The Learning Agreement must include all the educational components to be carried out by the student at the receiving institution (in table A) and it must contain as well the group of educational components that will be replaced in his/her degree by the sending institution (in table B) upon successful completion of the study programme abroad. Additional rows can be added as needed to tables A and B. Additional columns can also be added, for example, to specify the study cycle-level of the educational component. The presentation of this document may also be adapted by the institutions according to their specific needs. However, in every case, the two tables A and B must be kept separated, i.e. they cannot be merged. The objective is to make clear that there needs to be no one to one correspondence between the courses followed abroad and the ones replaced at the sending institutions. The aim is rather that a group of learning outcomes achieved abroad replaces a group of learning outcomes at the sending institution, without having a one to one correspondence between particular modules or courses. A normal academic year of full-time study is normally made up of educational components totalling 60 ECTS* credits. It is recommended that for mobility periods shorter than a full academic year, the educational components selected should equate to a roughly proportionate number of credits. In case the student follows additional educational components beyond those required for his/her degree programme, these additional credits must also be listed in the study programme outlined in table A. When mobility windows are embedded in the curriculum, it will be enough to fill in table B with a single line as described below: Component code (if any) Component title (as indicated in the course catalogue) at the sending institution Semester [autumn / spring] [or term] Number of ECTS* credits Mobility window … Total: 30 Otherwise, the group of components will be included in Table B as follows: Component code (if any) Component title (as indicated in the course catalogue) at the sending institution Semester [autumn / spring] [or term] Number of ECTS* credits Course x … 10 Module y … 10 Laboratory work … 10 Total: 30 The sending institution must fully recognise the number of ECTS* credits contained in table A if there are no changes to the study programme abroad and the student successfully completes it. Any exception to this rule should be clearly stated in an annex of the Learning Agreement and agreed by all parties. Example of justification for non-recognition: the student has already accumulated the number of credits required for his/her degree and does not need some of the credits gained abroad. Since the recognition will be granted to a group of components and it does not need to be based on a one to one correspondence between single educational components, the sending institution must foresee which provisions will apply if the student does not successfully complete some of the educational components from his study programme abroad. A web link towards these provisions should be provided in the Learning Agreement. The student will commit to reach a certain level of language competence in the main language of instruction by the start of the study period. The level of the student will be assessed after his/her selection with the Erasmus+ online assessment tool when available (the results will be sent to the sending institution) or else by any other mean to be decided by the sending institution. A recommended level has been agreed between the sending and receiving institutions in the inter-institutional agreement. In case the student would not already have this level when he/she signs the Learning Agreement, he/she commits to reach it with the support to be provided by the sending or receiving institution (either with courses that can be funded by the organisational support grant or with the Erasmus+ online tutored courses). All parties must sign the document; however, it is not compulsory to circulate papers with original signatures, scanned copies of signatures or digital signatures may be accepted, depending on the national legislation. * In countries where the "ECTS" system it is not in place, in particular for institutions located in partner countries not participating in the Bologna process, "ECTS" needs to be replaced in all tables by the name of the equivalent system that is used and a weblink to an explanation to the system should be added. The section to be completed during the mobility is needed only if changes have to be introduced into the original Learning Agreement. In that case, the section to be completed before the mobility should be kept unchanged and changes should be described in this section. Changes to the mobility study programme should be exceptional, as the three parties have already agreed on a group of educational components that will be taken abroad, in the light of the course catalogue that the receiving institution has committed to publish well in advance of the mobility periods and to update regularly as ECHE holder. However, introducing changes might be unavoidable due to, for example, timetable conflicts. Other reasons for a change can be the request for an extension of the duration of the mobility programme abroad. Such a request can be made by the student at the latest one month before the foreseen end date. These changes to the mobility study programme should be agreed by all parties within four to seven weeks (after the start of each semester). Any party can request changes within the first two to five-week period after regular classes/educational components have started for a given semester. The exact deadline has to be decided by the institutions. The shorter the planned mobility period, the shorter should be the window for changes. All these changes have to be agreed by the three parties within a two-week period following the request. In case of changes due to an extension of the duration of the mobility period, changes should be made as timely as possible as well. Changes to the study programme abroad should be listed in table C and, once they are agreed by all parties, the sending institution commits to fully recognise the number of ECTS credits as presented in table C. Any exception to this rule should be documented in an annex of the Learning Agreement and agreed by all parties. Only if the changes described in table C affect the group of educational components in the student's degree (table B) that will be replaced at the sending institution upon successful completion of the study programme abroad, a revised version should be inserted and labelled as "Table D: Revised group of educational components in the student's degree that will be replaced at sending institution". Additional rows and columns can be added as needed to tables C and D. All parties must confirm that the proposed amendments to the Learning Agreement are approved. For this specific section, original or scanned signatures are not mandatory and an approval by email may be enough. The procedure has to be decided by the sending institution, depending on the national legislation.
Interconnection Customer Compensation for Actions During Emergency Condition The CAISO shall compensate the Interconnection Customer in accordance with the CAISO Tariff for its provision of real and reactive power and other Emergency Condition services that the Interconnection Customer provides to support the CAISO Controlled Grid during an Emergency Condition in accordance with Article 11.6.
Special Parental Allowance for Totally Disabled Employees (a) An employee who:
(i) fails to satisfy the eligibility requirement specified in subparagraph 17.05(a)(ii) solely because a concurrent entitlement to benefits under the Disability Insurance (DI) Plan, the Long-term Disability (LTD) Insurance portion of the Public Service Management Insurance Plan (PSMIP) or via the Government Employees Compensation Act prevents the employee from receiving Employment Insurance or Québec Parental Insurance Plan benefits, and
(ii) has satisfied all of the other eligibility criteria specified in paragraph 17.05(a), other than those specified in sections (A) and (B) of subparagraph 17.05(a)(iii), shall be paid, in respect of each week of benefits under the parental allowance not received for the reason described in subparagraph (i), the difference between ninety-three per cent (93%) of the employee's rate of pay and the gross amount of his or her weekly disability benefit under the DI Plan, the LTD Plan or via the Government Employees Compensation Act.
(b) An employee shall be paid an allowance under this clause and under clause 17.05 for a combined period of no more than the number of weeks during which the employee would have been eligible for parental, paternity or adoption benefits under the Employment Insurance or Québec Parental Insurance Plan, had the employee not been disqualified from Employment Insurance or Québec Parental Insurance Plan benefits for the reasons described in subparagraph (a)(i).
