Positive Test results for Antibiotics AFTER Milk is collected and has caused the TANKER TO RETURN A POSITIVE RESULT . UPON CUSTOMER RISK ASSESSMENT , MILK IS ACCEPTED. Supplier will not be paid for this Milk as it has tested positive for antibiotics and is deemed to be in breach of ACM Food Safety Program (see part 6.1 for details) and Milk Quality Standards (see Table 3.1). For all positive samples (vat or Tanker) Milk collection will be suspended until a negative sample is achieved. Any subsequent positive vat samples taken during this process will not be paid for. Only after a negative sample is achieved, will ACM schedule Milk for collection. Supplier will be required to complete a CAR (Corrective Action Report) which is a requirement of ACM’s Food Safety Program. Refer to section 4.3 Management of Non‐Conformance ‐ Incident Report in the ACM Food Safety Program manual.
Positive Test Result Where there has been a positive test result in a confirmatory test and in any confirmatory retest (if the employee requested one), the Employer will do the following unless the employee has furnished a legitimate medical reason for the positive test result:
Positive Test Results In the event an employee tests positive for drug use, the employee will be provided, in writing, notice of their right to explain the test results. The employee may indicate any relevant circumstance, including over the counter or prescription medication taken within the last thirty (30) days, or any other information relevant to the reliability of, or explanation for, a positive test result.
Positive sequence component of the fundamental frequency AC bus voltage at either the Xxxx 00xx Xxxxxx 345kV Substation 345kV AC bus or the Bergen 230kV AC bus greater than the upper limit or less than the lower limit as specified in Figure G-1. For the period up to 0.5 seconds, the upper voltage limit specified in Figure G-1 shall be applied to the greater of the fundamental- frequency positive-sequence AC bus voltage in pu on the nominal line-to-line rms voltage, the crest phase-to-ground voltage of any AC bus phase in pu of times the nominal line-to-line rms voltage, and the crest phase-to-phase voltage of any AC bus phase in pu of times the nominal line-to-line rms AC bus voltage.
Positive Time Reporting Employees will accurately report time worked in accordance with a positive time reporting process as determined by each agency.
CONSEQUENCES OF POSITIVE TEST RESULTS For post-Accident or reasonable suspicion, a Covered Employee shall be immediately removed from performing his or her job or, in the alternative, may be temporarily reassigned to work that is not safety-sensitive if such work is available. The Covered Employee shall be subject to disciplinary action, and shall meet with the SAPC, as set forth in Exhibit A, and section 10 below, if the Covered Employee:
Competitive Terms 22.4.1 If the Contracting Body is able to obtain from any Sub-Contractor or any other third party more favourable commercial terms with respect to the supply of any materials, equipment, software, goods or services used by the Supplier or the Supplier Personnel in the supply of the Goods and/or Services, then the Authority may:
Production definitively discontinued 10.1. If the holder of the approval completely ceases to manufacture a vehicle type approved in accordance with this Regulation, he shall so inform the authority which granted the approval. Upon receiving the relevant communication that authority shall inform thereof the other Parties to the 1958 Agreement applying this Regulation by means of a communication form conforming to the model in Annex 1 to this Regulation.
Development Milestones In addition to its obligations under Paragraph 7.1, LICENSEE specifically commits to achieving the following development milestones in its diligence activities under this AGREEMENT: (a) (b).
Correction Period (1) End of correction period. The last day of the correction period for an Operational Failure is the last day of the second plan year following the plan year for which the failure occurred. However, in the case of a failure to satisfy the requirements of § 401(k)(3), 401(m)(2), or 401(m)(9), the correction period does not end until the last day of the second plan year following the plan year that includes the last day of the additional period for correction permitted under § 401(k)(8) or 401(m)(6). If a 403(b) Plan does not have a plan year, the plan year is deemed to be the calendar year for purposes of this subsection.
