Post-Acceptance Correction of Defects Sample Clauses

Post-Acceptance Correction of Defects. Consultant shall correct any Defects in the Services and/or Deliverables, or any components thereof, remaining to be corrected following Acceptance under the applicable Statement of Work.
AutoNDA by SimpleDocs
Post-Acceptance Correction of Defects. Supplier shall correct any Defects remaining to be corrected following Acceptance in accordance with Supplier’s warranty and/or Support and Maintenance Services obligations under Article 8.
Post-Acceptance Correction of Defects. Lucent shall correct any Defects remaining to be corrected following Product Acceptance, Installation Acceptance or Project Acceptance, as applicable, under the applicable Product Addendum or Statement of Work in accordance with Lucent's warranty and/or Support and Maintenance Services obligations under ARTICLE 8.

Related to Post-Acceptance Correction of Defects

  • Correction of Defects 35.1 The Engineer shall give notice to the Contractor of any Defects before the end of the Defects Liability Period, which begins at Completion and is defined in the Contract Data. The Defects Liability Period shall be extended for as long as Defects remain to be corrected.

  • Correction of Errors Contractor shall perform, at its own cost and expense and without reimbursement from the District, any work necessary to correct errors or omissions which are caused by the Contractor’s failure to comply with the standard of care required herein.

  • Notice of Defects If, based on Consulting Engineer/Architect's involvement during the construction phase, Consulting Engineer/Architect observes or otherwise becomes aware of any defect in the work, he shall give prompt written notice to City of such defects and their approximate location on the Project. However, Consulting Engineer/Architect shall not have control over or charge of and shall not be responsible for construction means, methods, techniques, sequences or procedures, or for safety precautions, inspections and programs in connection with the work, since these are solely the Contractor's responsibility under the contract for construction. Consulting Engineer/Architect shall not be responsible for the Contractor's schedules or failure to carry out the work in accordance with the Contract Documents. Consulting Engineer/Architect shall not have control over or charge of acts or omissions of the Contractor, Contractor's subcontractors, or their agents or employees.

  • Acceptance Testing At the time of installation of a LIS trunk group, and at no additional charge, acceptance tests will be performed to ensure that the service is operational and meets the applicable technical parameters.

  • Acceptance and Rejection a. Buyer shall accept the Services or give Seller notice of rejection within a reasonable time after the date of delivery. No payment, prior test, inspection, passage of title, any failure or delay in performing any of the foregoing, or failure to discover any defect or other nonconformance shall relieve Seller of any obligations under this Contract or impair any rights or remedies of Buyer.

  • Error Correction The Manager shall make adjustments to charges as required to reflect the discovery of errors or omissions in charges; provided, however, that any errors or omissions the correction of which would result in additional or increased charges or fees for Services must be corrected within [ ] years after the date of the related invoice.

  • Final Acceptance When the Project/Service or any portion thereof, as designated by the COUNTY, is ready for its intended use, the COUNTY and any other invited parties shall make an inspection of the Project/Service, to verify its completeness and develop a punch list of items needing completion or correction before final payment will be made. CONTRACTOR shall have ten (10) calendar days to correct all deficiencies. An eighty-dollar ($80.00) re-inspection fee shall be applied for the third inspection and any required re-inspection thereafter. The COUNTY shall have the right to exclude CONTRACTOR from those portions of the work designated as complete after the inspection; provided, however, that CONTRACTOR will have reasonable access for the time allotted by the COUNTY to complete or correct items on the punch list. When the work provided for under this Agreement has been completely performed by CONTRACTOR, and the final inspection has been made by the COUNTY, a final invoice will be prepared by the CONTRACTOR. The amount of this invoice, less any sums that may have been deducted or retained under the provisions of this Agreement, will be paid to CONTRACTOR in accordance with this Agreement, and after CONTRACTOR has agreed in writing to accept the balance due, as determined by the COUNTY, as full settlement of the account under the contract and of all claims in connection therewith. Occupancy by the COUNTY alone does not constitute final acceptance.

  • Acceptance; Rejection A holder of Notes may accept the offer to prepay made pursuant to this Section 8.3 by causing a notice of such acceptance to be delivered to the Company not later than 15 days after receipt by such holder of the most recent offer of prepayment. A failure by a holder of Notes to respond to an offer to prepay made pursuant to this Section 8.3 shall be deemed to constitute a rejection of such offer by such holder.

  • Latent Defects Notwithstanding anything to the contrary set forth herein, no acceptance, or deemed acceptance, by City pursuant to this Section shall be applicable with respect to any Latent Defects. An acceptance, or deemed acceptance, by City pursuant to this Section shall not mean that City has accepted, or the other party has been relieved of, responsibility for: (i) compliance with the Laws; (ii) the proper application of construction means or methods; or (iii) correcting any portion of the Project if it later is determined that any portion of the Project is inconsistent with the Final Documents and Drawings.

  • ALTERATIONS - ADDITIONS The LESSEE shall not make structural alterations or additions to the leased premises, but may make non-structural alterations provided the LESSOR consents thereto in writing, which consent shall not be unreasonably withheld or delayed. All such allowed alterations shall be at LESSEE's expense and shall be in quality at least equal to the present construction. LESSEE shall not permit any mechanics' liens, or similar liens, to remain upon the leased premises for labor and material furnished to LESSEE or claimed to have been furnished to LESSEE in connection with work of any character performed or claimed to have been performed at the direction of LESSEE and shall cause any such lien to be released of record forthwith without cost to LESSOR. Any alterations or improvements made by the LESSEE shall become the property of the LESSOR at the termination of occupancy as provided herein.

Time is Money Join Law Insider Premium to draft better contracts faster.