Transmission Delivery Service Implications Under ER Interconnection Service, Interconnection Customer will be eligible to inject power from the Generating Facility into and deliver power across the Transmission System on an “as available” basis up to the amount of MW identified in the applicable stability and steady state studies to the extent the upgrades initially required to qualify for ER Interconnection Service have been constructed. After that date FERC makes effective MISO’s Energy Market Tariff filed in Docket No. ER04-691-000, Interconnection Customer may place a bid to sell into the market up to the maximum identified Generating Facility output, subject to any conditions specified in the Interconnection Service approval, and the Generating Facility will be dispatched to the extent the Interconnection Customer’s bid clears. In all other instances, no transmission or other delivery service from the Generating Facility is assured, but Interconnection Customer may obtain Point-To-Point Transmission Service, Network Integration Transmission Service or be used for secondary network transmission service, pursuant to the Tariff, up to the maximum output identified in the stability and steady state studies. In those instances, in order for Interconnection Customer to obtain the right to deliver or inject energy beyond the Point of Interconnection or to improve its ability to do so, transmission delivery service must be obtained pursuant to the provisions of the Tariff. The Interconnection Customer’s ability to inject its Generating Facility output beyond the Point of Interconnection, therefore, will depend on the existing capacity of the Transmission or Distribution System as applicable, at such time as a Transmission Service request is made that would accommodate such delivery. The provision of Firm Point-To-Point Transmission Service or Network Integration Transmission Service may require the construction of additional Network or Distribution Upgrades.
Notifications of Outages and Maintenance In the event that a Registry Operator plans maintenance, it will provide notice to the ICANN emergency operations department, at least, twenty-‐four (24) hours ahead of that maintenance. ICANN’s emergency operations department will note planned maintenance times, and suspend Emergency Escalation services for the monitored services during the expected maintenance outage period. If Registry Operator declares an outage, as per its contractual obligations with ICANN, on services under a service level agreement and performance requirements, it will notify the ICANN emergency operations department. During that declared outage, ICANN’s emergency operations department will note and suspend emergency escalation services for the monitored services involved.
How to Obtain Warranty Service The Warranty Holder must inspect the Flooring for Manufacturing Defects caused by improper milling, grading, staining and coating, and report any such defects to Cali Bamboo, prior to installation of the Flooring. To obtain warranty service, the Warranty Holder must contact Cali Bamboo’s Customer Experience Department: xxxxxxxxxxxxxxx@xxxxxxxxxx.xxx/ 000-000-0000. Warranty claims must be received within 30 calendar days after the Warranty Holder identifies the Manufacturing Defect or other basis for a warranty claim. To be covered under this Cali Bamboo limited warranty, the Warranty Holder must provide documentation of sales order and proof that the Flooring was properly installed in accordance with the Installation Guide (defined below). Cali Bamboo reserves the right to retain a certified and independent flooring inspector to verify the Warranty Holder’s warranty claims. The determination of the flooring inspector regarding the warranty claim is not binding on either Cali Bamboo or on the Warranty Holder. A determination that does not verify the warranty claim shall not affect the Warranty Holder’s right to submit its claim to arbitration in accordance with the terms of the Arbitration Agreement (as defined in Cali Bamboo’s Terms and Conditions of Purchase). The performance of the inspection, however, if requested by Xxxx Xxxxxx and assuming that Xxxx Xxxxxx advances the full cost of the inspection as described above, is a requirement for the Warranty Holder to submit a warranty claim to arbitration under the Arbitration Agreement. For specific instructions on how to obtain warranty service for defective Flooring, visit the Cali Bamboo website xxxxx://xxx.xxxxxxxxxx.xxx/geowood-flooring-warranty/. This limited warranty covers Flooring that is both (i) installed with strict adherence to Cali Bamboo’s GeoWood flooring installation guide found online at xxxxx://xxx.xxxxxxxxxx.xxx/flooring-installation/ (the “Installation Guide”) and (ii) maintained in accordance with Cali Bamboo’s GeoWood flooring care and maintenance guidelines found online at xxxxx://xxx.xxxxxxxxxx.xxx/floor-care-and-maintenance/ (the “Maintenance Guide”). Cali Bamboo will provide copies of these guides upon request by the Warranty Holder. This limited warranty only applies when the Flooring is used under normal traffic and other usage conditions. The limited warranty for Manufacturing Defects does not apply after the Warranty Holder has installed the Flooring, and product variation or error that does not exceed the 5% industry standard is not considered a Manufacturing Defect for purposes of this limited warranty. This limited warranty does not extend to or cover:
Remedies for Title Defects (a) With respect to each Title Defect that Seller does not cure on or before the Closing, except as otherwise provided in this Section 3.05, the Purchase Price shall be reduced by an amount equal to the Title Defect Value agreed upon in writing by Buyer and Seller or, if Buyer agrees, Seller shall indemnify Buyer pursuant to Section 14.04 against all costs which Buyer may incur in connection with such Title Defect. If any Title Defect is in the nature of an unobtained consent to assignment or other restriction on assignability, the provisions of Section 3.08 shall apply.
(b) Except for those affected Assets which Seller elects to exclude from this transaction pursuant to Section 3.04(b)(ii), if on or before Closing the Parties have not agreed upon the validity of any asserted Title Defect or have not agreed on the Title Defect Value attributable thereto, either Party shall have the right to elect to have the validity of such Title Defect and/or such Title Defect Value determined by an Independent Expert pursuant to Section 16.03; provided that if the validity of any asserted Title Defect, or the Title Defect Value attributable thereto, is not determined before Closing, the affected Asset shall be excluded from the sale and the Purchase Price shall be reduced by the Allocated Value of such affected Asset as set forth on Exhibit C. Upon resolution of such dispute, the Allocated Value of that Asset less the Title Defect Value, if any, found to be attributable to such Title Defect shall, subject to this Section 3.05, be paid by Buyer to Seller and the Asset conveyed to Buyer, if that is part of the mutually agreed settlement.
(c) Notwithstanding anything to the contrary in this Agreement, (i) if the value of a given individual Title Defect (or individual Title Benefit (as defined in Section 3.09(a)) does not exceed $50,000 then no adjustment to the Purchase Price shall be made for such Title Defect (or Title Benefit), (ii) if the aggregate adjustment to the Purchase Price determined in accordance with this Agreement for Title Defects and Environmental Defects (as hereinafter defined) does not exceed three percent (3%) of the Purchase Price prior to any adjustments thereto, then no adjustment of the Purchase Price shall be made therefor and (iii) if the aggregate adjustment to the Purchase Price determined in accordance with this Agreement for Title Defects and Environmental Defects does exceed three percent (3%) of the Purchase Price prior to any adjustments thereto, then the Purchase Price shall only be adjusted by the amount of such excess.
Traffic Measurement and Billing over Interconnection Trunks 6.1 For billing purposes, each Party shall pass Calling Party Number (CPN) information on at least ninety-five percent (95%) of calls carried over the Interconnection Trunks.
6.1.1 As used in this Section 6, “Traffic Rate” means the applicable Reciprocal Compensation Traffic rate, Measured Internet Traffic rate, intrastate Switched Exchange Access Service rate, interstate Switched Exchange Access Service rate, or intrastate/interstate Tandem Transit Traffic rate, as provided in the Pricing Attachment, an applicable Tariff, or, for Measured Internet Traffic, the FCC Internet Order.
6.1.2 If the originating Party passes CPN on ninety-five percent (95%) or more of its calls, the receiving Party shall xxxx the originating Party the Traffic Rate applicable to each relevant minute of traffic for which CPN is passed. For any remaining (up to 5%) calls without CPN information, the receiving Party shall xxxx the originating Party for such traffic at the Traffic Rate applicable to each relevant minute of traffic, in direct proportion to the minutes of use of calls passed with CPN information.
6.1.3 If the originating Party passes CPN on less than ninety-five percent (95%) of its calls and the originating Party chooses to combine Reciprocal Compensation Traffic and Toll Traffic on the same trunk group, the receiving Party shall xxxx the higher of its interstate Switched Exchange Access Service rates or its intrastate Switched Exchange Access Services rates for all traffic that is passed without CPN, unless the Parties agree that other rates should apply to such traffic.
6.2 At such time as a receiving Party has the capability, on an automated basis, to use such CPN to classify traffic delivered over Interconnection Trunks by the other Party by Traffic Rate type (e.g., Reciprocal Compensation Traffic/Measured Internet Traffic, intrastate Switched Exchange Access Service, interstate Switched Exchange Access Service, or intrastate/interstate Tandem Transit Traffic), such receiving Party shall xxxx the originating Party the Traffic Rate applicable to each relevant minute of traffic for which CPN is passed. If the receiving Party lacks the capability, on an automated basis, to use CPN information on an automated basis to classify traffic delivered by the other Party by Traffic Rate type, the originating Party will supply Traffic Factor 1 and Traffic Factor
Buyer’s Remedies UNDER THE CIRCUMSTANCES SET FORTH IN SECTION 13.2 OF THIS AGREEMENT, IN CONNECTION WITH A TERMINATION OF THIS AGREEMENT BUYER MAY BE ENTITLED TO THE BREAK-UP FEE OR A PORTION OF THE BREAK-UP FEE AS LIQUIDATED DAMAGES, THE PARTIES ACKNOWLEDGING THAT ACTUAL DAMAGES WILL BE DIFFICULT TO ASCERTAIN. IF THE BUYER SHALL BE ENTITLED TO RECEIPT OF THE BREAK-UP FEE OR A PORTION OF THE BREAK-UP FEE UNDER THE EXPRESS TERMS OF THIS AGREEMENT, BUYER AND SELLERS AGREE THAT NEITHER BUYER NOR SMITHFIELD MAY SEEK ANY REMEDIES OTHER THAN COLLECTION OF THE BREAK-UP FEE OR SUCH PORTION OF THE BREAK-UP FEE, AND NEITHER BUYER NOR SMITHFIELD MAY CLAIM ANY ADDITIONAL DAMAGES AS A RESULT OF SUCH TERMINATION, BUT OTHERWISE BUYER AND SMITHFIELD HEREBY WAIVE ANY RIGHT TO SEEK ANY OTHER REMEDY OR TO SEEK ANY ADDITIONAL DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES, BY REASON OF ANY DEFAULT BY SELLERS OR TERMINATION OF THIS AGREEMENT; PROVIDED, HOWEVER, IN THE EVENT THIS AGREEMENT IS TERMINATED PURSUANT TO SECTION 13.1(a) OR IF THE CLOSING DOES NOT OCCUR DUE TO ANY FAILURE OF SELLERS TO CLOSE OR ANY MATERIAL BREACH BY SELLERS OF THEIR OBLIGATIONS UNDER THIS AGREEMENT, BUYER AND SMITHFIELD MAY PURSUE THE REMEDY OF SPECIFIC PERFORMANCE WITH RESPECT TO SALE OF THE TRANSFERRED ASSETS AND OTHERWISE WITH RESPECT TO CONSUMMATION OF THE TRANSACTIONS CONTEMPLATED HEREIN.
Points of Interconnection and Trunk Types 2.1 Point(s) of Interconnection.
2.1.1 Each Party, at its own expense, shall provide transport facilities to the technically feasible Point(s) of Interconnection on Verizon’s network in a LATA selected by PNG.
Quality Warranty Remedies 5.1. GOODS WARRANTY. Contractor warrants that, for a period of twelve (12) months from the date when the Goods are put into use, or eighteen (18) months after delivery of the Goods, whichever is later (“Goods Warranty Period”), the Goods: (a) are free from defects in design, material, and workmanship; (b) are fit and safe for the intended purposes and appropriate for the specified application(s) (if any); (c) are consistent with recognized industry quality standards; (d) comply with the requirements, specifications, drawings, standards, and descriptions included in this Contract; and (e) are produced and delivered in full compliance with applicable law (“Goods Warranty”). Contractor further warrants that it has good and marketable title to the Goods and shall keep Purchaser’s property free of liens. If Purchaser receives notice of a lien caused by Contractor, Purchaser may withhold any payment otherwise due Contractor until Contractor submits proof, in a form satisfactory to Purchaser, that all lienable claims have been fully paid or waived.
DELIVERY: FOB DESTINATION, INSIDE DELIVERY, FREIGHT PAID Whenever possible, contractors should give the ordering entities 3 working days prior notice of any deliveries and/or installations. Furniture contractors will not be responsible for the removal/moving of existing furnishings unless requested by the ordering entity. Contractors should verify site readiness prior to delivery. All deliveries will be made during normal working hours unless otherwise arranged with the ordering entity. Contractor will communicate any scheduling delays and/or changes immediately. Agencies will not be responsible for any freight damage, concealed or otherwise.
Minimum Condition and Warranty Requirements for TIPS Sales All goods quoted or sold through a TIPS Sale shall be new unless clearly stated otherwise in writing. All new goods and services shall include the applicable manufacturers minimum standard warranty unless otherwise agreed to in the Supplemental Agreement.
