Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “ (1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “ (1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
Qualified Medical Child Support Order A child who would otherwise meet the eligibility requirements and is required to be covered by a Qualified Medical Child Support Order (QMCSO) is considered an eligible dependent.
Replacement of Key Personnel The Engineer must notify the State in writing as soon as possible, but no later than three business days after a project manager or other key personnel is removed from association with this contract, giving the reason for removal.
CONDITIONS FOR EMERGENCY/HURRICANE OR DISASTER - TERM CONTRACTS It is hereby made a part of this Invitation for Bids that before, during and after a public emergency, disaster, hurricane, flood, or other acts of God that Orange County shall require a “first priority” basis for goods and services. It is vital and imperative that the majority of citizens are protected from any emergency situation which threatens public health and safety, as determined by the County. Contractor agrees to rent/sell/lease all goods and services to the County or other governmental entities as opposed to a private citizen, on a first priority basis. The County expects to pay contractual prices for all goods or services required during an emergency situation. Contractor shall furnish a twenty-four (24) hour phone number in the event of such an emergency.
Office Visits (other than Preventive Care Services) This plan covers office and clinic visits to diagnose or treat a sickness or injury. Office visit copayments differ depending on the type of provider you see. This plan covers physician visits in your home if you have an injury or illness that: • confines you to your home; or • requires special transportation; and • because of this injury or illness, you are physically unable to travel to the provider’s
Unbundled Network Terminating Wire (UNTW) 2.8.3.1 UNTW is unshielded twisted copper wiring that is used to extend circuits from an intra-building network cable terminal or from a building entrance terminal to an individual End User’s point of demarcation. It is the final portion of the Loop that in multi-subscriber configurations represents the point at which the network branches out to serve individual subscribers. 2.8.3.2 This element will be provided in MDUs and/or Multi-Tenants Units (MTUs) where either Party owns wiring all the way to the End User’s premises. Neither Party will provide this element in locations where the property owner provides its own wiring to the End User’s premises, where a third party owns the wiring to the End User’s premises.
Please see the current Washtenaw Community College catalog for up-to-date program requirements Conditions & Requirements
PROFESSIONAL GRIEVANCE PROCEDURE A. Any claim by the Association or a teacher that there has been a violation, misinterpretation, or misapplication of the terms of the Agreement or violation of any established policy shall be a grievance and shall be resolved through the procedure set forth herein. B. In the event that a teacher, or the Association believes there is a basis for a grievance, the teacher or representative of the Association within thirty (30) working days of the time the teacher knew of the circumstances giving rise to the grievance, shall first discuss the alleged grievance with the building principal either personally or accompanied by the Association Representative. The grievance process may begin at the Superintendent’s level when the building principal is not involved with an alleged incident. C. If, as a result of the informal discussion with the building principal, a grievance still exists, the teacher or representative of the Association may, within ten (10) working days, invoke the formal grievance procedure through the Association on the grievance report form, signed by the grievant and a representative of the Association. Said form shall be available from the Association Representative in each building. A copy of the grievance form shall be delivered to the building principal, it may be filed with the Superintendent or a representative designated by him. D. Within five (5) working days of receipt of the grievance the principal shall meet with the Association in an effort to resolve the grievance. The principal shall indicate his/her disposition of the grievance in writing within five (5) working days of such meeting and shall furnish a copy thereof to the Association. If the Association desires to proceed to the next step, it shall do so within fifteen (15) calendar days of the principal’s disposition. E. If the Association is not satisfied with the disposition of the grievance, or if no disposition has been made within five (5) working days of such meeting (or ten [10] working days from the date of filing, whichever shall be later) the grievance shall be transmitted to the Superintendent. Within seven (7) working days the Superintendent or his/her designee, shall meet with the Association concerning the grievance and shall indicate his/her disposition of the grievance in writing within five (5) working days of such meeting, and shall furnish a copy thereof to the Association. F. If the Association is not satisfied with the disposition of the superintendent, or if no disposition has been received within five (5) working days of such meeting the Association may proceed to a Board Level Hearing. This grievance hearing shall be heard in closed session, so long as it does not violate the open meetings act. If the grievance is not settled at the preceding step, it may be submitted to binding arbitration. Within fifteen (15) working days of the receipt of the Superintendent’s answer, the party choosing to arbitrate must give written notice to the other party, setting forth specifically the nature of the dispute to be arbitrated. The charging party shall file a Demand for Arbitration with the American Arbitration Association within fifteen (15) days from the notification date that arbitration will be pursued. The arbitrator shall be selected by the American Arbitration Association in accordance with its rules, which shall likewise govern the arbitration proceedings. G. The arbitrator shall have no power to rule on any of the following: 1. The termination of services of or failure to re-employ any probationary teacher. 2. Any claim or complaint for which there is another remedial procedure or forum established by law or by regulation having the force of law, including any matter subject to the procedures specified in the Teacher’s Tenure Act (Act IV Public Acts, Extra Session of 1937 of Michigan, as amended). 3. Any matter involving the content of a teacher evaluation. H. The Board and the Association shall not be permitted to assert in such arbitration proceedings any ground or to rely on any evidence not previously disclosed to the other party. The arbitrator shall have no power to alter, add to, or subtract from the terms of this Agreement. Both parties agree to be bound by the decision of the arbitrator and agree that judgment thereon may be entered in any court of competent jurisdiction. I. The fees and expense of the arbitrator shall be shared equally by both parties. J. The time limits provided in this Article shall be strictly observed but may be extended by written agreement of the parties. In the event a grievance is filed after May 15 of any year and strict adherence to the time limits may result in hardship to any party, the Board shall use its best efforts to process such grievance prior to the end of the school term or as soon thereafter as possible.
Certification as Small Contractor or Minority Business Enterprise This paragraph was intentionally left blank.