Racecourse Show Line Sample Clauses

Racecourse Show Line. During the race, aircraft occupy a raceway around the racecourse. The edge of this raceway closest to the primary spectator area is the show line, over which no aircraft is permitted to cross while racing. There can be more than one primary spectator area. a) The raceway width may vary in the various racing classes so that there is adequate room for the aircraft to pass one another. Criteria for passing aircraft during a sanctioned race or pylon racing school are established in accordance with the FAA-accredited or FAA-recognized Air Race Operations Manual/Rules of Competition. The critical requirement is that no racing aircraft is permitted to cross over the show line during the race. b) The minimum turn radius, the maximum turn angle, and the raceway width define the limits of a satisfactory racecourse. The racecourse relationship to the primary and secondary spectator areas or other populated area must also be defined. All racing classes require a minimum safety distance of 500 feet between the primary spectator area and the show line. c) An additional safety area, as defined below in 3-172A7), is required to ensure that spectators are protected in the event that debris leaves a race aircraft. Should this occur while the aircraft is in a turn, the debris will follow a path tangential to the turn from the moment it departs the aircraft.
Sample 1
AutoNDA by SimpleDocs

Related to Racecourse Show Line

  • Wire Unbundled DS1 Digital Loop This is a designed 4-wire Loop that is provisioned according to industry standards for DS1 or Primary Rate ISDN services and will come standard with a test point, OC, and a DLR. A DS1 Loop may be provisioned over a variety of loop transmission technologies including copper, HDSL-based technology or fiber optic transport systems. It will include a 4-Wire DS1 Network Interface at the End User’s location.

  • Voice Grade Unbundled Copper Sub-Loop Unbundled Sub-Loop Distribution – Intrabuilding Network Cable (aka riser cable)

  • Signaling Link Transport 9.2.1 Signaling Link Transport is a set of two or four dedicated 56 kbps transmission paths between Global Connection-designated Signaling Points of Interconnection that provide appropriate physical diversity.

  • Mail Order Catalog Warnings In the event that, the Settling Entity prints new catalogs and sells units of the Products via mail order through such catalogs to California consumers or through its customers, the Settling Entity shall provide a warning for each unit of such Product both on the label in accordance with subsection 2.4 above, and in the catalog in a manner that clearly associates the warning with the specific Product being purchased. Any warning provided in a mail order catalog shall be in the same type size or larger than other consumer information conveyed for such Product within the catalog and shall be located on the same display page of the item. The catalog warning may use the Short-Form Warning content described in subsection 2.3(b) if the language provided on the Product label also uses the Short-Form Warning.

  • STRS PICK-UP The Board agrees, as a condition of employment, to tax shelter employee contributions to the State Teacher's Retirement System (STRS) in accordance with State Retirement System and Federal Internal Revenue Service guidelines and restrictions. This section in no way implies that the Board will contribute any portion of the employee's share of retirement contributions. For purposes of this paragraph, total annual salary and salary per pay period of each bargaining unit member shall be the salary otherwise payable under this Agreement, as amended. The total annual salary and salary per pay period of each member shall be payable by the Board in two parts: (1) deferred salary and (2) cash salary. A member's deferred salary shall be equal to that percentage of said member's total annual salary or salary per pay period which is required from time to time by the State Teachers Retirement System (STRS) to be paid as an employee contribution by said member as a pickup of the STRS employee contribution otherwise payable by said member. A member's cash salary shall be equal to said member's total annual salary or salary per period less the amount of the pickup for said member and shall be payable, subject to applicable payroll deductions, to said member. The Board's total combined expenditures for members' total annual salaries otherwise payable under this Agreement, as amended, (including pickup amounts) and its employer contributions to STRS shall not be greater than the amounts it would have paid for those items had this provision not been in effect. The Board shall compute and remit its employer contributions to STRS based upon total annual salary, including the "pickup". The Board shall report for Federal and Ohio income tax purposes as a member's gross income said member's total annual salary less the amount of the "pickup". The Board shall report for municipal income tax purposes as a member's gross income said member's total annual salary, including the amount of the pickup. The pickup shall be included in the member's total annual salary for the purpose of computing daily rate of pay, for determining paid salary adjustments to be made due to absence, or for any other similar purpose. The pickup shall apply to all payroll payments made after the effective date of this provision. Should the Board's payment of deferred salary cause an individual bargaining unit member's annuity contributions to exceed the IRS permissible level, any such individual shall have the right to adjust annuity deductions within thirty (30) days of the effective date of this provision.

  • Unbundled Digital Loops 2.3.1 BellSouth will offer Unbundled Digital Loops (UDL). UDLs are service specific, will be designed, will be provisioned with test points (where appropriate), and will come standard with OC and a DLR. The various UDLs are intended to support a specific digital transmission scheme or service. 2.3.2 BellSouth shall make available the following UDLs, subject to restrictions set forth herein:

  • Minimum Break between Shifts (a) Where it is necessary to work extended overtime, it is agreed that no Employee shall resume or continue to work without having had ten consecutive hours off duty between the termination of the overtime and the commencement of the Employee’s ordinary work on the next day or shift. (b) In the event that an Employee agrees to a request from site management to resume or continue to work without having had ten consecutive hours off duty, the Employee shall be paid at double ordinary time rates until the Employee is released from duty for such period.

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.

  • Course Curriculum, Instruction, and Grading X. Xxxx College courses offered as dual credit, regardless of where they are taught, follow the same syllabus, course outline, textbook, grading method, and other academic policies as the courses outlined in the Hill College catalog. B. Approved courses being taught for dual credit must follow the approved master syllabus of the discipline and of Hill College. C. Textbooks should be identical to those approved for use by Hill College. Should an instructor propose an alternative textbook, the textbook must be approved in advance by the appropriate instructional department of Hill College and the Vice President of Instruction. Other instructional materials for dual credit/concurrent courses must be identical or at an equivalent level to materials used by Hill College. D. Courses which result in college‐level credit will follow the standard grading practices of Hill College, as identified by college policy and as identified in the appropriately approved course syllabus. The grades used in college records are A (excellent), B (above average), C (average), D (below average), F (failure), I (incomplete), W (withdrawn), WC (withdrawn COVID). The lowest passing grade is D. Grade point averages are computed by assigning values to each grade as follows: A = 4 points, B = 3 points, C = 2 points, D = 1 point, and F = 0 points. Grading criteria may be devised by Hill College and the ISD to allow faculty the opportunity to award high school credit only or high school and college credit depending upon student performance. E. Faculty, who are responsible for teaching dual credit/concurrent classes, are responsible for keeping appropriate records, certifying census date rosters, providing interim grade reports, certifying final grade reports at the end of the semester, certifying attendance, and providing other reports and information as may be required by Hill College and/or the School District.

  • COVID-19 Vaccine Passports Pursuant to Texas Health and Safety Code, Section 161.0085(c), Contractor certifies that it does not require its customers to provide any documentation certifying the customer’s COVID-19 vaccination or post-transmission recovery on entry to, to gain access to, or to receive service from the Contractor’s business. Contractor acknowledges that such a vaccine or recovery requirement would make Contractor ineligible for a state-funded contract.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!