Recall Strategy Sample Clauses

Recall Strategy. If any of the circumstances described in Section 8.2 arise, at the Purchaser’s written request, the Supplier shall use Commercially Reasonable Efforts to take, and shall use Commercially Reasonable Efforts to compel [***] to take, all such acts as the Purchaser may reasonably direct in writing. If the Purchaser or any Regulator deems that a Product recall is required, the recall strategy shall be developed in good faith by the Parties and the Supplier shall use Commercially Reasonable Efforts to follow, and shall use Commercially Reasonable Efforts to compel [***] to follow, timing requirements. The reasonable and documented costs of any such action agreed upon by the Parties as a result of the circumstances described in Section 8.2, or of any such recall under this Section 8.3, shall be borne by the Supplier only in the event and to the extent the need for the action is the result of a failure on the part of the Supplier to comply with its obligations under this Agreement, and if not the result of a failure of the Supplier shall be borne by the Purchaser.
AutoNDA by SimpleDocs

Related to Recall Strategy

  • Strategy As an organization without operational services (fuel, maintenance, etc.), and in consideration that the majority of potential issues come from boat maintenance whereby the boats are personal property, the predominant strategy will be the minimization of on-site waste. With this approach, the organization will have minimal potential impact on the environment and reduce regulatory risk. To accomplish this, requirements will be established by policy, periodic communications shall occur, and audits will be utilized to provide feedback for improvement.

  • Product Development (a) Supplier may develop enhancements it intends to incorporate into the BioGlue Surgical Adhesive during the term of this Agreement that have potential application to the Company Product (“Enhancements”). Unless otherwise agreed by the parties, at least once every six months during the Term, representatives of each of BioForm and Supplier shall hold a meeting in accordance with Sections 4.4 and 8.4 (the “Product Development Meeting”) at which Supplier will present Enhancements for BioForm to consider for application to the Company Product. At such Product Development Meeting, BioForm will also present its marketing plans (pursuant to Section 4.4) for the period and any information or feedback that BioForm reasonably believes may lead to Improvements. Within 30 calendar days following each Product Development Meeting, Supplier shall deliver a notice to BioForm (the “Enhancements Notice”) that shall describe the Enhancements that were presented by Supplier at such Product Development Meeting. Within 30 calendar days following receipt of the Enhancements Notice, BioForm may notify Supplier in writing if BioForm elects that any Enhancement described in the Enhancements Notice shall become an Improvement. If BioForm does provide such notice to Supplier during such 30-calendar day period, then BioForm and Supplier shall agree on a timeline for implementation of the Improvement in new Product Specifications for Company Product. If BioForm does not provide such a notice, said Enhancement shall not be implemented into the Company Product. The Enhancements Notice may also describe any potential Enhancements presented by Supplier at the Product Development Meeting, but BioForm shall not be required to take any action under this Section 8.4 with respect to such potential Enhancements until such time as they are presented by Supplier as Enhancements at a future Product Development Meeting. All Enhancements and potential Enhancement information provided by Supplier shall be considered Supplier Confidential Information. (b) From time to time, each party may request the other party to participate in joint projects to develop Improvements. Neither party is obligated to participate in such projects, and in each **** Certain information on this page has been omitted and filed separately with the Securities and Exchange Commission. Confidential treatment has been requested with respect to the omitted portions. instance, each party’s decision whether to participate will be made in such party’s sole discretion. If both parties mutually agree to participate in such a project (a “Program”), the parties will promptly prepare a mutually agreeable written development agreement specifying the development activities to be performed by and the research and development tasks assigned to each party (the “Development Agreement”). All allocation of Intellectual Property rights with respect to any Program will be set forth in writing in the Development Agreement. (c) In the absence of a Development Agreement, (i) BioForm and Supplier shall retain joint ownership of Intellectual Property rights in which there is joint inventorship by BioForm (or its Affiliates) and Supplier, as determined in accordance with United States patent law, with Supplier’s rights in such joint ownership being subject to the license rights of BioForm under this Agreement, (ii) any Intellectual Property rights related to the Company Products, Enhancements, and Improvements that are created solely by employees or consultants of Supplier during the Term shall be considered to be Intellectual Property rights of Supplier, subject to the license rights of BioForm under this Agreement, and (iii) any Intellectual Property rights related to the Company Products and Improvements that are created solely by employees or consultants of BioForm or any of its Affiliates during the Term shall be considered to be Intellectual Property rights of BioForm. BioForm hereby grants to Supplier a perpetual, royalty free, world-wide, nonexclusive license to Supplier under such Blocking Intellectual Property to make, use, and sell such Intellectual Property outside the Field. “Blocking Intellectual Property” for the purposes of Section 8.4(c)(iii) shall mean Intellectual Property necessary for Supplier to make, use, or sell SA Product.

  • Recall List The Board shall maintain a recall list. Copies of the list will be sent to each person on the list and the Association at least once during the fall and once during the spring each year.

  • Commercialization Intrexon shall have the right to develop and Commercialize the Reverted Products itself or with one or more Third Parties, and shall have the right, without obligation to Fibrocell, to take any such actions in connection with such activities as Intrexon (or its designee), at its discretion, deems appropriate.

  • Commercialization Reports Throughout the term of this Agreement and during the Sell-Off Period, and within thirty (30) days of December 31st of each year, Company will deliver to University written reports of Company’s and Sublicensees’ efforts and plans to develop and commercialize the innovations covered by the Licensed Rights and to make and sell Licensed Products. Company will have no obligation to prepare commercialization reports in years where (a) Company delivers to University a written Sales Report with active sales, and (b) Company has fulfilled all Performance Milestones. In relation to each of the Performance Milestones each commercialization report will include sufficient information to demonstrate achievement of those Performance Milestones and will set out timeframes and plans for achieving those Performance Milestones which have not yet been met.

  • Commercialization Plan (a) Not later than three [***] after submission of Regulatory Filings for each Product in each country of the Territory, Licensee will provide to the JCC for review its initial Commercialization Plan for each Product for each country in the Territory. Such initial Commercialization Plan will describe Licensee’s plans for activities to be conducted for such Product for such country. Each Commercialization Plan shall include the details of obligations to be performed by Licensee to achieve the specific activities that are applicable to the stage of [***] Certain information in this document has been omitted and filed separately with the Securities and Exchange Commission. Confidential treatment has been requested with respect to the omitted portions. Commercialization (e.g., pre-launch, launch planning, launch, or post-launch) of the applicable Product during the time period covered by such Commercialization Plan and subsequent time periods. (b) Prior to the First Commercial Sale for such Product in such country, Licensee will provide to the JCC for review an updated Commercialization Plan for such Product for such country. Such updated Commercialization Plan will include, but not be limited to, Licensee’s updated plans for activities to be conducted for such Product for such country prior to launch as well as activities to be conducted in connection with such launch. (c) Promptly after each anniversary of the First Commercial Sale of such Product during the Term, Licensee will provide to the JCC for review updated Commercialization Plans for such Product for such country. Such further updated Commercialization Plan will include, but not be limited to, Licensee’s plans for Commercialization activities for such Product and such country for the twelve (12) month period following the date of delivery of such Commercialization Plan. No Commercialization Plan may be implemented by Licensee if [***]. Each Commercialization Plan shall be consistent with and shall not contradict the terms of this Agreement [***], and in the event of any inconsistency between the Commercialization Plan and this Agreement, the terms of this Agreement shall prevail. Notwithstanding the foregoing, if a [***], Licensee shall [***] and shall promptly [***].

  • Loss Leader; Recycled Products Contractor shall not sell or use any article or product as a “loss leader” as defined in Section 17030 of the Business and Professions Code. If Contractor will sell to the Judicial Council, or use in the performance of this Agreement, goods specified in PCC 12207 (for example, certain paper products, office supplies, mulch, glass products, lubricating oils, plastic products, paint, antifreeze, tires and tire-derived products, and metal products), then with respect to those goods: (i) Contractor shall use recycled products in the performance of this Agreement to the maximum extent doing so is economically feasible, and (ii) upon request, Contractor shall certify in writing under penalty of perjury, the minimum, if not exact, percentage of post consumer material as defined in the PCC 12200, in such goods regardless of whether the goods meet the requirements of PCC 12209.

  • Technology Research Analyst Job# 1810 General Characteristics

  • Research Analyst Independence The Company acknowledges that the Underwriters’ research analysts and research departments are required to be independent from their respective investment banking divisions and are subject to certain regulations and internal policies, and that such Underwriters’ research analysts may hold views and make statements or investment recommendations and/or publish research reports with respect to the Company and/or the offering that differ from the views of their respective investment banking divisions. The Company hereby waives and releases, to the fullest extent permitted by law, any claims that the Company may have against the Underwriters with respect to any conflict of interest that may arise from the fact that the views expressed by their independent research analysts and research departments may be different from or inconsistent with the views or advice communicated to the Company by such Underwriters’ investment banking divisions. The Company acknowledges that each of the Underwriters is a full service securities firm and as such from time to time, subject to applicable securities laws, may effect transactions for its own account or the account of its customers and hold long or short positions in debt or equity securities of the companies that may be the subject of the transactions contemplated by this Agreement.

  • Product Changes Vocera shall have the right, in its absolute discretion, without liability to End User, to update to provide new functionality or otherwise change the design of any Product or to discontinue the manufacture or sale of any Product. Vocera shall notify End User at least 90 days prior to the delivery of any Product which incorporates a change that adversely affects form, fit or function (“Material Change”). Vocera shall also notify End User at least 90 days prior to the discontinuance of manufacture of any Product. Notification will be made as soon as reasonably practical for changes associated with regulatory or health and safety issues.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!